Influence of desensitizing and anti-erosive toothpastes on dentine permeability: An in vitro study.

OBJECTIVE: This study analyzed the effect of desensitizing and/or anti-erosive toothpastes on dentine permeability. METHODS: One-mm dentin discs were prepared from human molars and exposed to EDTA solution (5 min, 17%). Initial dentine permeability was measured, under constant pressure. Specimens were randomly allocated into 10 groups: four anti-erosive toothpastes (calcium silicate + sodium phosphate, potassium nitrate, stannous chloride + chitosan, oligopeptide-104); four desensitizing toothpastes (arginine + calcium carbonate, calcium sodium phosphosilicate, strontium acetate, stannous fluoride); and two controls (regular fluoridated toothpaste, and human saliva). They were submitted to a 5-day erosion-abrasion cycling model. Erosion consisted of immersion in citric acid (2 min, 0.3%, natural pH ˜ 2.6, 4x/day), followed by 1 h exposure to human saliva. Specimens were brushed for 15 s (2 N, 45 strokes) with the toothpaste slurries (total exposure time of 2 min). After 5 cycles, the final dentine permeability was determined. Dentine permeability change was calculated as a percentage of the initial hydraulic conductance (%Lp). Data were analyzed with one-way ANOVA and Tukey tests (α=0.05). RESULTS: The toothpastes calcium silicate + sodium phosphate and potassium nitrate, showed significant decrease in %Lp, with no difference between them. The regular fluoridated toothpaste also decreased the %Lp, not differing from potassium nitrate. No desensitizing toothpaste showed change in %Lp. Human saliva, oligopeptide-104 and stannous chloride + chitosan presented significant increase in %Lp, without difference between them. CONCLUSION: Calcium silicate + sodium phosphate, potassium nitrate, and the regular fluoridated toothpaste decreased dentine permeability, whereas the desensitizing toothpastes tested did not. CLINICAL RELEVANCE: Toothpastes had distinct impacts on dentine permeability, which may reflect a variable effect on the treatment of dentine hypersensitivity. Within the limitations of a laboratory-based study, toothpastes with an anti-erosive claim could also be effective in reducing the pain in dentine hypersensitivity.

Lasers in esthetic dentistry: soft tissue photobiomodulation, hard tissue decontamination, and ceramics conditioning.

The increasing concern and the search for conservative dental treatments have resulted in the development of several new technologies. Low and high power lasers can be cited as one of these new technologies. Low power lasers act at cellular level leading to pain reduction, modulation of inflammation, and improvement of tissue healing. High power lasers act by increasing temperature and have the potential to promote microbial reduction and ablation of hard and soft tissues. The clinical application of both low and high power lasers requires specific knowledge concerning laser interaction with biological tissues, so that the correct irradiation protocol can be established. The present case report describes the clinical steps of two metal-ceramic crowns development in a 60-year-old patient. Three different laser wavelengths were applied throughout the treatment with different purposes: Nd:YAG laser (1,064 nm) for dentin decontamination, diode (660 nm) for soft tissue biomodulation, and Er:YAG laser (2,940 nm) for inner ceramic surface conditioning. Lasers were successfully applied in the present case report as coadjutant in the treatment. This coadjutant technology can be a potential tool to assist treatment to reach the final success.