Chemical characterization and factor analysis of PM2.5 in two sites of Monterrey, Mexico.

The Monterrey Metropolitan Area (MMA) has shown a high concentration of PM2.5 in its atmosphere since 2003. The contribution of possible sources of primary PM2.5 and its precursors is not known. In this paper we present the results of analyzing the chemical composition of sixty 24-hr samples of PM2.5 to determine possible sources of PM2.5 in the MMA. The samples were collected at the northeast and southeast of the MMA between November 22 and December 12, 2007, using low-volume devices. Teflon and quartz filters were used to collect the samples. The concentrations of 16 airborne trace elements were determined using x-ray fluorescence (XRF). Anions and cations were determined using ion chromatography. Organic carbon (OC) and elemental carbon (EC) were determined by thermal optical analysis. The results show that Ca had the maximum mean concentration of all elements studied, followed by S. Enrichment factors above 50 were calculated for S, Cl, Cu, Zn, Br and Pb. This indicates that these elements may come from anthropogenic sources. Overall, the major average components of PM2.5 were OC (41.7%), SO4(2-) (22.9%), EC (7.4%), crustal material (11.4%), and NO3- (12.6%), which altogether accounted for 96% of the mass. Statistically, we did not find any difference in SO4(2-) concentrations between the two sites. The fraction of secondary organic carbon was between 24% and 34%. The results of the factor analysis performed over 10 metals and OC and EC show that there are three main sources of PM2.5: crustal material and vehicle exhaust; industrial activity; and fuel oil burning. The results show that SO4(2-), OC, and crustal material are important components of PM2.5 in MMA. Further work is necessary to evaluate the proportion of secondary inorganic and organic aerosol in order to have a better understanding of the sources and precursors of aerosols in the MMA.

Performance of a semi-industrial scale gasification process for the destruction of polychlorinated biphenyls.

A semi-industrial scale test was conducted to thermally treat mixtures of spent oil and askarels at a concentration of 50,000 ppm and 100,000 ppm of polychlorinated biphenyls (PCBs) under a reductive atmosphere. In average, the dry-basis composition of the synthesis gas (syngas) obtained from the gasification process was: hydrogen 46%, CO 34%, CO2 18%, and CH4 0.8%. PCBs, polychlorinated dibenzo-p-dioxins, and polychlorinated dibenzofurans (PCDDs/PCDFs) in the gas stream were analyzed by high-resolution gas chromatography (GC)-mass spectrometry. The coplanar PCBs congeners 77, 105, 118, 156/ 157, and 167 were detected in the syngas at concentrations < 2 x 10(-7) mg/m3 (at 298 K, 1 atm, dry basis, 7% O2). The chlorine released in the destruction of the PCBs was transformed to hydrogen chloride and separated from the gas by an alkaline wet scrubber. The concentration of PCBs in the water leaving the scrubber was below the detection limit of 0.002 mg/L, whereas the destruction and removal efficiency was > 99.9999% for both tests conducted. The concentration of PCDDs/PCDFs in the syngas were 8.1 x 10(-6) ng-toxic equivalent (TEQ)/m3 and 7.1 x 10(-6) ng-TEQ/m3 (at 298 K, 1 atm, dry basis, 7% O2) for the tests at 50,000 ppm and 100,000 ppm PCBs, respectively. The only PCDD/F congener detected in the gas was the octachloro-dibenzo-p-dioxin, which has a toxic equivalent factor of 0.001. The results obtained for other pollutants (e.g., metals and particulate matter) meet the maximum allowed emission limits according to Mexican, U.S., and European regulations for the thermal treatment of hazardous waste (excluding CO, which is a major component of the syngas, and total hydrocarbons, which mainly represent the presence of CH4).