ABSTRACT
To extend the working life of products made of titanium alloy, it is necessary to improve the polishing method to diminish the remaining defects on the workpiece surface. The Halbach array-assisted magnetic abrasive particle polishing method for titanium alloy was employed in this work. The distribution of magnetic field strength was simulated and verified at first to learn the characteristics of the Halbach array used in this work. Then, the polishing performance of the polishing tool was studied by conducting the polishing test, which aimed to display the relationship between shear force and surface roughness with polishing time, and the surface morphology during polishing was also analyzed. Following the establishment of the response surface model, a study on the optimal polishing parameters was conducted to obtain the suitable parameters for maximum shear force and minimum surface roughness. The results show that the maximum shear force 6.11 N and minimum surface roughness Sa 88 nm can be attained, respectively, under the conditions of (1) polishing tool speed of 724.254 r·min-1, working gap of 0.5 mm, and abrasive particle size of 200 µm; and (2) polishing tool speed of 897.87 r·min-1, working gap of 0.52 mm, and abrasive particle size of 160 µm.
ABSTRACT
A new perovskite solar cell (PSC) structure with a functionalized interface between perovskite and a hole transport material has been proposed in this report. The short circuit current density of PSC was notably enhanced with the novel architecture (with an increase of 8.7%), and a power conversion efficiency (PCE) of 16.93% was achieved. With the increased perovskite/hole conductor interface, hysteresis suppression was observed. The advantages of this structure in light-harvesting efficiency, trap density, and carrier separation rate were proved by various characterization and analysis studies. It is noteworthy that a PCE of 14.67% was achieved with poly(3-hexyl-thiophene), which to our knowledge is the highest performing PSC based on this material.
ABSTRACT
Most antisolvents employed in previous research were miscible with perovskite precursor solution. They always led to fast formation of perovskite even if the intermediate stage existed, which was not beneficial to obtain high quality perovskite films and made the formation process less controllable. In this work, a novel ethyl ether/n-hexane mixed antisolvent (MAS) was used to achieve high nucleation density and slow down the formation process of perovskite, producing films with improved orientation of grains and ultrasmooth surfaces. These high quality films exhibited efficient charge transport at the interface of perovskite/hole transport material and perovskite solar cells based on these films showed greatly improved performance with the best power conversion efficiency of 17.08%. This work also proposed a selection principle of MAS and showed that solvent engineering by designing the mixed antisolvent system can lead to the fabrication of high-performance perovskite solar cells.
ABSTRACT
The crystal growth process significantly influences the properties of organic-inorganic halide perovskite films along with the performance of solar cell devices. In this paper, we adopted the microwave irradiation to treat perovskite films through a one-step deposition method for several minutes at a fixed output power. It is found that the specific microwave irradiation process can evaporate the solvent directly and heat perovskite film quickly. In comparison with the conventional thermal annealing process, a microwave irradiation process assisted fast and controllable crystallization of perovskite films with less energy-loss and time-consumption and therefore resulted in the enhancement in the photovoltaic performance of the corresponding solar cells.
