Application of DGT to high pH environments: uptake efficiency of radionuclides of different oxidation states onto Chelex binding gel.

The DGT Chelex binding phase has not been tested for binding efficiency over the extreme high pH range (i.e., 10 to 13). Here, we examined the uptake efficiency of the gel-encapsulated Chelex cation exchange resin binding phase when in direct contact with solutions of radionuclides of different oxidation states over the circumneutral to high pH range (∼7 to 13). Results show that the Chelex binding gel is suitable for Eu(3+) for circumneutral pH, for UO2(2+) up to at least pH 10.7 and for NpO2(+) up to at least pH 11.7. Application may be appropriate at higher pH values but testing of complete solution deployment units will be required. This work provides the framework to use DGT as a tool for the study of high pH radionuclide systems.

The effect of humic acid on uranyl sorption onto bentonite at trace uranium levels.

The effect of humic acid (HA) on U(VI) sorption on bentonite was studied in batch experiments at room temperature and ambient atmosphere at a (237)U(VI) concentration of 8.4 × 10(-11) M and HA concentration of 100 mg L(-1). The distribution of U(VI) between the liquid and solid phases was studied as a function of pH and ionic strength both in the absence and presence of HA. It was shown that the uranyl sorption on bentonite is strongly dependent on pH and the presence of humics, and the effect of the addition order was negligible. In the absence of HA an enhancement in the uptake with increasing pH was observed and a sharp sorption edge was found to take place between pH 3.2 and 4.2. The presence of HA slightly increases uranium(VI) sorption at low pH and curtails it at moderate pH, compared to the absence of HA. In the basic pH range for both the presence and absence of HA the sorption of uranium is significantly reduced, which could be attributed to the formation of soluble uranyl carbonate complexes. The influence of ionic strength on U(VI) and HA uptake by bentonite were investigated in the range of 0.01-1.0 M, and while there was an enhancement in the sorption of humic acid with increasing ionic strength, no significant effect of the ionic strength on the U(VI) sorption was observed in both the absence and presence of HA.

The effect of EDTA on the groundwater transport of thorium through sand.

The effect of the anthropogenic complexing agent EDTA on thorium transport in groundwater has been studied using sand-packed columns and flow rates in the range of 20-100 m y⁻¹. The concentrations injected into the columns were in the range of 0.4-4 mM for Th and 4-40 mM for EDTA, and with EDTA:Th ratios in the range 1:1 to 10:1. The results show that EDTA can significantly increase Th transport, but two very different behaviours are observed at Th concentrations of 0.4 and 4 mM. At the lower concentration, Th breakthrough is retarded with respect to a conservative tracer, with a peak width that is consistent with a single K(d) value, followed by a longer tail, and the behaviour is very sensitive to the flow rate. However at 4 mM Th, the breakthrough peak appears near to that of the tracer, and the width of the peak is consistent with a distribution of K(d) values and/or a larger dispersivity than the tracer. Speciation and transport modelling have been used to interpret the data, and a model was developed that could explain the 0.4 mM behaviour. This suggests that ternary surface complexes are important in these systems, with at least two different species involved, although the complexity of Th speciation in these systems leads to significant uncertainty in the values of the equilibrium and kinetic parameters. For the 4 mM systems, the rapid transport observed could not be explained by a simple chemical model; instead it is likely that EDTA plays an important role in stabilising and transporting thorium colloids and clusters.

Estimation of Model VII humic binding constants for Pd2+, Sn2+, U4+, NpO2(2+), Pu4+ and PuO2(2+).

Using previously established procedures that utilise linear free energy relationships, we estimated binding constants for the Windermere Humic Aqueous Model VII (WHAM/Model VII) for several radionuclide cations (Pd(2+), Sn(2+), U(4+), NpO(2)(2+), Pu(4+) and PuO(2)(2+)). This extends the number of cations that can be calculated with the model above the 40 included in the original Model VII work. When combined with equilibrium constants for inorganic species this allows the calculation of equilibrium distributions of chemical species under a wide range of conditions.

Corrosion and transport of depleted uranium in sand-rich environments.

The firing of depleted uranium (DU) weapons during conflicts and military testing has resulted in the deposition of DU in a variety of sand-rich environments. In this study, DU-amended dune sand microcosm and column experiments were carried out to investigate the corrosion of DU and the transport of corrosion products. Under field-moist conditions, DU corroded to metaschoepite ((UO(2))(8)O(2)(OH)(12).(H(2)O)(10)) at a rate of 0.10+/-0.012 g cm(-2)y(-1). This loosely bound corrosion product detached easily from the coupon and became distributed heterogeneously within the sand. The corrosion of DU caused significant changes in the geochemical environment, with NO(3)(-) and Fe(III) reduction observed. Column experiments showed that transport of metaschoepite was mainly dependent on its dissolution and the subsequent interaction of the resulting dissolved uranyl (UO(2)(2+)) species with sand particles. The modelling results predict that the transport of U released from metaschoepite dissolution is retarded, due to a slowly desorbing surface species (first order desorption rate constant=5.0 (+/-1.0)x10(-8)s(-1)). The concentrations of U eluting from the metaschoepite column were orders of magnitude higher than the World Health Organisation's recommended maximum admissible concentration for U in drinking water of 15 microg L(-1). Therefore, a relatively high level of mobile U contamination would be expected in the immediate proximity of a corroding penetrator in a sand-rich environment.

Humic acid sorption onto a quartz sand surface: A kinetic study and insight into fractionation.

