ABSTRACT
A Mach-Zehnder interferometer (MZI) based fiber axial micro-displacement sensor was proposed. The MZI was constructed by a bowknot-type taper (BTT) combining with a fiber core-offset between two single mode fibers (SMFs). The axial micro-displacement of the core offset is correlated with the MZI transmission spectrum and varied with the interferometer arm length. For the arm length L of 12, 18, 24 and 30 mm, the proposed sensors showed high sensitivity of -0.362 dB/µm, -0.385 dB/µm, -0.332 dB/µm and -0.235dB/µm, and temperature errors of -0.056 dB/°C, -0.036 dB/°C, -0.044 dB/°C, -0.048 dB/°C, respectively. The theoretical simulations of the energy distributions were also given. The obtained sensitivity of -0.385 dB/µm is about 150 times high than that of the current similar existing axial micro-displacement sensor.
Subject(s)
Fiber Optic Technology/instrumentation , Interferometry/instrumentation , Models, Theoretical , Refractometry/instrumentation , Transducers, Pressure , Transducers , Computer Simulation , Computer-Aided Design , Equipment Design , Equipment Failure Analysis , Motion , Optical Devices , TorqueABSTRACT
A curvature sensor based on a polarization-dependent in-fiber Mach-Zehnder interferometer (MZI) is proposed. The MZI is fabricated by core-offset fusion splicing one section of polarization maintaining fiber (PMF) between two single mode fibers (SMFs). Two independent interference patterns corresponding to the two orthogonal polarization modes for the PMF are obtained. The couple efficiency between the core mode and the cladding mode decreased with the increasing of the bending on the MZI part. The curvature variation on the MZI part can be obtained by detecting the fringe visibility of the interference patterns. A difference arithmetic demodulation method is used to reduce the effects of the light source power fluctuations and temperature cross-sensitivity. Experimental results show that maximal sensitivity of -0.882 dB/m(-1) is obtained under a measurement range of 0.1 to 0.35 m(-1) for the curvature sensor. With the use of difference arithmetic demodulation method, the temperature-curvature cross-sensitivity and light source power fluctuations effects on the proposed sensor are decreased by 94% and 91%, respectively.
