The effect of transverse wavefront width on specular neutron reflection.

In the analysis of neutron scattering measurements of condensed matter structure, it normally suffices to treat the incident and scattered neutron beams as if composed of incoherent distributions of plane waves with wavevectors of different magnitudes and directions that are taken to define an instrumental resolution. However, despite the wide-ranging applicability of this conventional treatment, there are cases, such as specular neutron reflectometry, in which the structural length scales of the scattering object require that the wavefunction of an individual neutron in the beam be described by a spatially localized packet - in particular with respect to the transverse extent of its wavefronts (i.e. normal to the packet's mean direction of propagation). It is shown in the present work that neutron diffraction patterns observed for periodic transmission phase gratings, as well as specular reflection measurements from patterned thin films with repeat units of the order of micrometres, can be accurately described by associating an individual neutron with a wave packet and treating a beam as a collection of independent packets. In these cases, accurate analysis requires that the transverse spatial extent of a neutron packet wavefront be accounted for in addition to the angular divergence of the beam that is characterized by a distribution of packet mean wavevector directions. It is shown how a measure of the effective transverse spatial extent of the neutron packet - over which its wavefronts are of sufficient uniformity to produce coherent scattering - can be determined by employing reference diffraction gratings and patterned thin films of known structure and composition.

Pore collapse and regrowth in silicon electrodes for rechargeable batteries.

Structure and composition of an 11 nm thick amorphous silicon (a-Si) thin film anode, capped with 4 nm of alumina are measured, in operando, by neutron reflectivity (NR) and electrochemical impedance spectroscopy in a lithium half-cell. NR data are analyzed to quantify the a-Si thickness and composition at various states of charge over six cycles. The a-Si anode expands and contracts upon lithiation and delithiation, respectively, while maintaining its integrity and low interfacial roughness (≤1.6 nm) throughout the cycling. The apparently non-linear expansion of the a-Si layer volume versus lithium content agrees with previous thin-film a-Si anode studies. However, a proposed pore collapse and regrowth (PCRG) mechanism establishes that the solid domains in the porous LixSi film expand linearly with Li content at 8.48 cm(3) mol(-1) Li, similar to crystalline Si. In the PCRG model, porosity is first consumed by expansion of solid domains upon lithiation, after which the film as a whole expands. Porosity is reestablished at 5-28% upon delithiation. Data show that the alumina protective layer on the a-Si film functions as an effective artificial solid electrolyte interphase (SEI), maintaining its structural integrity, low interfacial roughness, and relatively small transport resistance. No additional spontaneously-formed SEI is observed in this study.

Communication: nanoscale ion fluctuations in Nafion polymer electrolyte.

Ion conduction mechanisms and the nanostructure of ion conduction networks remain poorly understood in polymer electrolytes which are used as proton-exchange-membranes (PEM) in fuel cell applications. Here we study nanoscale surface-potential fluctuations produced by Brownian ion dynamics in thin films of low-hydration Nafion™, the prototype PEM. Images and power spectra of the fluctuations are used to derive the local conductivity-relaxation spectrum, in order to compare with bulk behavior and hopping-conductivity models. Conductivity relaxation-times ranged from hours to milliseconds, depending on hydration and temperature, demonstrating that the observed fluctuations are produced by water-facilitated hydrogen-ion hopping within the ion-channel network. Due to the small number of ions probed, non-Gaussian statistics of the fluctuations can be used to constrain ion conduction parameters and mechanisms.

Structural characterization of the voltage-sensor domain and voltage-gated K+-channel proteins vectorially oriented within a single bilayer membrane at the solid/vapor and solid/liquid interfaces via neutron interferometry.

