Introducing the MARGOT prototype: An ultra-compact and mobile gas detection system for nuclear explosion monitoring.

An ultra-compact and unshielded spectrometer for analysis of atmospheric radioxenons has been developed. This system works at ambient temperature and has a 58 cm3 inner active volume. Atmospheric radioxenons activities are determined with electron/photon coincidence technique using both NaI(Tl) detector and large pixellized Si-PIN detector. The performances of the detection system without shielding in terms of Minimal Detectable Activities are below 65 mBq for a 12 h acquisition, for all radioxenons of interest. An enhanced version of the prototype presented here is already under development: the Mobile Analyzer for Radioactive Gases OuTflows (MARGOT) system.

Low-level laboratory measurement of xenon radionuclides: Electron-photon versus photon measurements.

Radioactive xenon (mainly 131mXe, 133Xe, 133mXe and 135Xe) are tracked as markers of nuclear weapons testing. The CEA has developed the PIPSBox, a measurement cell able to detect electrons emitted by xenon nuclides. Combined with an ultra-low background γ spectrometer, electron detection capacities allow reaching minimum detectable activities (MDA) for a 3-day long measurement of about 0.5mBq for the four xenon radionuclides. Compared to a classical measurement cell, MDAs are improved by a factor of 2-4.

SPALAX NG: A breakthrough in radioxenon field measurement.

Lessons-learned from 10 years of noble gas stations operation and dedicated R&D allowed the design of a New Generation of station. In order to produce 60m3 air equivalent Xenon samples every 8h, it implements: (i) larger sampler unit for Xenon extraction (2 compressors and 8 nitrogen membranes), (ii) new noble gas adsorbent (Ag@ZSM5), (iii) hardened components and (iv) new high resolution coincidence low background spectrometer (HPGe/PIPSBox). Station expected radioxenon sensitivity is lower than 0.3mBq/m3.

Ground surface ultralow background spectrometer: Active shielding improvements and coincidence measurements for the Gamma3 spectrometer.

The ultralow background versatile spectrometer GAMMA3 has been optimized with the following shielding improvements: (i) optimized nitrogen injection flux of 300Lh-1, and (ii) cosmic veto configuration with 9 scintillating plates. These improvements allow a reduction of 39% of the normalized integral background count rate down to 2.7±0.2min-1kgGe-1 (40-2500keV energy range). Minimum Detectable Activities when performing direct γ-ray spectrometry or γ-γ coincidence spectrometry are compared.

Spalax™ new generation: A sensitive and selective noble gas system for nuclear explosion monitoring.

In the context of the verification regime of the Comprehensive nuclear Test ban Treaty (CTBT), CEA is developing a new generation (NG) of SPALAX™ system for atmospheric radioxenon monitoring. These systems are able to extract more than 6cm(3) of pure xenon from air samples each 12h and to measure the four relevant xenon radioactive isotopes using a high resolution detection system operating in electron-photon coincidence mode. This paper presents the performances of the SPALAX™ NG prototype in operation at Bruyères-le-Châtel CEA centre, integrating the most recent CEA developments. It especially focuses on an innovative detection system made up of a gas cell equipped with two face-to-face silicon detectors associated to one or two germanium detectors. Minimum Detectable activity Concentrations (MDCs) of environmental samples were calculated to be approximately 0.1 mBq/m(3) for the isotopes (131m)Xe, (133m)Xe, (133)Xe and 0.4 mBq/m(3) for (135)Xe (single germanium configuration). The detection system might be used to simultaneously measure particulate and noble gas samples from the CTBT International Monitoring System (IMS). That possibility could lead to new capacities for particulate measurements by allowing electron-photon coincidence detection of certain fission products.

An introduction to γ(3) a new versatile ultralow background gamma spectrometer. Background description and analysis.

The γ(3) setup has been designed as a versatile, high sensitivity spectrometry platform. State-of-the art techniques have been implemented to reduce its background to minimum level even though the system is installed at ground level. The shield design and background performance of the setup are presented. The spectrometer is composed of three identical HPGe detectors for high detection efficiency or coincidence measurement and can accommodate several sample geometries. Its shield includes three layers of increasing purity lead, a cosmic veto, an inner borated polyethylene layer, and a radon-free gas injection system. The spectrometer normalized background count rate is 4.4 counts per minutekgGe(-1) (in the 40-2500keV energy range). Its background characteristics, cosmic veto efficiency, and radon-free gas injection performances are discussed.

On the use of (127)Xe standards for the quality control of CTBTO noble gas stations and support laboratories.

