Cobalt Impregnation on Titania Photocatalysts Enhances Vis Phenol Photodegradation.

One of the main challenges of photocatalysis is to find a stable and effective photocatalyst, that is active and effective under sunlight. Here, we discuss the photocatalytic degradation of phenol as a model pollutant in aqueous solution using NUV-Vis (>366 nm) and UV (254 nm) in the presence of TiO2-P25 impregnated with different concentrations of Co (0.1%, 0.3%, 0.5%, and 1%). The modification of the surface of the photocatalyst was performed by wet impregnation, and the obtained solids were characterized using X-ray diffraction, XPS, SEM, EDS, TEM, N2 physisorption, Raman and UV-Vis DRS, which revealed the structural and morphological stability of the modified material. BET isotherms are type IV, with slit-shaped pores formed by nonrigid aggregate particles and no pore networks and a small H3 loop near the maximum relative pressure. The doped samples show increased crystallite sizes and a lower band gap, extending visible light harvesting. All prepared catalysts showed band gaps in the interval 2.3-2.5 eV. The photocatalytic degradation of aqueous phenol over TiO2-P25 and Co(X%)/TiO2 was monitored using UV-Vis spectrophotometry: Co(0.1%)/TiO2 being the most effective with NUV-Vis irradiation. TOC analysis showed ca. 96% TOC removal with NUV-Vis radiation, while only 23% removal under UV radiation.

Effect of heat treatment on the photocatalytic activity of α-Fe2O3 nanoparticles: towards diclofenac elimination.

α-Fe2O3 nanoparticles were synthesized via a straightforward method. XRD, FTIR, SEM, ESR, and DRS techniques investigated the influence of various calcination temperatures on the crystal structure, optical, and photocatalytic properties of the samples. The obtained results demonstrated that the average crystallite size increased with the increase in the calcination temperature. Measured and computed optical properties were in accordance and the bandgap energy decreased with the increase in the calcination temperature. The highest photocatalytic degradation efficiency for diclofenac (DCF) was obtained with the sample calcinated at 300 °C (96%). The photocatalytic process occurs because of the presence of OH• radicals. The addition of H2O2 led to the inhibition of OH• radicals that H2O2 scavenged.

New insights into the efficient removal of emerging contaminants by biochars and hydrochars derived from olive oil wastes.

The removal of emerging contaminants (ECs) for water source reclamation, minimizing energy and chemical use, is an environmental concern worldwide. In this study, we used the technologically cleaner pyrolysis and hydrothermal carbonization (HTC) processes to convert olive oil production wastes into chars in order to simultaneously remove triclosan (TCS), ibuprofen (IBP) and diclofenac (DCF) from water. The chars prepared from olive stone (S), olive tree pruning (P) and pitted and reprocessed wet olive mill waste (H), as well as commercial biochars and a commercial active carbon (CAC), were characterized using different techniques and assayed as adsorbents. Pyrolysis temperatures had only a slight effect on the adsorption capacity of chars. The pseudo second-order reaction kinetic and the Freundlich equation provided the best fit for experimental data. The pH values of char suspensions were negatively correlated with their maximum adsorption capacities. The hydrochars synthetized at the lowest temperatures (≤ 240 °C), which had an acidic pH and were rich in oxygenated functional groups, recorded the highest adsorption rates (64% for DCF, 43% for IBP) and especially for TCS, with a rate of 98%, despite of a low surface area of 7.5 m2/ g. This study demonstrates for the first time that unmodified hydrochars from pitted and reprocessed wet olive mill waste are inexpensive, sustainable and environmentally friendly adsorbents which can be used to remove ECs and other similar compounds in water treatments.

Enhanced Photocatalytic Degradation of the Imidazolinone Herbicide Imazapyr upon UV/Vis Irradiation in the Presence of CaxMnOy-TiO2 Hetero-Nanostructures: Degradation Pathways and Reaction Intermediates.

