First report of collagenase production by Trichosporon sp. strain isolated from pollen of Amazonian bee (Melipona seminigra seminigra).

Trichosporon yeasts are widely employed to produce lipids, lipases, and aspartic peptidases, but there are no previous studies on collagenase production. This work aimed to select the best collagenase producing Amazonian Trichosporon strains. Moreover, a 23-full factorial design (FFD) and a 22-central composite design combined with Response Surface Methodology were applied to optimize production and find the best conditions for hydrolysis of type I bovine collagen. Most of the studied strains had some collagenolytic activity, but the selected one achieved the highest value (44.02 U) and a biomass concentration of 2.31 g/L. The best collagenase production conditions were 160 rpm of agitation, pH 5.5 and a substrate concentration of 4.0 g/L. The former experimental design showed that substrate concentration was the only statistically significant factor on both biomass concentration and collagenase activity, while the latter showed simultaneous effects of substrate concentration and pH on collagenolytic activity, which peaked at pH 5.5-6.4 and substrate concentration of 3.0-3.4 g/L. An additional 2³-FFD was finally used to optimize the conditions collagen hydrolysis, and pH 6, 25 °C and a substrate concentration of 7.5 (g/L) ensured the highest hydrolysis degree. This study is the first that describes optimized conditions of collagenase production by Trichosporon strains.

Zika Virus Surveillance at the Human-Animal Interface in West-Central Brazil, 2017-2018.

Zika virus (ZIKV) was first discovered in 1947 in Uganda but was not considered a public health threat until 2007 when it found to be the source of epidemic activity in Asia. Epidemic activity spread to Brazil in 2014 and continued to spread throughout the tropical and subtropical regions of the Americas. Despite ZIKV being zoonotic in origin, information about transmission, or even exposure of non-human vertebrates and mosquitoes to ZIKV in the Americas, is lacking. Accordingly, from February 2017 to March 2018, we sought evidence of sylvatic ZIKV transmission by sampling whole blood from approximately 2000 domestic and wild vertebrates of over 100 species in West-Central Brazil within the active human ZIKV transmission area. In addition, we collected over 24,300 mosquitoes of at least 17 genera and 62 species. We screened whole blood samples and mosquito pools for ZIKV RNA using pan-flavivirus primers in a real-time reverse-transcription polymerase chain reaction (RT-PCR) in a SYBR Green platform. Positives were confirmed using ZIKV-specific envelope gene real-time RT-PCR and nucleotide sequencing. Of the 2068 vertebrates tested, none were ZIKV positive. Of the 23,315 non-engorged mosquitoes consolidated into 1503 pools tested, 22 (1.5%) with full data available showed some degree of homology to insect-specific flaviviruses. To identify previous exposure to ZIKV, 1498 plasma samples representing 62 species of domestic and sylvatic vertebrates were tested for ZIKV-neutralizing antibodies by plaque reduction neutralization test (PRNT90). From these, 23 (1.5%) of seven species were seropositive for ZIKV and negative for dengue virus serotype 2, yellow fever virus, and West Nile virus, suggesting potential monotypic reaction for ZIKV. Results presented here suggest no active transmission of ZIKV in non-human vertebrate populations or in alternative vector candidates, but suggest that vertebrates around human populations have indeed been exposed to ZIKV in West-Central Brazil.

Determinants of CO2 emissions in the MERCOSUR: the role of economic growth, and renewable and non-renewable energy.

The main objective of this study was to analyze the impact of energy consumption (divided into renewable and non-renewable sources) and income on CO2 emissions within the environmental Kuznets curve (EKC) model for the Southern Common Market (MERCOSUR). To do so, the annual panel data collected during the 1990-2014 periods was used. The CO2 variable, representing carbon dioxide emissions in metric tons per capita, was used as a proxy for the emission of pollutants. The annual data were obtained from the World Bank (World Development Indicators). The sample consisted of the five MERCOSUR member countries: Argentina, Brazil, Paraguay, Uruguay, and Venezuela, comprising a period of 25 consecutive years. The results showed that energy consumption from renewable sources had a negative impact on CO2 emissions, while the energy consumption from non-renewable sources had a positive impact. The positive impact of economic development on CO2 emissions was also seen. In addition, this study supports the validity of the EKC hypothesis for the MERCOSUR because GDP (real output) leads to environmental degradation while GDP2 reduces the level of gas emissions.

