Ratiometric fluorescence sensing and quantification of circulating blood sodium sensors in mice in vivo.

In this work, we introduce ratiometric diffuse in vivo flow cytometry (R-DiFC) for quantitative measurement of circulating fluorescent red blood cell (fRBC) sensors for systemic blood sodium levels. Unlike in our previous work in measuring circulating fRBC sensors, R-DiFC allows simultaneous measurement of two fluorophores encapsulated in the sensor, the ratio of which enables self-calibration of the fluorescence signal with different fRBC depths in biological tissue. We show that the R-DiFC signal varies significantly less than either fluorescence signal alone. This work holds promise for personalized monitoring of systemic sodium for bipolar patients in the future.

A DNA-Based MRI Contrast Agent for Quantitative pH Measurement.

Extracellular pH is important in clinical measurements due to its correlation to cell metabolism and disease progression. In MRI, T1/T2 ratiometric analysis and other methods have been previously applied to quantify pH using conventional pulse sequences. However, for nanoparticle-based approaches, heterogeneity in size and surface functionalization tends toward qualitative rather than quantitative results. To address this limitation, we developed a novel DNA-based MRI contrast agent, pH-DMRCA, which utilizes a highly programmable and reproducible nanostructure. The pH-DMRCA is a dendritic DNA scaffold that is functionalized with a pH-responsive MRI-sensitive construct, Gd(NP-DO3A), at the end of each DNA arm. We first evaluated the r1 and r2 response of our pH-DMRCA over a range of pH values (pH = 5-9) to establish a relaxometric model of pH. These MRI-based assessments of pH were validated in a separate set of samples using a pH electrode (n = 18) and resulted in a good linear correlation (R2 = 0.99, slope = 0.98, intercept = 0). A Bland-Altman analysis of the results also showed reasonable agreement between the calculated pH and measured pH. Moreover, these pH comparisons were consistent across three different pH-DMRCA concentrations, demonstrating concentration-independence of the method. This MRI-based pH quantification methodology was further verified in human blood plasma. Given the versatility of the DNA-based nanostructures, the contrast agent has a potential to be applied to a wide variety of imaging applications where extracellular pH is important including cancer, stroke, cardiovascular disease, and other important diseases.

Real-time particle-by-particle detection of erythrocyte-camouflaged microsensor with extended circulation time in the bloodstream.

Personalized medicine offers great potential benefits for disease management but requires continuous monitoring of drugs and drug targets. For instance, the therapeutic window for lithium therapy of bipolar disorder is very narrow, and more frequent monitoring of sodium levels could avoid toxicity. In this work, we developed and validated a platform for long-term, continuous monitoring of systemic analyte concentrations in vivo. First, we developed sodium microsensors that circulate directly in the bloodstream. We used "red blood cell mimicry" to achieve long sensor circulation times of up to 2 wk, while being stable, reversible, and sensitive to sodium over physiologically relevant concentration ranges. Second, we developed an external optical reader to detect and quantify the fluorescence activity of the sensors directly in circulation without having to draw blood samples and correlate the measurement with a phantom calibration curve to measure in vivo sodium. The reader design is inherently scalable to larger limbs, species, and potentially even humans. In combination, this platform represents a paradigm for in vivo drug monitoring that we anticipate will have many applications in the future.

DNA-Based Photoacoustic Nanosensor for Interferon Gamma Detection.

Tracking protein levels in the body is vital in both research and medicine, where understanding their physiological roles provides insight into their regulation in homeostasis and diseases. In medicine, protein levels are actively sampled since they continuously fluctuate, reflecting the status of biological systems and provide insight into patient health. One such protein is interferon gamma, a clinically relevant protein with immunoregulatory functions that play critical roles against infection. New tools for continuously monitoring protein levels in vivo are invaluable in monitoring real-time conditions of patients to allow better care. Here, we developed a DNA-based nanosensor for the photoacoustic detection of interferon gamma. This work demonstrates how we transformed a simple DNA motif, receptors, and a novel phthalocyanine dye into a proof-of-concept photoacoustic nanosensor for protein detection. Surface plasmon resonance kinetic analysis demonstrated that the nanosensor is responsive and reversible to interferon gamma with an affinity in the nanomolar range, KD1 = 167 nM and KD2 = 316 nM. As a reporter, our design includes a novel phthalocyanine-based photoacoustic dye that stacks in a J-aggregate, causing a 22.5% increase in signal. Upon receptor binding, the DNA structure bends to induce phthalocyanine dye stacking, resulting in a 55% increase in photoacoustic signal in the presence of 10 µM interferon gamma. This proof-of-concept nanosensor is a novel approach to the development of a photoacoustic sensor and may be adapted for other proteins of interest in the future for in vivo tracking.