The determination of reaction pathways and identification of products of pollutants degradation is central to photocatalytic environmental remediation. This work focuses on the photocatalytic degradation of the herbicide Imazapyr (2-(4-methyl-5-oxo-4-propan-2-yl-1H-imidazol-2-yl) pyridine-3-carboxylic acid) under UV-Vis and visible-only irradiation of aqueous suspensions of CaxMnOy-TiO2, and on the identification of the corresponding degradation pathways and reaction intermediates. CaxMnOy-TiO2 was formed by mixing CaxMnOy and TiO2 by mechanical grinding followed by annealing at 500 °C. A complete structural characterization of CaxMnOy-TiO2 was carried out. The photocatalytic activity of the hetero-nanostructures was determined using phenol and Imazapyr herbicide as model pollutants in a stirred tank reactor under UV-Vis and visible-only irradiation. Using equivalent loadings, CaxMnOy-TiO2 showed a higher rate (10.6 µM·h-1) as compared to unmodified TiO2 (7.4 µM·h-1) for Imazapyr degradation under UV-Vis irradiation. The mineralization rate was 4.07 µM·h-1 for CaxMnOy-TiO2 and 1.21 µM·h-1 for TiO2. In the CaxMnOy-TiO2 system, the concentration of intermediate products reached a maximum at 180 min of irradiation that then decreased to a half in 120 min. For unmodified TiO2, the intermediates continuously increased with irradiation time with no decrease observed in their concentration. The enhanced efficiency of the CaxMnOy-TiO2 for the complete degradation of the Imazapyr and intermediates is attributed to an increased adsorption of polar species on the surface of CaxMnOy. Based on LC-MS, photocatalytic degradation pathways for Imazapyr under UV-Vis irradiation have been proposed. Some photocatalytic degradation was obtained under visible-only irradiation for CaxMnOy-TiO2. Hydroxyl radicals were found to be main reactive oxygen species responsible for the photocatalytic degradation through radical scavenger investigations.

Factors Influencing Imazapyr Herbicide Removal from Wastewater Using Photocatalytic Ozonation.

This study investigates the degradation of imazapyr herbicide from wastewater by photocatalytic ozonation using TiO2 as a semiconductor. Effects of operational parameters on imazapyr removal efficiency including TiO2 dosing, initial herbicide concentration and pH were also studied. Obtained results showed that more than 90% of removal efficiency representing the disappearance of imazapyr was maintained until 7 µM in the presence of 200 mgL-1of UV100-TiO2. Otherwise, the degradation of imazapyr followed the first-order kinetics with a photocatalytic rate constant of 0.247 min-1, and complete degradation was achieved within 20 min using photocatalytic ozonation for 5 µM of Imazapyr at pH 7.

Chromatography and high-resolution mass spectrometry for the characterization of the degradation products of the photodegradation of amidosulfuron: an analytical approach.

Simulated sunlight irradiation causing degradation of amidosulfuron, a pyrimidinylsulfonylurea herbicide, has been investigated in aqueous solution. The main degradation products were followed up by ultrahigh-pressure liquid chromatography with a UV detector (UHPLC-UV) and identified by combining ultrahigh-pressure liquid chromatography-mass spectrometry (UHPLC-MS) and Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR-MS). On the basis of the retrosynthetic analysis, the most identified degradation products were mainly due to the losses of methylsulfamic acid (CH5NO3S), sulfocarbamic acid (CH3NO5S), carbamic acid (CH3NO2), methyl(methylsulfonyl)sulfamic acid (C2H7NO5S2), N-methylmethanesulfonamide (C2H7NO2S), and sulfonic acid (H2SO4) molecules. Accordingly, O and S-demethylation as well as hydroxylation processes were also observed. Sum formulas of the main degradation products were assigned, and a mechanical pathway is proposed.

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100.

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changesand whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.

Hydrolysis of mefenpyrdiethyl: an analytical and DFT investigation.

The hydrolysis of the herbicide safener mefenpyrdiethyl (1-(2, 4-dichlorophenyl)-4, 5-dihydro-5-methyl-1H-pyrazole-3,5-dicarboxylic acid diethyl ester) was investigated in aqueous solutions in the pH range from 2 to 9 and the temperature range from 298 to 323 K. The kinetics of hydrolysis were pseudo first order and were found to be strongly pH and temperature dependent. While near-constant in acidic medium, the hydrolysis rates strongly increased in alkaline pH, and total hydrolysis was observed at pH 11. Two main hydrolysis products, mefenpyrethyl (monoester) and mefenpyr (dicarboxylic acid) were isolated by ultrahigh-pressure liquid chromatography (UHPLC) and characterized using high-resolution Fourier transform ion cyclotron resonance mass spectroscopy (ICR-FT/MS) as well as (1)H, (13)C and 2D NMR analyses. Additionally, a density functional theory (DFT) investigation explained the stability of the pesticide at pH 7 and the high reactivity of the pesticide in alkaline medium. The key nucleophilic reaction partner is hydroxyl ions instead of neutral water molecules. Furthermore, the calculated activation barrier for hydrolysis in alkaline medium is in agreement with the extrapolated and experimentally determined activation barrier at pH 14.