Cardiac myocytes' dynamic contractile behavior differs depending on heart segment.

Cardiac myocytes originating from different parts of the heart exhibit varying morphology and ultrastructure. However, the difference in their dynamic behavior is unclear. We examined the contraction of cardiac myocytes originating from the apex, ventricle, and atrium, and found that their dynamic behavior, such as amplitude and frequency of contraction, differs depending on the heart segment of origin. Using video microscopy and high-precision image correlation, we found that: (1) apex myocytes exhibited the highest contraction rate (∼17 beats/min); (2) ventricular myocytes exhibited the highest contraction amplitude (∼5.2 micron); and (3) as myocyte contraction synchronized, their frequency did not change significantly, but the amplitude of contraction increased in apex and ventricular myocytes. In addition, as myocyte cultures mature they formed contractile filaments, further emphasizing the difference in myocyte dynamics is persistent. These results suggest that the dynamic behavior (in addition to static properties) of myocytes is dependent on their segment of origin.

Adhesion of biocompatible and biodegradable micropatterned surfaces.

We studied the effects of pillar dimensions and stiffness of biocompatible and biodegradable micropatterned surfaces on adhesion on different compliant substrates. The micropatterned adhesives were based on biocompatible polydimethylsiloxane (PDMS) and biodegradable poly(lactic-co-glycolic) acid (PLGA) polymer systems. Micropatterned and non-patterned compliant PDMS did not show significant differences in adhesion on compliant mice ear skin or on gelatin-glycerin model substrates. However, adhesion measurements for micropatterned stiff PLGA on compliant gelatin-glycerin model substrates showed significant enhancement in pull-off strengths compared to non-patterned controls.

Layering of [BMIM]+-based ionic liquids at a charged sapphire interface.

The structure of two model room temperature ionic liquids, [BMIM](+)[PF(6)](-) and [BMIM](+)[BF(4)](-), near the solid/liquid interface with charged Al(2)O(3)(0001) (sapphire) was determined with subnanometer resolution by high energy (72.5 keV) x-ray reflectivity. [BMIM](+)[PF(6)](-) exhibits alternately charged, exponentially decaying, near-surface layering. By contrast, the smaller-anion compound, [BMIM](+)[BF(4)](-), shows only a single layer of enhanced electron density at the interface. The different layering behaviors, and their characteristic length scales, correspond well to the different bulk diffraction patterns, also measured in this study. Complementary measurements of the surface and interface energies showed no significant different between the two RTILs. The combined bulk-interface results support the conclusion that the interfacial ordering is dominated by the same electrostatic ion-ion interactions dominating the bulk correlations, with hydrogen bonding and dispersion interactions playing only a minor role.

Moulding technique demonstrates the contribution of surface geometry to the super-hydrophobic properties of the surface of a water strider.

Water striders (Insecta, Heteroptera, Gerridae) have a complex three-dimensional waterproof hairy cover which renders them super-hydrophobic. This paper experimentally demonstrates for the first time the mechanism of the super-hydrophobicity of the cuticle of water striders. The complex two-level microstructure of the surface, including the smallest microtrichia (200-300 nm wide, 7-9 microm long), was successfully replicated using a two-step moulding technique. The mould surface exhibited super-hydrophobic properties similar to the original insect surface. The average water contact angle (CA) of the mould was 164.7 degrees , whereas the CA of the flat polymer was about 92 degrees . These results show that (i) in water striders, the topography of the surface plays a dominant role in super-hydrophobicity, (ii) very low surface energy bulk material (typically smaller than 0.020 N m(-1)) is not necessary to achieve super-hydrophobicity; and (3) the two-step moulding technique may be used to mimic quite complex biological functional surfaces.