ABSTRACT
Quantum measurements that use the entangled photons' polarization to encode quantum information require calibration and alignment of the measurement bases between spatially separate observers. Because of the changing birefringence in optical fibers arising from temperature fluctuations or external mechanical vibrations, the polarization state at the end of a fiber channel is unpredictable and time-varying. Polarization tracking and stabilization methods originally developed for classical optical communications cannot be applied to polarization-entangled photons, where the separately detected photons are statistically unpolarized, yet quantum mechanically correlated. We report here a fast method for automatic alignment and dynamic tracking of the polarization measurement bases between spatially separated detectors. The system uses the Nelder-Mead simplex method to minimize the observed coincidence rate between non-locally measured entangled photon pairs, without relying on classical wavelength-multiplexed pilot tones or temporally interleaved polarized photons. Alignment and control is demonstrated in a 7.1 km deployed fiber loop as well as in a controlled drifting scenario.
ABSTRACT
In the canonical ramp compression experiment, a smoothly increasing load is applied to the surface of the sample, and the particle velocity history is measured at two or more different distances into the sample, at interfaces where the surface of the sample can be probed. The velocity histories are used to deduce a stress-density relation, usually using iterative Lagrangian analysis to account for the perturbing effect of the impedance mismatch at the interface. In that technique, a stress-density relation is assumed in order to correct for the perturbation and is adjusted until it becomes consistent with the deduced stress-density relation. This process is subject to the usual difficulties of nonlinear optimization, such as the existence of local minima (sensitivity to the initial guess), possible failure to converge, and relatively large computational effort. We show that, by considering the interaction of successive characteristics reaching a free surface, the stress-density relation can be deduced directly by recursion rather than iteration. This calculation is orders of magnitude faster than iterative analysis and does not require an initial guess. Direct recursion may be less suitable for very noisy data, but it was robust when applied to trial data. The stress-density relation deduced was identical to the result from iterative Lagrangian analysis.