Hybrid Nanoparticle Platform for Nanoscale Scintillation Proximity Assay.

ß-particle emitting radionuclides, such as 3H, 14C, 32P, 33P, and 35S, are important molecular labels due to their small size and the prevalence of these atoms in biomolecules but are challenging to selectively detect and quantify within aqueous biological samples and systems. Here, we present a core-shell nanoparticle-based scintillation proximity assay platform (nanoSPA) for the separation-free, selective detection of radiolabeled analytes. nanoSPA is prepared by incorporating scintillant fluorophores into polystyrene core particles and encapsulating the scintillant-doped cores within functionalized silica shells. The functionalized surface enables covalent attachment of specific binding moieties such as small molecules, proteins, or DNA that can be used for analyte-specific detection. nanoSPA was demonstrated for detection of 3H-labeled analytes, the most difficult biologically relevant ß-emitter to measure due to the low energy ß-particle emission, using three model assays that represent covalent and non-covalent binding systems that necessitate selectivity over competing 3H-labeled species. In each model, nmol quantities of target were detected directly in aqueous solution without separation from unbound 3H-labeled analyte. The nanoSPA platform facilitated measurement of 3H-labeled analytes directly in bulk aqueous samples without surfactants or other agents used to aid particle dispersal. Selectivity for bound 3H-analytes over unbound 3H analytes was enhanced up to 30-fold when the labeled species was covalently bound to nanoSPA, and 4- and 8-fold for two non-covalent binding assays using nanoSPA. The small size and enhanced selectivity of nanoSPA should enable new applications compared to the commonly used microSPA platform, including the potential for separation-free, analyte-specific cellular or intracellular detection.

A Comparison of Iron Oxide Particles and Silica Particles for Tracking Organ Recellularization.

Reseeding of decellularized organ scaffolds with a patient's own cells has promise for eliminating graft versus host disease. This study investigated whether ultrasound imaging or magnetic resonance imaging (MRI) can track the reseeding of murine liver scaffolds with silica-labeled or iron-labeled liver hepatocytes. Mesoporous silica particles were created using the Stöber method, loaded with Alexa Flour 647 fluorophore, and conjugated with protamine sulfate, glutamine, and glycine. Fluorescent iron oxide particles were obtained from a commercial source. Liver cells from donor mice were loaded with the silica particles or iron oxide particles. Donor livers were decellularized and reperfused with silica-labeled or iron-labeled cells. The reseeded livers were longitudinally analyzed with ultrasound imaging and MRI. Liver biopsies were imaged with confocal microscopy and scanning electron microscopy. Ultrasound imaging had a detection limit of 0.28 mg/mL, while MRI had a lower detection limit of 0.08 mg/mL based on particle weight. The silica-loaded cells proliferated at a slower rate compared to iron-loaded cells. Ultrasound imaging, MRI, and confocal microscopy underestimated cell numbers relative to scanning electron microscopy. Ultrasound imaging had the greatest underestimation due to coarse resolution compared to the other imaging modalities. Despite this underestimation, both ultrasound imaging and MRI successfully tracked the longitudinal recellularization of liver scaffolds.

Polystyrene-Core, Silica-Shell Scintillant Nanoparticles for Low-Energy Radionuclide Quantification in Aqueous Media.