A kinetic study of Aldrich humic acid sorption onto a quartz sand surface has revealed an initial rapid uptake of humic acid molecules followed by a much slower sorption. The humic acid molecular weight and chemical fractionation resulting from adsorption onto the simple quartz sand surface were investigated for the two kinetic steps by coupled asymmetric flow-field flow fractionation-UV/visible absorption spectrophotometry. The molecular weight distribution of residual humic acid in solution after adsorption deviated from the original molecular weight distribution, showing preferential adsorption of certain molecular weight components. This fractionation is different after the two kinetic steps. Humic acid molecules characterised by a molecular weight below 4800 Da and with a weight-average molecular weight (M(w)) of 1450 Da were adsorbed after the fast kinetic step, whereas humic acid molecules in the molecular weight range 1400-9200 Da and of M(w) 3700 Da were adsorbed after the slower uptake. Therefore, the adsorption of low molecular weight humic components takes place initially, and is then followed by the adsorption of higher molecular weight components. Chemical adsorptive fractionation, investigated by studying the 253 nm/203 nm absorbance ratio over time, shows that aromatic components are preferentially adsorbed during the fast kinetic step. The fractionation pattern may be explained by the physicochemical characteristics of the Aldrich humic acid and the underlying sorption processes. The trend for the sorption kinetics of europium onto the quartz sand surface in the presence of humic acid is similar to that of the humic acid itself.

Magnesium hydroxide bulk and colloid-associated 152Eu in an alkaline environment: colloid characterisation and sorption properties in the presence and absence of carbonate.

The distribution of 152Eu between magnesium hydroxide bulk, colloids and solution has been assessed under alkaline conditions, such as those in nuclear fuel storage ponds. The colloidal phase has been characterised by two complementary methods: coupled ultrafiltration-ICP-AES and scanning electron microscopy. The quantity and the size distribution of the colloidal phase is strongly ionic strength-dependent. A decrease of the quantity of colloids, in particular the larger size ranges, has been observed with increasing ionic strength. Small colloids (1 kDa-10 kDa fraction) are predominant at all ionic strengths. The morphology of colloids, observed by field-emission gun scanning electron microscopy, appears to change from hexagonal prismatic (characteristic to the mineral) to spherical (energetically more favourable) as size decreases. The distribution of 152Eu between the solid and liquid/colloidal phases has been investigated at carbonate concentrations ranging from 0 to 10(-2) M by coupled ultrafiltration and gamma-spectrometry. Mg(OH)2 bulk appears to be a very strong sorbent for 152Eu, since complete sorption onto the bulk happens for carbonate concentrations as high as 10(-3) M. Scavenging of 152Eu by Mg(OH)2 colloids is negligible in the presence of Mg(OH)2 bulk. The distribution of 152Eu between liquid and colloidal phases has been investigated in the absence of bulk at various carbonate concentrations. A significant uptake of 152Eu by the colloids in solution has been observed, which decreases with increasing carbonate concentration. 152Eu appears to be mainly associated to the smallest colloids (1 kDa-10 kDa fraction). There is a strong correlation between the sorption properties and the surface area of the colloids.

The role of humic non-exchangeable binding in the promotion of metal ion transport in groundwaters in the environment.

Metal ions form strong complexes with humic substances. When the metal ion is first complexed by humic material, it is bound in an 'exchangeable' mode. The metal ion in this fraction is strongly bound, however, if the metal-humic complex encounters a stronger binding site on a surface, then the metal ion may dissociate from the humic substance and be immobilised. However, over time, exchangeably-bound metal may transfer to a 'non-exchangeable' mode. Transfer into this mode and dissociation from it are slow, regardless of the strength of the competing sink, and so immobilisation may be hindered. A series of coupled chemical transport calculations has been performed to investigate the likely effects of non-exchangeable binding upon the transport of metal ions in the environment. The calculations show that metal in the non-exchangeable mode will have a significantly higher mobility than that in the exchangeable mode. The critical factor is the ratio of the non-exchangeable first-order dissociation rate constant and the residence time in the groundwater column, metal ion mobility increasing with decreasing rate constant. A second series of calculations has investigated the effect of the sorption to surfaces of humic/metal complexes on the transport of the non-exchangeably bound metal. It was found that such sorption may reduce mobility, depending upon the humic fraction to which the metal ion is bound. For the more weakly sorbing humic fractions, under ambient conditions (humic concentration etc.) the non-exchangeable fraction may still transport significantly. However, for the more strongly sorbed fractions, the non-exchangeable fraction has little effect upon mobility. In addition to direct retardation, sorption also increases the residence time of the non-exchangeable fraction, giving more time for dissociation and immobilisation. The non-exchangeable dissociation reaction, and the sorption reaction have been classified in terms of two Damkohler numbers, which can be used to determine the importance of chemical kinetics during transport calculations. These numbers have been used to develop a set of rules that determine when full chemical kinetic calculations are required for a reliable prediction, and when equilibrium may be assumed, or when the reactions are sufficiently slow that they may be ignored completely.

The simultaneous modelling of metal ion and humic substance transport in column experiments.

Pulsed column experiments using Co, fulvic acid and porous sediment packing, along with up/down-flooding experiments using Eu, humic acid and intact sandstone blocks have been performed. The elution of metal and humic and their distribution along the sandstone columns have been measured. A mixed equilibrium and kinetic coupled chemical transport model has been used to simulate the results. In both cases, one exchangeable and one non-exchangeable component have been used to simulate the interaction of metal and humic substance. For the pulsed experiments, a simple equilibrium approach was used to model humic sorption, while a two component, kinetic model was required for the sandstone columns.