Correction to Brown Carbon from Photo-Oxidation of Glyoxal and SO2 in Aqueous Aerosol.

[This corrects the article DOI: 10.1021/acsearthspacechem.3c00035.].

Brown Carbon from Photo-Oxidation of Glyoxal and SO2 in Aqueous Aerosol.

Aqueous-phase dark reactions during the co-oxidation of glyoxal and S(IV) were recently identified as a potential source of brown carbon (BrC). Here, we explore the effects of sunlight and oxidants on aqueous solutions of glyoxal and S(IV), and on aqueous aerosol exposed to glyoxal and SO2. We find that BrC is able to form in sunlit, bulk-phase, sulfite-containing solutions, albeit more slowly than in the dark. In more atmospherically relevant chamber experiments where suspended aqueous aerosol particles are exposed to gas-phase glyoxal and SO2, the formation of detectable amounts of BrC requires an OH radical source and occurs most rapidly after a cloud event. From these observations we infer that this photobrowning is caused by radical-initiated reactions as evaporation concentrates aqueous-phase reactants and aerosol viscosity increases. Positive-mode electrospray ionization mass spectrometric analysis of aerosol-phase products reveals a large number of CxHyOz oligomers that are reduced rather than oxidized (relative to glyoxal), with the degree of reduction increasing in the presence of OH radicals. This again suggests a radical-initiated redox mechanism where photolytically produced aqueous radical species trigger S(IV)-O2 auto-oxidation chain reactions, and glyoxal-S(IV) redox reactions especially if aerosol-phase O2 is depleted. This process may contribute to daytime BrC production and aqueous-phase sulfur oxidation in the atmosphere. The BrC produced, however, is about an order of magnitude less light-absorbing than wood smoke BrC at 365 nm.

Brown Carbon Production by Aqueous-Phase Interactions of Glyoxal and SO2.

Oxalic acid and sulfate salts are major components of aerosol particles. Here, we explore the potential for their respective precursor species, glyoxal and SO2, to form atmospheric brown carbon via aqueous-phase reactions in a series of bulk aqueous and flow chamber aerosol experiments. In bulk aqueous solutions, UV- and visible-light-absorbing products are observed at pH 3-4 and 5-6, respectively, with small but detectable yields of hydroxyquinone and polyketone products formed, especially at pH 6. Hydroxymethanesulfonate (HMS), C2, and C3 sulfonates are major products detected by electrospray ionization mass spectrometry (ESI-MS) at pH 5. Past studies have assumed that the reaction of formaldehyde and sulfite was the only atmospheric source of HMS. In flow chamber experiments involving sulfite aerosol and gas-phase glyoxal with only 1 min residence times, significant aerosol growth is observed. Rapid brown carbon formation is seen with aqueous aerosol particles at >80% relative humidity (RH). Brown carbon formation slows at 50-60% RH and when the aerosol particles are acidified with sulfuric acid but stops entirely only under dry conditions. This chemistry may therefore contribute to brown carbon production in cloud-processed pollution plumes as oxidizing volatile organic compounds (VOCs) interact with SO2 and water.

Nitrogen-Containing, Light-Absorbing Oligomers Produced in Aerosol Particles Exposed to Methylglyoxal, Photolysis, and Cloud Cycling.

Aqueous methylglyoxal chemistry has often been implicated as an important source of oligomers in atmospheric aerosol. Here we report on chemical analysis of brown carbon aerosol particles collected from cloud cycling/photolysis chamber experiments, where gaseous methylglyoxal and methylamine interacted with glycine, ammonium, or methylammonium sulfate seed particles. Eighteen N-containing oligomers were identified in the particulate phase by liquid chromatography/diode array detection/electrospray ionization high-resolution quadrupole time-of-flight mass spectrometry. Chemical formulas were determined and, for 6 major oligomer products, MS2 fragmentation spectra were used to propose tentative structures and mechanisms. Electronic absorption spectra were calculated for six tentative product structures by an ab initio second order algebraic-diagrammatic-construction/density functional theory approach. For five structures, matching calculated and measured absorption spectra suggest that they are dominant light-absorbing species at their chromatographic retention times. Detected oligomers incorporated methylglyoxal and amines, as expected, but also pyruvic acid, hydroxyacetone, and significant quantities of acetaldehyde. The finding that ∼80% (by mass) of detected oligomers contained acetaldehyde, a methylglyoxal photolysis product, suggests that daytime methylglyoxal oligomer formation is dominated by radical addition mechanisms involving CH3CO*. These mechanisms are evidently responsible for enhanced browning observed during photolytic cloud events.