ABSTRACT
Due to the high hardness and brittleness of ceramic materials, conventional cutting methods result in poor quality and machining difficulties. Additive manufacturing has also been tried in various ways, but it has many limitations. This study aims to propose a system to monitor surface defects that occur during the printing process based on high-viscosity composite resin that maximizes ceramic powder content in real time using image processing and convolutional neural network (CNN) algorithms. To do so, defects mainly observed on the surface were classified into four types by form: pore, minor, critical, and error, and the effect of each defect on the printed structure was tested. In order to improve the classification efficiency and accuracy of normal and defective states, preprocessing of images obtained based on cropping, dimensionality reduction, and RGB pixel standardization was performed. After training and testing the preprocessed images based on the DenseNet algorithm, a high classification accuracy of 98% was obtained. Additionally, for pore and minor defects, experiments confirmed that the defect surfaces can be improved through the reblading process. Therefore, this study presented a defect detection system as well as a feedback system for process modifications based on classified defects.
ABSTRACT
Ceramics are high-strength and high-temperature resistant materials that are used in various functional parts. However, due to the high strength and brittleness properties, there are many difficulties in the fabrication of complex shapes. Therefore, there are many studies related to the fabrication of ceramic parts using 3D printing technology optimized for complex shapes. Among them, studies using photo-polymerization (PP) 3D printing technology with excellent dimensional accuracy and surface quality have received the most widespread attention. To secure the physical properties of sintered ceramic, the content and distribution of materials are important. This study suggests a novel 3D printing process based on a high-viscosity composite resin that maximizes the content of zirconia ceramics. For reliable printing, the developed 3D printers that can adjust the process environment were used. To minimize warpage and delamination, the divided micro square pattern images were irradiated in two separate intervals of 1.6 s each while maintaining the internal chamber temperature at 40 °C. This contributed to improved stability and density of the sintered structures. Ultimately, the ceramic parts with a Vickers hardness of 12.2 GPa and a relative density of over 95% were able to be fabricated based on a high-viscosity resin with 25,000 cps.
ABSTRACT
Growth phase-specific autolysis of Bacillus subtilis by inhibitors of membrane permeability, inhibitors of macromolecule biosynthesis, inhibitors of cell wall biosynthesis and detergents were tested and characterized in glucose limited liquid medium. The minimum autolysin induction concentration (MAIC) of test compounds, which was at least 1/20th lower than the conventional autolysis induction concentration, induced autolysis only for cells at the glucose exhaustion point (diauxic point) of the growth phase, while it was not induced for cells at pre- and post-diauxic points. Inhibitors of macromolecule synthesis that are not known for inducing autolysis, such as chloramphenicol, rifampicin, nalidixic acid, and detergents, also induced specific autolysis. Two types of autolysis corresponding to the concentrations of compounds are distinguished: concentration-sensitive and concentration-insensitive types.