(127)Xe has a longer half-life than (131m)Xe, it can be easily purely produced and it is present in the environment at very low level. For these reasons, (127)Xe is supposed to be a convenient quality control radionuclide for remote noble gas stations of the International Monitoring System (IMS) network. As CEA/DAM has recently developed two new photon/electron setups for low-level detection of (131m)Xe, (133m)Xe, (133)Xe and (135)Xe, we took the opportunity to test these setups for the measurement of a (127)Xe standard. The results and a detailed description of these measurements are presented in this paper. They illustrate the complexity of (127)Xe decay, emitting simultaneously several γ, X-rays, conversion electrons and Auger electrons; this results in highly summated coincidence spectra. The measurements performed provide precise electron energy calibration of the setups. The count rate of electrons in coincidence with iodine Kα X-rays was found to be surprisingly low, leading to the study of electron-gated photon spectrum. Finally, a comparison of three photon/electron coincidence spectra obtained with three different setups is given. The use of (127)Xe as a standard for energy calibration of IMS noble gas station is possible, but it appears to be quite complicated for efficiency check of noble gas station equipped with ß/γ detectors.

Improvements of low-level radioxenon detection sensitivity by a state-of-the art coincidence setup.

The ability to quantify isotopic ratios of 135, 133 m, 133 and 131 m radioxenon is essential for the verification of the Comprehensive Nuclear-Test Ban Treaty (CTBT). In order to improve detection limits, CEA has developed a new on-site setup using photon/electron coincidence (Le Petit et al., 2013. J. Radioanal. Nucl. Chem., DOI : 10.1007/s 10697-013-2525-8.). Alternatively, the electron detection cell equipped with large silicon chips (PIPS) can be used with HPGe detector for laboratory analysis purpose. This setup allows the measurement of ß/γ coincidences for the detection of (133)Xe and (135)Xe; and K-shell Conversion Electrons (K-CE)/X-ray coincidences for the detection of (131m)Xe, (133m)Xe and (133)Xe as well. Good energy resolution of 11 keV at 130 keV and low energy threshold of 29 keV for the electron detection were obtained. This provides direct discrimination between K-CE from (133)Xe, (133m)Xe and (131m)Xe. Estimation of Minimum Detectable Activity (MDA) for (131m)Xe is in the order of 1mBq over a 4 day measurement. An analysis of an environmental radioxenon sample using this method is shown.

Production of pure samples of 131mXe and 135Xe.

Pure samples of (131m)Xe, (133m)Xe, (133)Xe and (135)Xe facilitate the calibration and testing of noble gas sampler stations and related laboratory instrumentation. We have earlier reported a Penning trap-based production method for pure (133m)Xe and (133)Xe samples. Here we complete the work by reporting the successful production of pure (131m)Xe and (135)Xe samples using the same technique. In addition, we present data on xenon release from graphite.

Innovative concept for a major breakthrough in atmospheric radioactive xenon detection for nuclear explosion monitoring.

The verification regime of the comprehensive test ban treaty (CTBT) is based on a network of three different waveform technologies together with global monitoring of aerosols and noble gas in order to detect, locate and identify a nuclear weapon explosion down to 1 kt TNT equivalent. In case of a low intensity underground or underwater nuclear explosion, it appears that only radioactive gases, especially the noble gas which are difficult to contain, will allow identification of weak yield nuclear tests. Four radioactive xenon isotopes, 131mXe, 133mXe, 133Xe and 135Xe, are sufficiently produced in fission reactions and exhibit suitable half-lives and radiation emissions to be detected in atmosphere at low level far away from the release site. Four different monitoring CTBT systems, ARIX, ARSA, SAUNA, and SPALAX™ have been developed in order to sample and to measure them with high sensitivity. The latest developed by the French Atomic Energy Commission (CEA) is likely to be drastically improved in detection sensitivity (especially for the metastable isotopes) through a higher sampling rate, when equipped with a new conversion electron (CE)/X-ray coincidence spectrometer. This new spectrometer is based on two combined detectors, both exhibiting very low radioactive background: a well-type NaI(Tl) detector for photon detection surrounding a gas cell equipped with two large passivated implanted planar silicon chips for electron detection. It is characterized by a low electron energy threshold and a much better energy resolution for the CE than those usually measured with the existing CTBT equipments. Furthermore, the compact geometry of the spectrometer provides high efficiency for X-ray and for CE associated to the decay modes of the four relevant radioxenons. The paper focus on the design of this new spectrometer and presents spectroscopic performances of a prototype based on recent results achieved from both radioactive xenon standards and air sample measurements. Major improvements in detection sensitivity have been reached and quantified, especially for metastable radioactive isotopes 131mXe and 133mXe with a gain in minimum detectable activity (about 2 × 10-3 Bq) relative to current CTBT SPALAX™ system (air sampling frequency normalized to 8 h) of about 70 and 30 respectively.