Screening the extractability of some typical environmental pollutants by ionic liquids in liquid-phase microextraction.

The extractability of some typical environmental pollutants in ionic liquids (ILs) was screened by using a simple one-step liquid phase microextraction procedure. It was demonstrated that 1-alkyl-3-methylimidazolium hexafluorophosphate ([CnMIM][PF6], n = 4, 8), two typical ILs, could effectively extract a set of 45 typical environmental pollutants including BTEX (benzene, toluene, ethylbenzene, and xylene), polycyclic aromatic hydrocarbons, phthalates, phenols, aromatic amines, herbicides, organotin, and organomecury. Analytes in 10 mL sample solution held in a 15 mL vial were extracted by a 5 microL drop of ILs suspended on the needle of a high-performance liquid chromatography (HPLC) microsyringe; this was followed by HPLC, atomic absorption spectrometry, or cold-vapor atomic fluorescence spectrometry determination. The enrichment factors determined were in the range of 5-168 for 15 min extraction by [C4MIM][PF6] and 4-178 for 30 min extraction by [C8MIM][PF6], respectively, which indicates that ILs might be considered as potential environmentally benign alternative recyclable solvents for the enrichment of environmental pollutants.

Determination of formaldehyde in shiitake mushroom by ionic liquid-based liquid-phase microextraction coupled with liquid chromatography.

Using ionic liquid as extraction solvent and 2,4-dinitrophenylhydrazine (DNPH) as derivative agent, formaldehyde in shiitake mushroom was determined by liquid-phase microextraction coupled with high-performance liquid chromatography (HPLC). Shiitake mushroom was leached with water and filtrated, then the formaldehyde in filtrate was derivatized with DNPH and extracted simultaneously into a 10mul drop of ionic liquid suspended on the tip of the microsyringe, and finally injected into the HPLC system for determination. The proposed procedure has a detection limit of 5mugl(-1) formaldehyde in extraction solution, thus the mushroom sample filtrate could be diluted with a large ratio to eliminate the influence of sample matrix. The method has a relative standard deviation of 3.5% between days for 53.5mugl(-1) formaldehyde standards. High contents of formaldehyde (119-494mugg(-1) wet weight), which is harmful for human beings, were detected in shiitake mushroom. Therefore, strategies must be taken to prevent the accumulation and strictly control the content of formaldehyde in shiitake mushroom.

Ionic liquid-based liquid-phase microextraction, a new sample enrichment procedure for liquid chromatography.

Room temperature ionic liquids (RTILs) were used as extraction solvent in liquid-phase microextraction (LPME) coupled with liquid chromatography. Using 1-hexyl-3-methylimidazolium hexafluorophosphate ([C6MIM][PF6]) as extraction solvent, some parameters related to LPME of 4-nonylphenol (4-NP) and 4-tert-octylphenol (4-t-OP) were optimized. Although [C6MIM][PF6] can suspend a much larger volume of drop on the needle of the microsyringe than the conventional solvents such as 1-octanol and carbon tetrachloride, the method sensitivity was analyte dependent because of the different partition coefficients and the relatively large viscosity of [C6MIM][PF6]. The proposed procedure has a detection limit and enrichment factor of 0.3 microg l(-1) and 163 for 4-NP, and 0.7 microg l(-1) and 130 for 4-t-OP, respectively. Aqueous samples including tap water, river water, and effluent from sewage treatment plant were analyzed by the proposed method and the recoveries at 10 microg l(-1) spiked level were in the range of 90-113%.

Use of ionic liquids for liquid-phase microextraction of polycyclic aromatic hydrocarbons.

This paper demonstrates, for the first time, that ionic liquids (IL) such as 1-octyl-3-methylimidazolium hexafluorophosphate ([C(8)MIM][PF(6)]) are excellent extraction solvents in liquid-phase microextraction (LPME). The unique properties of nonvolatility and adequate viscosity allow IL to be conveniently adopted as extraction solvents in both direct-immersion and headspace LPME. Model compounds, polycyclic aromatic hydrocarbons (PAHs), are conveniently and rapidly enriched in a 3-microL drop of [C(8)MIM][PF(6)] suspended on the tip of a microsyringe followed by liquid chromatographic determination. Compared to 1-octanol, a larger volume drop of [C(8)MIM][PF(6)] can be formed and survive for a longer extraction time; therefore, a much higher enrichment factor for PAHs can be reached. For low-volatility PAHs, direct-immersion LPME provides higher enrichment factors than that of headspace LPME. However, the enrichment factor obtained by headspace LPME was almost 3-fold of that by direct-immersion LPME in a 30-min extraction of the most volatile PAH, naphthalene. For 30-min direction-immersion LPME of EPA priority PAHs, the enrichment factor, correlation coefficient (R(2)), and reproducibility (RSD, n = 5) were in the range of 42-166, 0.9169-0.9976, and 2.8-12%, respectively. Considering that IL can be easily prepared from relatively inexpensive materials and tuned by combination of different anions and cations for task-specific extraction of analytes from various solvent media, this proposed method should have great potentiality in sample preparation. Furthermore, the nonvolatility of IL makes it potentially useful for headspace LPME of volatile analytes.