ß-particle emitting radionuclides are useful molecular labels due to their abundance in biomolecules. Detection of ß-emission from 3H, 35S, and 33P, important biological isotopes, is challenging due to the low energies (Emax ≤ 300 keV) and short penetration depths (≤0.6 mm) in aqueous media. The activity of biologically relevant ß-emitters is usually measured in liquid scintillation cocktail (LSC), a mixture of energy-absorbing organic solvents, surfactants, and scintillant fluorophores, which places significant limitations on the ability to acquire time-resolved measurements directly in aqueous biological systems. As an alternative to LSC, we developed polystyrene-core, silica-shell nanoparticle scintillators (referred to as nanoSCINT) for quantification of low-energy ß-particle emitting radionuclides directly in aqueous solutions. The polystyrene acts as an absorber for energy from emitted ß-particles and can be loaded with a range of hydrophobic scintillant fluorophores, leading to photon emission at visible wavelengths. The silica shell serves as a hydrophilic shield for the polystyrene core, enabling dispersion in aqueous media and providing better compatibility with water-soluble analytes. While polymer and inorganic scintillating microparticles are commercially available, their large size and/or high density complicates effective dispersion throughout the sample volume. In this work, nanoSCINT nanoparticles were prepared and characterized. nanoSCINT responds to 3H, 35S, and 33P directly in aqueous solutions, does not exhibit a change in scintillation response between pH 3.0 and 9.5 or with 100 mM NaCl, and can be recovered and reused for activity measurements in bulk aqueous samples, demonstrating the potential for reduced production of LSC waste and reduced total waste volume during radionuclide quantification. The limits of detection for 1 mg/mL nanoSCINT are 130 nCi/mL for 3H, 8 nCi/mL for 35S, and <1 nCi/mL for 33P.

Fate of fluorescent core-shell silica nanoparticles during simulated secondary wastewater treatment.

Increasing use of silica nanoparticles (SiO2 NPs) in consumer products and industrial processes leads to SiO2 NP discharge into wastewater. Thus, there is a need to understand the fate of SiO2 NPs during wastewater treatment. However, the detection of SiO2 NPs in environmental systems is hindered by the elevated background levels of natural silicon. In this work, laboratory-synthesized fluorescent core-shell SiO2 NPs were used to study the fate of these NPs during secondary wastewater treatment. Fluorescent measurements provided an easy and fast method for SiO2 NP tracking. A laboratory-scale activated sludge system consisting of an aeration tank and a settler was fed with synthetic wastewater containing ca. 7.5 mg L(-1) of fluorescent SiO2 NPs for 30 days. SiO2 NPs were effectively removed from the wastewater (>96%) during the first 6 days, however the concentration of SiO2 NPs in the effluent gradually increased afterwards and the NP discharge was as high as 65% of the input after 30 days of NP dosing. The poor removal of the SiO2 NPs was related to the high colloidal stability of the NPs in the wastewater and their limited propensity to biosorption. Although some degree of NP adsorption on the biomass was observed using fluorescence microscopy, the affinity of SiO2 NPs for the activated sludge was not enough for a sustained and effective removal of the SiO2 NPs from the wastewater.

Hybrid phospholipid bilayer coatings for separations of cationic proteins in capillary zone electrophoresis.

Protein separations in CZE suffer from nonspecific adsorption of analytes to the capillary surface. Semipermanent phospholipid bilayers have been used to minimize adsorption, but must be regenerated regularly to ensure reproducibility. We investigated the formation, characterization, and use of hybrid phospholipid bilayers (HPBs) as more stable biosurfactant capillary coatings for CZE protein separations. HPBs are formed by covalently modifying a support with a hydrophobic monolayer onto which a self-assembled lipid monolayer is deposited. Monolayers prepared in capillaries using 3-cyanopropyldimethylchlorosilane (CPDCS) or n-octyldimethylchlorosilane (ODCS) yielded hydrophobic surfaces with lowered surface free energies of 6.0 ± 0.3 or 0.2 ± 0.1 mJ m(-2) , respectively, compared to 17 ± 1 mJ m(-2) for bare silica capillaries. HPBs were formed by subsequently fusing vesicles comprised of 1,2-dilauroyl-sn-glycero-3-phosphocholine or 1,2-dioleoyl-sn-glycero-3-phosphocholine to CPDCS- or ODCS-modified capillaries. The resultant HPB coatings shielded the capillary surface and yielded reduced electroosmotic mobility (1.3-1.9 × 10(-4) cm(2) V(-1) s(-1) ) compared to CPDCS- and ODCS-modified or bare capillaries (3.6 ± 0.2 × 10(-4) cm(2) V(-1) s(-1) , 4.8 ± 0.4 × 10(-4) cm(2) V(-1) s(-1) , and 6.0 ± 0.2 × 10(-4) cm(2) V(-1) s(-1) , respectively), with increased stability compared to phospholipid bilayer coatings. HPB-coated capillaries yielded reproducible protein migration times (RSD ≤ 3.6%, n ≥ 6) with separation efficiencies as high as 200 000 plates/m.