Effect of thermal cycling on temperature changes and bond strength in different test specimens.

Objectives: To investigate temperature changes in various test specimens during thermal cycling and to evaluate difference in micro-tensile repair bond strength in specimens cut from the inner or the outer area of composite blocks after thermal cycling. Materials and methods: Four rectangular composite blocks of various sizes were fabricated, and thermocouples placed in the centre of the specimens or halfway from the surface to the centre. Composite cylinders were made on ground flat extracted molars, as intended for micro-tensile and shear bond testing, with a thermocouple placed at the centre of the cylinder radius between composite and dentin. The specimens were thermal cycled between 5 °C and 55 °C with 20-60 s dwell times. The highest and lowest temperatures in the test specimens were recorded. Composite blocks were fabricated and stored in water for a week and then repaired with the same composite. After thermal cycling (5000×, 5 °C and 55 °C with a 20 s dwell time), test specimens were cut for micro-tensile testing. Results: None of the specimens tested reached the cold and warm water bath temperatures after a 20 s dwell time. In the smallest composite block, the centre core temperature reached 5 °C and 55 °C after 40 s dwell time, but lacked 1 °C after 60 s in the largest block. None of the specimens involving teeth reached water temperatures. The micro-tensile repair strength was significantly different between the outer and the central cut rods (p < .05). Conclusions: The most commonly used dwell times for thermal cycling are insufficient to create a homogeneous temperature change.

Effect of curing and silanizing on composite repair bond strength using an improved micro-tensile test method.

Objectives: To evaluate the micro-tensile repair bond strength between aged and new composite, using silane and adhesives that were cured or left uncured when new composite was placed. Methods: Eighty Filtek Supreme XLT composite blocks and four control blocks were stored in water for two weeks and thermo-cycled. Sandpaper ground, etched and rinsed specimens were divided into two experimental groups: A, no further treatment and B, the surface was coated with bis-silane. Each group was divided into subgroups: (1) Adper Scotchbond Multi-Purpose, (2) Adper Scotchbond Multi-Purpose adhesive, (3) Adper Scotchbond Universal, (4) Clearfil SE Bond and (5) One Step Plus. For each adhesive group, the adhesive was (a) cured according to manufacturer's instructions or (b) not cured before repair. The substrate blocks were repaired with Filtek Supreme XLT. After aging, they were serially sectioned, producing 1.1 × 1.1 mm square test rods. The rods were prepared for tensile testing and tensile strength calculated at fracture. Type of fracture was examined under microscope. Results: Leaving the adhesive uncured prior to composite repair placement increased the mean tensile values statistically significant for all adhesives tested, with or without silane pretreatment. Silane surface treatment improved significantly (p < 0.001) tensile strength values for all adhesives, both for the cured and uncured groups. The mean strength of the control composite was higher than the strongest repair strength (p < 0.001). Conclusions: Application of freshly made silane and a thin bonding layer, rendered higher tensile bond strength. Not curing the adhesive before composite placement increased the tensile bond strength.

Erosive and Mechanical Tooth Wear in Viking Age Icelanders.

(1) Background: The importance of the Icelandic Sagas as a source of information about diet habits in medieval Iceland, and possibly other Nordic countries, is obvious. Extensive tooth wear in archaeological material worldwide has revealed that the main cause of this wear is believed to have been a coarse diet. Near the volcano Hekla, 66 skeletons dated from before 1104 were excavated, and 49 skulls could be evaluated for tooth wear. The purpose of this study was to determine the main causes of tooth wear in light of diet and beverage consumption described in the Sagas; (2) Materials and methods: Two methods were used to evaluate tooth wear and seven for age estimation; (3) Results: Extensive tooth wear was seen in all of the groups, increasing with age. The first molars had the highest score, with no difference between sexes. These had all the similarities seen in wear from a coarse diet, but also presented with characteristics that are seen in erosion in modern Icelanders, through consuming excessive amounts of soft drinks. According to the Sagas, acidic whey was a daily drink and was used for the preservation of food in Iceland, until fairly recently; (4) Conclusions: It is postulated that the consumption of acidic drinks and food, in addition to a coarse and rough diet, played a significant role in the dental wear seen in ancient Icelanders.

Enamel erosion and mechanical tooth wear in medieval Icelanders.

OBJECTIVES: The Icelandic Sagas are an important source of information on the way of life and diet habits in Iceland and possibly other Nordic countries 1000 years ago. Archaeological human skull material worldwide has revealed extensive tooth wear, with the main cause believed to be coarse diet. From a graveyard near volcano Hekla, 66 skeletons dated from before 1104 were excavated. The purpose of this study was to determine the main causes of tooth wear in Icelanders 1000 years ago. MATERIALS AND METHODS: Forty-nine skulls were available for research. Two methods were used to evaluate tooth wear and seven for age estimation. An attempt was made to determine the main causes of tooth wear in the light of likely diet and beverage consumption according to a computer search on food and drink customs described in the Icelandic Sagas. RESULTS: Tooth wear was extensive in all groups, increasing with age. The highest score was on first molars, with no difference between sexes. It had all the similarities seen in wear from coarse diet. In some instances it had similar characteristics to those seen in erosion in modern Icelanders consuming excessive amounts of soft drinks. According to the Sagas, acidic whey was a daily drink and used for preservation of food in Iceland until recently. CONCLUSIONS: Since acidic whey has considerably high dental erosive potential, it is postulated that consumption of acidic drinks and food, in addition to a coarse and rough diet, played a significant role in the dental wear of ancient Icelanders.