On the Ytterbium Valence and the Physical Properties in Selected Intermetallic Phases.

The present review summarizes important aspects of the crystal chemistry of ytterbium-based intermetallic compounds along with a selection of their outstanding physical properties. These originate in many cases from the ytterbium valence. Different valence states are possible here, divalent (4f14), intermediate-valent, or trivalent (4f13) ytterbium, resulting in simple diamagnetic, Pauli or Curie-Weiss paramagnetic, or valence fluctuating behavior. Especially, some of the Yb3+ intermetallics have gained deep interest due to their Kondo or heavy Fermion ground states. We have summarized their property investigations using magnetic and transport measurements, specific heat data, NMR, ESR, and Mössbauer spectroscopy, elastic and inelastic neutron scattering, and XAS data as well as detailed thermoelectric measurements.

Searching for Laves Phase Superstructures: Structural and 27Al NMR Spectroscopic Investigations in the Hf-V-Al System.

Laves phases exhibit a plethora of different structures and a multitude of physical properties. Investigations in the ternary system Hf-V-Al led to the discovery of numerous members of the solid solution Hf(V1-xAlx)2, which adopt the hexagonal MgZn2 type (C14) for medium to high amounts of Al (x = 0.2-1) and the cubic MgCu2 type (C15) for small Al amounts (x = 0.05-0.1). While all members exhibit Pauli-paramagnetic behavior due to the absence of localized magnetic moments, the V-rich cubic member Hf(V0.95Al0.05)2 additionally exhibits a superconducting state below TC = 7.6(1) K. All synthesized compounds were characterized by powder X-ray diffraction, and selected samples were furthermore investigated by 27Al solid-state magic-angle spinning (MAS) NMR. HfAl2 exhibits two Al resonances, one rather sharp and one significantly broadened signal, in line with the crystal structure and respective coordination environments. The members of the solid solution exhibit extremely broadened resonances due to the mixing of V and Al on the same crystallographic sites. For nominal Hf(V0.125Al0.875)2, however, two distinct sharp NMR signals were observed. This contrasts with the description of a solid solution. Therefore, single-crystal X-ray studies were conducted, showing that Hf(V0.125Al0.875)2 really is an ordered compound with the sum formula Hf4VAl7 (P3̅m1), which exhibits an, thus far, unknown superstructure of MgZn2.

Photo-cross-linked and pH-Switchable Soft Polymer Nanocapsules from Polyglycidyl Ethers.

Soft polymer nanocapsules and microgels, which can adapt their shape and, at the same time, sequester and release molecular payloads in response to an external trigger, are a challenging complement to vesicular structures like polymersomes. In this work, we report the synthesis of such capsules by photo-cross-linking of coumarin-substituted polyglycidyl ethers, which we prepared by Williamson etherification of epichlorohydrin (ECH) repeating units with 7-hydroxycoumarin in copolymers with tert-butyl glycidyl ether (tBGE). To control capsule size, we employed the prepolymers in an o/w miniemulsion, where they formed a gel layer at the interface upon irradiation at 365 nm by [2π + 2π] photodimerization of the coumarin groups. Upon irradiation at 254 nm, the reaction could be reversed and the gel wall could be repeatedly disintegrated and rebuilt. We further demonstrated (i) reversible hydrophilization of the gels by hydrolysis of the lactone rings in coumarin dimers as a mechanism to manipulate the permeability of the capsules and (ii) binding functional molecules as amides. Thus, the presented nanogels are remarkably versatile and can be further used as a carrier system.

Theoretical and 27Al NMR Spectroscopic Investigations of Binary Intermetallic Alkaline-Earth Aluminides.

The binary alkaline-earth aluminides AEAl2 (AE = Ca and Sr) and AEAl4 (AE = Ca-Ba) have been synthesized from the elements and investigated via powder X-ray diffraction experiments. CaAl2 adopts the cubic MgCu2-type structure (Fd3̅m), while SrAl2 crystallizes in the orthorhombic KHg2-type (Imma). LT-CaAl4 crystallizes with the monoclinic CaGa4-type (C2/m), while HT-CaAl4, SrAl4, and BaAl4 adopt the tetragonal BaAl4-type structure (I4/mmm). The close structural relation of the two CaAl4 polymorphs was established using a group-subgroup relation in the Bärnighausen formalism. In addition to the room-temperature and normal pressure phase of SrAl2, a high-pressure/high-temperature phase has been prepared using multianvil techniques, and its structural and spectroscopic parameters were determined. Elemental analysis by inductively coupled plasma mass spectrometry showed that no significant impurities with other elements besides the weighed ones are present and the chemical compositions match the synthesized ones. The title compounds have been furthermore investigated by 27Al solid-state magic angle spinning NMR experiments to validate the crystal structure and to gain information about the influence of the composition on the electron transfer and the NMR characteristics. This has also been investigated from a quantum chemical point of view using Bader charges, while the stabilities of the binary compounds in the three phase diagrams (Ca-Al, Sr-Al and Ba-Al) have been studied by calculations of formation energies per atom.