The voltage-sensor domain (VSD) is a modular four-helix bundle component that confers voltage sensitivity to voltage-gated cation channels in biological membranes. Despite extensive biophysical studies and the recent availability of X-ray crystal structures for a few voltage-gated potassium (Kv) channels and a voltage-gate sodium (Nav) channel, a complete understanding of the cooperative mechanism of electromechanical coupling, interconverting the closed-to-open states (i.e., nonconducting to cation conducting) remains undetermined. Moreover, the function of these domains is highly dependent on the physical-chemical properties of the surrounding lipid membrane environment. The basis for this work was provided by a recent structural study of the VSD from a prokaryotic Kv-channel vectorially oriented within a single phospholipid (1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC)) membrane investigated by X-ray interferometry at the solid/moist He (or solid/vapor) and solid/liquid interfaces, thus achieving partial to full hydration, respectively (Gupta et al. Phys. Rev. E2011, 84, 031911-1-15). Here, we utilize neutron interferometry to characterize this system in substantially greater structural detail at the submolecular level, due to its inherent advantages arising from solvent contrast variation coupled with the deuteration of selected submolecular membrane components, especially important for the membrane at the solid/liquid interface. We demonstrate the unique vectorial orientation of the VSD and the retention of its molecular conformation manifest in the asymmetric profile structure of the protein within the profile structure of this single bilayer membrane system. We definitively characterize the asymmetric phospholipid bilayer solvating the lateral surfaces of the VSD protein within the membrane. The profile structures of both the VSD protein and phospholipid bilayer depend upon the hydration state of the membrane. We also determine the distribution of water and exchangeable hydrogen throughout the profile structure of both the VSD itself and the VSD:POPC membrane. These two experimentally determined water and exchangeable hydrogen distribution profiles are in good agreement with molecular dynamics simulations of the VSD protein vectorially oriented within a fully hydrated POPC bilayer membrane, supporting the existence of the VSD's water pore. This approach was extended to the full-length Kv-channel (KvAP) at a solid/liquid interface, providing the separate profile structures of the KvAP protein and the POPC bilayer within the reconstituted KvAP:POPC membrane.

A molecular beam epitaxy facility for in situ neutron scattering.

A molecular beam epitaxy (MBE) facility has been built to enable in situ neutron scattering measurements during growth of epitaxial layers. While retaining the full capabilities of a research MBE chamber, this facility has been optimized for polarized neutron reflectometry measurements. Optimization includes a compact lightweight portable design, a neutron window, controllable magnetic field, deposition across a large 76 mm diameter sample with exceptional flux uniformity, and sample temperatures continuously controllable from 38 to 1375 K. A load lock chamber allows for sample insertion, storage of up to 4 samples, and docking with other facilities. The design and performance of this chamber are described here.

First-principles determination of hybrid bilayer membrane structure by phase-sensitive neutron reflectometry.

The application of a new, phase-sensitive neutron reflectometry method to reveal the compositional depth profiles of biomimetic membranes is reported. Determination of the complex reflection amplitude allows the related scattering length density (SLD) profile to be obtained by a first-principles inversion without the need for fitting or adjustable parameters. The SLD profile so obtained is unique for most membranes and can therefore be directly compared with the SLD profile corresponding to the chemical compositional profile of the film, as predicted, for example, by a molecular dynamics simulation. Knowledge of the real part of the reflection amplitude, in addition to enabling the inversion, makes it possible to assign a spatial resolution to the profile for a given range of wavevector transfer over which the reflectivity data are collected. Furthermore, the imaginary part of the reflection amplitude can be used as a sensitive diagnostic tool for recognizing the existence of certain in-plane inhomogeneities in the sample. Measurements demonstrating the practical realization of this phase-sensitive technique were performed on a hybrid bilayer membrane (self-assembled monolayer of thiahexa (ethylene oxide) alkane on gold and a phospholipid layer) in intimate contact with an aqueous reservoir. Analysis of the experimental results shows that accurate compositional depth profiles can now be obtained with a spatial resolution in the subnanometer range, primarily limited by the background originating from the reservoir and the roughness of the film's supporting substrate.

Hybrid bilayer membranes in air and water: infrared spectroscopy and neutron reflectivity studies.

In this report we describe the fabrication and characterization of a phospholipid/alkanethiol hybrid bilayer membrane in air. The bilayer is formed by the interaction of phospholipid with the hydrophobic surface of a self-assembled alkanethiol monolayer on gold. We have characterized the resulting hybrid bilayer membrane in air using atomic force microscopy, spectroscopic ellipsometry, and reflection-absorption infrared spectroscopy. These analyses indicate that the phospholipid added is one monolayer thick, is continuous, and exhibits molecular order which is similar to that observed for phospholipid/phospholipid model membranes. The hybrid bilayer prepared in air has also been re-introduced to water and characterized using neutron reflectivity and impedance spectroscopy. Impedance data indicate that when moved from air to water, hybrid bilayers exhibit a dielectric constant and thickness that is essentially equivalent to hybrid bilayers prepared in situ by adding phospholipid vesicles to alkanethiol monolayers in water. Neutron scattering from these samples was collected out to a wave vector transfer of 0.25 A(-1), and provided a sensitivity to changes in total layer thickness on the order of 1-2 A. The data confirm that the acyl chain region of the phospholipid layer is consistent with that observed for phospholipid-phospholipid bilayers, but suggest greater hydration of the phospholipid headgroups of HBMs than has been reported in studies of lipid multilayers.