Prevalence, severity and explanatory factors of tooth wear in Arab populations.

OBJECTIVES: The aim of this study was to assess the prevalence and severity of tooth wear and related risk indicators in six Arab countries. METHODS: This multicenter, multinational cross-sectional study was conducted among 2924 participants between the ages of 18-35 years old from six Arab countries. Calibrated dentists assessed tooth wear using the Basic Erosive Wear Examination Index (BEWE). Participants were also asked to complete a questionnaire that assessed their dietary and oral health habits. Each participant was identified by the sextant with the highest BEWE score in the upper and lower jaws. RESULTS: Odds ratios were estimated for correlates of tooth wear anterior and posterior regions. Oman had the highest prevalence of BEWE score 3 (N = 255 (60.2%)). Overall, the highest BEWE score 3 was observed on the incisal edge of the upper anterior teeth (N = 602 (20.6%)) and in the lower left posterior region (sextant 6) on the occlusal surface (N = 466 (15.9%)). Correlates of severe tooth wear in both regions were eating or drinking more than six times per day, age and education. Drinking soft drinks "once a day" was significantly associated with severe tooth wear in the posterior region (OR: 1.3, 95% CI:1.05, 1.6). Brushing teeth more than twice a day was inversely associated with tooth wear in the anterior region (OR:0.75, 95% CI: 0.57,0.97). CONCLUSION: The prevalence of tooth wear in Arab populations is relatively high, specific preventive and therapeutic measures should be developed to target people at higher risk of this condition. CLINICAL SIGNIFICANCE: Tooth wear is now regarded as a significant oral health problems, dentists should advise their patients about dietary and oral health habits that can lead to severe tooth wear.

Effect of C-factor on microtensile bond strengths of low-shrinkage composites.

UNLABELLED: This study evaluated the microtensile bond strength (µ-TBS) of low-shrinkage composites with their corresponding adhesive systems, Filtek Silorane/Silorane adhesive (SIL, 3M ESPE AG, Seefeld, Germany) and Aelite LS/One-Step Plus (AL, BISCO Inc, Schaumburg, IL, USA) in cavities with different C-factors. Filtek Z250/Adper Single Bond Plus (Z, 3M ESPE, St Paul, MN, USA) was used as a control. METHOD: Standardized Class I cavities were prepared in extracted human molars after removing occlusal enamel. Cavities were assigned into six different C-factors by applying nail polish to four walls, three walls, two walls adjacent to each other, two walls opposite to each other, one wall, or no walls. Resin composites with their corresponding adhesive systems were applied according to manufacturer instructions. Specimens were sectioned to obtain four rectangular beams from the center of the restorations and µ-TBS was measured. Data were analyzed by Weibull survival analysis. Shrinkage stresses of the resin composites were determined after 30 minutes from the start of light-curing using a tensometer testing machine. Flexure elastic modulus was determined using standard procedures, in accordance with ISO 4049. Data for shrinkage stress and elastic modulus were analyzed by one-way analysis of variance followed by a Tukey multiple-comparisons test (p<0.05). RESULTS: µ-TBS of both SIL and AL were not affected by different C-factors; however, the bond strength of Z decreased significantly when the C-factor increased. Shrinkage stress results were 0.94 ± 0.1, 1.79 ± 0.18, and 2.14 ± 0.23 MPa for SIL, AL, and Z, respectively. The flexural modulus of both the SIL and the AL was significantly lower than that of Z. CONCLUSIONS: Increasing C-factor did not negatively affect the bond strength of low-shrinkage composites.