Effects on perceived air quality and symptoms of exposure to microbially produced metabolites and compounds emitted from damp building materials.

UNLABELLED: This work investigated perceived air quality and health effects from exposure to low to high levels of volatile organic compounds (VOCs) emitted from damp building materials and a mixture of molds growing on the materials. A mixture of Wallemia sebi, Fusarium culmorum, Penicillium chrysogenum, Ulocladium botrytis, and Aspergillus versicolor was inoculated on pine wood and particle board. In Study 1, each of 27 participants took part in two exposure conditions, one with air from molds growing on building materials (low levels of emissions from the building materials and the mold mixture) and one with blank air, both conditions during 60 min. In Study 2, each of 24 participants was exposed (10 min) four times in a 2 x 2 design randomly to air from moldy building materials (high levels) and blank, with and without nose-clip. The participants rated air quality and symptoms before, during, and after each exposure. Self-reported tear-film break-up time and attention and processing speed (Study 1) was also measured. Exposure to high VOC levels increased the reports of perceived poor air quality, and in the condition without nose-clip enhanced skin symptoms were also noted. No such outcome was observed when exposing the participants to low VOC levels. PRACTICAL IMPLICATIONS: Emissions from building materials caused by dampness and microbial growth may be involved in indoor air health problems. This study showed that exposure to high levels of VOC emitted from damp building materials and a mixture of mold may cause perceived poor air quality. It also indicated that stimulation of chemical warning systems (the nasal chemosensory part of the trigeminal system and the olfactory system) may enhance skin symptoms.

Volatile organic compounds (VOCs) emitted from materials collected from buildings affected by microorganisms.

In this study mould damaged materials, including carpet, concrete, gypsum board, insulation, plastic, sand and wood, from 20 different buildings with moisture problems were collected. To study emissions from these materials both conventional methods for sampling, such as collection on Tenax TA, were used as well as complementary methods for sampling a wider spectrum of compounds, such as more volatile VOCs, amines and aldehydes. Analysis was carried out using gas chromatography and high-performance liquid chromatography. Mass spectrometry was used for identification of compounds. Alcohols and ketones were almost exclusively emitted from the materials after they had been wet for a week. Acids were also emitted in large quantities from wet gypsum board and plastic. No primary or secondary amines could be identified, but two tertiary amines, trimethylamine and triethylamine, were emitted from sand contaminated by Bacillus. The most common moulds found were Penicillium and Aspergillus. A multivariate method (partial least squares, PLS) was used to investigate the emission patterns from the materials. Materials with bacterial growth had a different VOC profile to those with only mould growth.

Identification using versatile sampling and analytical methods of volatile compounds from Streptomyces albidoflavus grown on four humid building materials and one synthetic medium.

UNLABELLED: The Streptomyces spp. form a common group of bacteria found in the indoor air of water-damaged buildings. They are known for their capability to produce compounds, like geosmin, with low odor thresholds. In this study, two strains of Streptomyces albidoflavus were cultivated on pinewood, gypsum board, particle-board, sand and tryptone glucose extract agar (TGEA). Air samples from the cultures were collected on six different adsorbents and chemosorbents to sample a wide range of compounds such as VOCs, aldehydes, amines and lightweight organic acids. The samples were analyzed with gas chromatography, high-pressure liquid chromatography and ion chromatography. Mass spectrometry was used for identification of the compounds. Metabolites were found and identified in air samples from cultures on all materials except sand. Alcohols and ketones were the dominating compound groups produced by cultures grown on pinewood and gypsum board. Few metabolites were produced on particle-board. The culture growing on TGEA produced mainly sulfur compounds and sesquiterpenes. Ammonia, methylamine, diethylamine, ethylamine and one unidentifiable amine were also found from cultivation on TGEA. The growth medium was of crucial importance to the production of potentially irritating metabolites. PRACTICAL IMPLICATIONS: Microbial growth and the production of volatile metabolites is one possible explanation for building-related health problems. Streptomyces spp. are frequently found in water-damaged buildings. This study shows that Streptomyces spp. are able to produce not only odorous compounds like geosmin, but also potentially irritating compounds. This finding should be of interest in indoor air investigations.