Carbon Dioxide Hydrogenation by Means of Plasmonic Resonance Activation in Silica Aerogel Media.

Surface Plasmon Resonance can be used to activate zinc oxide/copper catalysts in order to perform the carbon dioxide hydrogenation reaction by means of light energy, avoiding high-temperature processes. The synthesis and impregnation methods have been designed to fill glass microreactors with ZnO/Cu nanoparticles supported on transparent silica aerogels to maximize the light absorbed by the catalyst. A LED device surrounding the glass microreactors provided white light to activate the catalyst homogeneously throughout the reactor. Temperature, pressure, amount of catalyst and gases flow were studied as possible variables to enhance the process trying to maximize CO2 conversion rates, achieving the best results working at high pressures. The use of transparent SiO2 Aerogels as supports for photocatalytic gas phase reactions even under high-pressure conditions is demonstrated.

Hydrothermal fractionation of woody biomass: Lignin effect on sugars recovery.

Subcritical water was employed to fractionate woody biomass into carbohydrates and lignin. Nine urban trees species (hardwood and softwood) from Spain were studied. The experiments were carried out in a semi-continuous reactor at 250 °C for 64 min. The hemicellulose and cellulose recovery yields were between 30%wt. and 80%wt. while the lignin content in the solid product ranged between 32%wt. and 92%wt. It was observed that an increment of solubilized lignin disfavored the hydrolysis of hemicelluloses. It was determined that the maximum extraction of hemicellulose was achieved at 20 min of solid reaction time while the extraction of celluloses not exhibited a maximum value. The hydrolysis of hemicellulose and cellulose would be governed by the hydrolysis kinetic and the polymers accessibility. In addition, the extraction of hemicellulose was negatively affected by the lignin content in the raw material while cellulose hydrolysis was not affected by this parameter.

Governing chemistry of cellulose hydrolysis in supercritical water.

At extremely low reaction times (0.02 s), cellulose was hydrolyzed in supercritical water (T=400 °C and P=25 MPa) to obtain a sugar yield higher than 95 wt%, whereas the 5-hydroxymethylfurfural (5-HMF) yield was lower than 0.01 wt %. If the reaction time was increased to 1 s, the main product was glycolaldehyde (60 wt%). Independently of the reaction time, the yield of 5-HMF was always lower than 0.01 wt%. To evaluate the reaction mechanism of biomass hydrolysis in pressurized water, several parameters (temperature, pressure, reaction time, and reaction medium) were studied for different biomasses (cellulose, glucose, fructose, and wheat bran). It was found that the H(+) and OH(-) ion concentration in the reaction medium as a result of water dissociation is the determining factor in the selectivity. The reaction of glucose isomerization to fructose and the further dehydration to 5-HMF are highly dependent on the ion concentration. By an increase in the pOH/pH value, these reactions were minimized to allow control of 5-HMF production. Under these conditions, the retroaldol condensation pathway was enhanced, instead of the isomerization/dehydration pathway.

Energetic approach of biomass hydrolysis in supercritical water.

Cellulose hydrolysis can be performed in supercritical water with a high selectivity of soluble sugars. The process produces high-pressure steam that can be integrated, from an energy point of view, with the whole biomass treating process. This work investigates the integration of biomass hydrolysis reactors with commercial combined heat and power (CHP) schemes, with special attention to reactor outlet streams. The innovation developed in this work allows adequate energy integration possibilities for heating and compression by using high temperature of the flue gases and direct shaft work from the turbine. The integration of biomass hydrolysis with a CHP process allows the selective conversion of biomass into sugars with low heat requirements. Integrating these two processes, the CHP scheme yield is enhanced around 10% by injecting water in the gas turbine. Furthermore, the hydrolysis reactor can be held at 400°C and 23 MPa using only the gas turbine outlet streams.

Experimental study of the supercritical water oxidation of recalcitrant compounds under hydrothermal flames using tubular reactors.

The hydrothermal flame is a new method of combustion that takes place in supercritical water oxidation reactions when the temperature is higher than the autoignition temperature. In these conditions, waste can be completely mineralized in residence times of milliseconds without the formation of by-products typical of conventional combustion. The object of this work is to study the hydrothermal flame formation in aqueous streams with high concentrations of recalcitrant compounds: an industrial waste with a high concentration of acetic acid and various concentrated solutions of ammonia. A tubular reactor with a residence time of 0.7 s was used. Oxygen was used as the oxidant and isopropyl alcohol (IPA) as co-fuel to reach the operation temperature required. The increase of IPA concentrations in the feeds resulted in a better TOC removal. For mixtures containing acetic acid, 99% elimination of TOC was achieved at temperatures higher than 750 °C. In the case of mixtures containing ammonia, TOC removals reached 99% while maximum total nitrogen removals were never higher than 94%, even for reaction temperatures higher than 710 °C. Ignition was observed at concentrations as high as 6% wt NH(3) with 2% wt IPA while at IPA concentrations below 2% wt IPA, the ammonia did not ignite.

Liquid-vapor equilibrium of the systems butylmethylimidazolium nitrate-CO2 and hydroxypropylmethylimidazolium nitrate-CO2 at high pressure: influence of water on the phase behavior.

Ionic liquids (IL) are receiving increasing attention due to their potential as "green" solvents, especially when used in combination with SC-CO2. In this work liquid-vapor equilibria of binary mixtures of CO2 with two imidazolium-based ionic liquids (IL) with a nitrate anion have been experimentally determined: butylmethylimidazolium nitrate (BMImNO3) and hydroxypropylmethylimidazolium nitrate (HOPMImNO3), using a Cailletet apparatus that operates according to the synthetic method. CO2 concentrations from 5 up to 30 mol % were investigated. It was found that CO2 is substantially less soluble in HOPMImNO3 than in BMImNO3. Since these ILs are very hygroscopic, water easily can be a major contaminant, causing changes in the phase behavior. In case these Ils are to be used in practical applications, for instance, together with CO2 as a medium in supercritical enzymatic reactions, it is very important to have quantitative information on how the water content will affect the phase behavior. This work presents the first systematic study on the influence of water on the solubility of carbon dioxide in hygroscopic ILs. It was observed that the presence of water reduces the absolute solubility of CO2. However, at fixed ratios of CO2/IL, the bubble point pressure remains almost unchanged with increasing water content. In order to explain the experimental results, the densities of aqueous mixtures of both ILs were determined experimentally and the excess molar volumes calculated.