Survivability of Salmonella cells in popcorn after microwave oven and conventional cooking.

The survivability of Salmonella cells in popcorn preparation was determined for two distinct cooking methods. The first method used a standard microwave oven. The second method used conventional cooking in a pan. Prior to thermal processing in independent experiments, 12 suspensions in a range between 1x10(3) and 8x10(6) colony-forming units (CFU) per gram of Salmonella cells were inoculated in both raw microwave popcorn and conventional corn kernels. The influence of the initial concentration of Salmonella cells in the raw products and the lethal effects on Salmonella by thermal treatments for cooking were studied. Survival of Salmonella cells was determined in the thermally processed material by pre-enrichment and enrichment in selective medium, in accordance with the legislation for expanded cereals and cereals in flakes. Viable experimental contaminants were recovered from the conventionally cooked popcorn with initial inoculation concentrations of 9x10(4)cells/g or greater. Salmonella cell viability was significantly reduced after microwave oven treatment, with recoveries only from initial concentrations of 2x10(6)cells/g or superior.

Di-(2-ethylhexyl)phthalate in sewage sludge and post-treated sludge: quantitative determination by HRGC-MS and mass spectral characterization.

DEHP was quantified into sewage sludge, thermally dried sludge and compost samples from different areas of Catalonia (North East Spain) using high-resolution gas chromatography (HRGC) coupled to a mass spectrometry (MS). The aim of the work was to determine the evolution of this ubiquitous environmental contaminant along some post-treatment sludge processes, such as composting and thermally drying. DEHP concentration detected in some sludges are above the maximum limit suggested by the EC (100 ppm d.m.) for agricultural use. However, the composting and thermally drying reduce the amount of DEHP in sewage sludge to acceptable level for safe land application. The study was completed with the characterization and long-term observation of DEHP in sewage sludge, composted sludge and thermally dried sludge mixed with two types of soils. In all cases, the percentage of DEHP degraded was higher than 50% after 9 months of incubation.

Application of the new C18 speedisks to the analysis of polychlorinated dibenzo-p-dioxins and dibenzofurans in water and effluent samples.

A recently introduced disk for solid-phase extraction of pollutants from water (C18 Speedisk) has been tested for the analysis of polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF). The complete procedure of analysis has been validated with spiked deionized water. The accuracy, expressed as recovery for the sum of 2,3,7,8-substituted congeners. is 92% and the precision, expressed as the RSD of reproducibility, is 5.8%. The limit of detection (LOD), using 2 l of water, is 4.2 pg/l (0.6 pg ITEQ/l) for the sum of 2,3,7,8-substituted congeners. Actually, the C18 Speedisks have substituted the use of other C18 membrane disks in our laboratory because they allow the fast and efficient analysis of samples with high content of suspended material and reduce the time of elution of free-particulate samples. These disks have been successfully applied to the analysis of water from different sources and with very different physical and chemical characteristics: seawater, rain water, an industrial effluent, a landfill leachate and the inlet and chlorinated and non-chlorinated outlet water from a wastewater treatment plant.

Analysis of dioxin-like compounds in vegetation and soil samples burned in Catalan forest fires. Comparison with the corresponding unburned material.

Only a few data are reported about the formation of polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF) in forest fires. However, the inventories of sources undertaken by several European and American countries consider natural fires as a possible source of PCDD/F and, in some cases, as one of the most important. In our work we have analysed vegetation and soil samples burned in four forest fires which happened in Catalonia in the summer of 1998. The concentration of dioxin-like compounds (PCDD/F, non-ortho polychlorinated bi-phenyls (PCB) and mono-ortho PCB) has been compared to the concentration present in the corresponding unburned material collected in places near the fires but not affected. The results of this preliminary study show very low concentrations in all the samples, both burned and unburned. Although a change in the profile (proportional increase of tetrachlorinated congeners in PCDD/F) is observed in burned samples compared to unburned ones, the absolute values of concentration decrease in most samples. Therefore, natural fires seem not to be an important source of dioxin-like compounds. These results will be confirmed with air emissions measurements in future studies.

Separation of non-ortho polychlorinated biphenyl congeners on pre-packed carbon tubes. Application to analysis in sewage sludge and soil samples.

The analysis of planar (non-ortho) polychlorinated biphenyls (PCB) by HRGC-ECD or HRGC-HRMS requires a fractionation step to avoid the interferences of the bulk of PCB, usually in much higher concentration than the planar ones. In this paper, a new method, based on the fractionation of PCB on SPE commercial tubes pre-packed with Carbopack B, has been developed. After the extract has been applied on the stationary phase, the bulk of PCD are eluted with 15 ml of hexane (fraction I), mono-ortho PCB with 20 ml of hexane/toluene 99:1 (fraction II) and planar PCB with 20 ml of toluene (fraction III) in a station under vacuum. The method has been validated: accuracy (expressed as recovery in %) is >70% and precision (expressed as % RSD) is <20% considering changes of day, analyst and batch of tubes. The method is linear in the range studied. Other advantages are that the method is simple, rapid and it can be easily automated. The application of this separation to the determination of planar PCB in fly-ash extracts from an intercalibration exercise and to sewage sludge, sediment and soil samples has been successful. In addition, this method removes hydrocarbons from the planar PCB fraction and allows its concentration to very small volumes.

Study of evolution of PCDD/F in sewage sludge-amended soils for land restoration purposes.

The evolution of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) in sewage sludge-amended soils used in the restoration of degraded lands, like quarries, has been studied. Two experiments were performed: one in the lab, under controlled conditions, and another in a quarry. Two different doses of sewage sludge were applied in both experiments (with two types of application in the quarry experiment) and the evolution of the amended soils were compared with that of the respective control soils (without addition of sewage sludge). The samples were analyzed with a previously validated method by HRGC HRMS after the extraction and the necessary clean-up steps. The results reveal that polluted sewage sludge increases PCDD/F concentration in soils and that these compounds are persistent in the matrix after long periods of time.

Quantification of sterols, 5alpha- and 5beta-stanols in sewage sludge, manure and soils amended with these both potential fertilizers.

A method for the quantitative determination of sterols, 5alpha- and 5beta-stanols is proposed to characterize the lipid fraction of two potential organic fertilizers, like sewage sludge and manure, as well as soils amended by them. It was possible to determine the kind of fertilizer added to the soil. Further studies were conducted to determine the accumulative effects of steroids in soils treated with manure and different doses of sewage sludge.

Development of an analytical procedure to study linear alkylbenzenesulphonate (LAS) degradation in sewage sludge-amended soils.

A procedure for determining linear alkylbenzenesulphonates (LASs) in sewage sludge and amended soils has been developed. Extraction by sample treatment with 0.5 M potassium hydroxide in methanol and reflux was compared with a previously described extraction procedure in Soxhlet with methanol and solid sodium hydroxide in the sample. Repeatability results were similar with savings in extraction time, solvents and evaporation time. A clean-up method involving a C18 cartridge has been developed. Analytes were quantified by a reversed-phase HPLC method with UV and fluorescence detectors. Recoveries obtained were higher than 84%. The standing procedure was applied to high doses of sewage sludge-amended soils (15%) with increasing quantities of added LASs. Degradation data for a 116-day period are presented.