Analytical screening studies on irradiated food packaging.

Foods may be irradiated in their final packaging and this process may affect the composition of the packaging and in turn affect the migration of substances into food. Headspace and liquid injection GC-MS and HPLC with time-of-flight MS have been used to identify and estimate levels of radiolytic products in irradiated finished plastic packaging materials. Fifteen retail packaging materials were studied. Investigations were carried out into the effect of different irradiation types (gamma and electron beam), irradiation doses (1, 3, 7 and 10 kGy) and dose rates (5 kGy s(-1) for electron beam and 0.4 and 1.85 kGy h(-1) for gamma) on the radiolytic products. Any differences seen in comparing the two ionising radiation types were attributed largely to the very different dose rates; for electron beam a 10 kGy dose was delivered in just 2 s whereas using gamma it took 5.4 h. Differences were also seen when comparing the same samples irradiated at different doses. Some substances were not affected by irradiation, others decreased in concentration and others were formed upon increasing doses of irradiation. These results confirm that irradiation-induced changes do occur in substances with the potential to migrate and that the safety of the finished packaging material following irradiation should be assessed.

Methods of analysis for 2-dodecylcyclobutanone and studies to support its role as a unique marker of food irradiation.

Methods of analysis for 2-dodecylcyclobutanone (2-DCB) using gas chromatography with mass spectrometric detection (GC-MS), liquid chromatography with time-of-flight mass spectrometric detection (LC-TOF-MS) and LC with tandem MS (MS/MS) detection have been developed and optimised for maximum sensitivity to allow very low irradiation doses to be detected. The LC-MS/MS method, following derivatisation with 2,4-dinitrophenylhydrazine, was found to be the most sensitive technique and was used to determine the amount of 2-DCB formed from the model compounds palmitic acid, glyceryl tripalmitate and 1,3-dipalmitoyl-2-oleoylglycerol irradiated over a range of doses by two different irradiation sources (gamma and electron beam). The model compounds were also treated with a number of non-irradiation based processing techniques including heating in the presence and absence of oxygen, light, and redox active metal salts, in a conventional oven, microwave oven and pressure cooker. No 2-DCB was detected in any of the processed non-irradiated model compounds, reaffirming the hypothesis that 2-DCB is a unique radiolytic product that can be used as a marker of irradiation in foodstuffs.

Determination of polyadipates migrating from lid gaskets of glass jars. Hydrolysis to adipic acid and measurement by LC-MS/MS.

Polyadipate plasticizers can be present in the polyvinylchloride (PVC) gaskets used to seal the lids of glass jars. As the gaskets can come into direct contact with the foodstuffs inside the jar, the potential exists for polyadipate migration into the food. The procedure and performance characteristics of a test method for the analysis of polyadipates in food simulants (3% aqueous acetic acid and 10% aqueous ethanol) and the volatile test media used in substitute fat tests (isooctane and 95% aqueous ethanol) are described. The PVC gaskets were exposed to the food simulants or their substitutes under standard test conditions. Studies were initially carried out using direct measurement of the polyadipate oligomers by liquid chromatography with time-of-flight mass spectrometric detection (LC-TOF-MS) but this was not practical due to the number of peaks detected. Instead, the migrating polyadipates were hydrolysed to adipic acid and measured by liquid chromatography with tandem mass spectrometric detection (LC-MS/MS). The amount of polyadipate that this measurement of adipic acid represents was then calculated. Method performance was assessed by analysis of gaskets from two types of jar lids by single-laboratory validation. Linearity, sensitivity, repeatability, intermediate reproducibility and recovery were determined to be suitable for checking compliance with the 30 mg/kg specific migration limits for polyesters of 1,2-propane diol and/or 1,3- and/or 1,4-butanediol and/or polypropylene-glycol with adipic acid, which may be end-capped with acetic acid or fatty acids C(12)-C(18) or n-octanol and/or n-decanol. The method was found to be much quicker than previous methods involving extraction, clean-up, hydrolysis, esterification, derivatisation and GC measurement, consequently saving time and money.

A dendritic active site: catalysis of the Henry reaction.

[reaction: see text] Dendrimers containing an encapsulated tertiary amine were prepared by coupling tris(2-aminoethyl)amine with dendritic branches derived from L-lysine. These dendrimers were used as catalysts in the Henry (nitroaldol) reaction between 4-nitrobenzaldehyde and nitroethane, and their catalytic performance was compared with that of triethylamine. Attachment of the dendritic shell alters the rate of reaction and influences the syn:anti ratio of products. It is proposed that the dendritic shell generates an encapsulated catalytically active site, mimicking the behavior of a protein superstructure.

High-performance liquid chromatography applications of optical rotation detection with compensation for scattering and absorbance at the laser wavelength.

Use of instrumentation developed to enable simultaneous monitoring of optical rotation (OR) and transmittance allows OR measurements to be made in the presence of high levels of absorbance, scattering or other effects that change the intensity of the plane-polarised light at the photodiode detector. This extends the application of OR detection to areas where it was previously difficult. Examples of the application of high-performance liquid chromatography (HPLC) with the improved OR detector include (i) the analytical scale separation of fructose and sucrose and (ii) the semi-preparative separation of enantiomers of warfarin and Trögers base. A signal-to-noise improvement of up to 150% is found when comparing signals with and without correction for transmittance changes. The improved OR detector has been used in series with a UV detector and the system shown to be suitable for on-line measurement of peak purity in separations using a chiral column under overload conditions.