ABSTRACT
We have investigated the use of DualEELS in elementally sensitive tilt series tomography in the scanning transmission electron microscope. A procedure is implemented using deconvolution to remove the effects of multiple scattering, followed by normalisation by the zero loss peak intensity. This is performed to produce a signal that is linearly dependent on the projected density of the element in each pixel. This method is compared with one that does not include deconvolution (although normalisation by the zero loss peak intensity is still performed). Additionally, we compare the 3D reconstruction using a new compressed sensing algorithm, DLET, with the well-established SIRT algorithm. VC precipitates, which are extracted from a steel on a carbon replica, are used in this study. It is found that the use of this linear signal results in a very even density throughout the precipitates. However, when deconvolution is omitted, a slight density reduction is observed in the cores of the precipitates (a so-called cupping artefact). Additionally, it is clearly demonstrated that the 3D morphology is much better reproduced using the DLET algorithm, with very little elongation in the missing wedge direction. It is therefore concluded that reliable elementally sensitive tilt tomography using EELS requires the appropriate use of DualEELS together with a suitable reconstruction algorithm, such as the compressed sensing based reconstruction algorithm used here, to make the best use of the limited data volume and signal to noise inherent in core-loss EELS.
ABSTRACT
Electron tomography (ET) is an increasingly important technique for the study of the three-dimensional morphologies of nanostructures. ET involves the acquisition of a set of two-dimensional projection images, followed by the reconstruction into a volumetric image by solving an inverse problem. However, due to limitations in the acquisition process, this inverse problem is ill-posed (i.e., a unique solution may not exist). Furthermore, reconstruction usually suffers from missing wedge artifacts (e.g., star, fan, blurring, and elongation artifacts). Recently, compressed sensing (CS) has been applied to ET and showed promising results for reducing missing wedge artifacts. This uses image sparsity as a priori knowledge to improve the accuracy of reconstruction, and can require fewer projections than other reconstruction techniques. The performance of CS relies heavily on the degree of sparsity in the selected transform domain and this depends essentially on the choice of sparsifying transform. We propose a new image reconstruction algorithm for ET that learns the sparsifying transform adaptively using a dictionary-based approach. We demonstrate quantitatively using simulations from complex phantoms that this new approach reconstructs the morphology with higher fidelity than either analytically based CS reconstruction algorithms or traditional weighted back projection from the same dataset. SCANNING 38:251-276, 2016. © 2015 Wiley Periodicals, Inc.
ABSTRACT
The three-dimensional (3-D) pyramid compressor project at the University of Glasgow has developed a compressor for images obtained from confocal laser scanning microscopy (CLSM) device. The proposed method using a combination of image pyramid coder and vector quantization techniques has good performance at compressing confocal volume image data. An experiment was conducted on several kinds of CLSM data using the presented compressor compared with other well-known volume data compressors, such as MPEG-1. The results showed that the 3-D pyramid compressor gave a higher subjective and objective image quality of reconstructed images at the same compression ratio, and presented more acceptable results when applying image processing filters on reconstructed images.