Raman and NMR spectroscopic and theoretical investigations of the cubic laves-phases REAl2 (RE = Sc, Y, La, Yb, Lu).

The cubic Laves-phase aluminides REAl2 with RE = Sc, Y, La, Yb and Lu were prepared from the elements by arc-melting or using refractory metal ampoules and induction heating. They all crystallize in the cubic crystal system with space group Fd3̄m and adopt the MgCu2 type structure. The title compounds were characterized by powder X-ray diffraction and spectroscopically investigated using Raman and 27Al and in the case of ScAl2 by 45Sc solid-state MAS NMR. In both, the Raman and NMR spectra, the aluminides exhibit only one signal due to the crystal structure. DFT calculations were used to calculate Bader charges illustrating the charge transfer in these compounds along with NMR parameters and densities of states. Finally, the bonding situation was assessed by means of ELF calculations rendering these compounds aluminides with positively charged REδ+ cations embedded in an [Al2]δ- polyanion.

Comparison of Candida antarctica Lipase B Variants for Conversion of ε-Caprolactone in Aqueous Medium-Part 2.

Enzyme-catalyzed ring-opening polymerization of lactones is a method of increasing interest for the synthesis of polyesters. In the present work, we investigated which changes in the structure of Candida antarctica lipase B (CaLB) shift the catalytic equilibrium between esterification and hydrolysis towards polymerization. Therefore, we present two concepts: (i) removing the glycosylation of CaLB to increase the surface hydrophobicity; and (ii) introducing a hydrophobic lid adapted from Pseudomonas cepacia lipase (PsCL) to enhance the interaction of a growing polymer chain to the elongated lid helix. The deglycosylated CaLB (CaLB-degl) was successfully generated by site-saturation mutagenesis of asparagine 74. Furthermore, computational modeling showed that the introduction of a lid helix at position Ala148 was structurally feasible and the geometry of the active site remained intact. Via overlap extension PCR the lid was successfully inserted, and the variant was produced in large scale in Pichia pastoris with glycosylation (CaLB-lid) and without (CaLB-degl-lid). While the lid variants show a minor positive effect on the polymerization activity, CaLB-degl showed a clearly reduced hydrolytic and enhanced polymerization activity. Immobilization in a hydrophobic polyglycidol-based microgel intensified this effect such that a higher polymerization activity was achieved, compared to the "gold standard" Novozym® 435.

CaLB Catalyzed Conversion of ε-Caprolactone in Aqueous Medium. Part 1: Immobilization of CaLB to Microgels.

The enzymatic ring-opening polymerization of lactones is a method of increasing interest for the synthesis of biodegradable and biocompatible polymers. In the past it was shown that immobilization of Candida antarctica lipase B (CaLB) and the reaction medium play an important role in the polymerization ability especially of medium ring size lactones like ε-caprolactone (ε-CL). We investigated a route for the preparation of compartmentalized microgels based on poly(glycidol) in which CaLB was immobilized to increase its esterification ability. To find the ideal environment for CaLB, we investigated the acceptable water concentration and the accessibility for the monomer in model polymerizations in toluene and analyzed the obtained oligomers/polymers by NMR and SEC. We observed a sufficient accessibility for ε-CL to a toluene like hydrophobic phase imitating a hydrophobic microgel. Comparing free CaLB and Novozym® 435 we found that not the monomer concentration but rather the solubility of the enzyme, as well as the water concentration, strongly influences the equilibrium of esterification and hydrolysis. On the basis of these investigations, microgels of different polarity were prepared and successfully loaded with CaLB by physical entrapment. By comparison of immobilized and free CaLB, we demonstrated an effect of the hydrophobicity of the microenvironment of CaLB on its enzymatic activity.

Developing a registry of workers involved in nanotechnology: BASF experiences.

OBJECTIVE: To assist BASF in the establishment of a registry of workers involved in nanotechnology. METHODS: The initial step was a complete inventory of nanomaterials and sites of use. Guidance was developed to clarify which particulate nanomaterials were to be included in the survey. Site management was then contacted by the medical department to obtain a list of workers. RESULTS: The time line for collecting data ranged from several months to a year, depending on the information needed, and presented challenges based on the lack of global definition and labeling of nanomaterials. Less than 50 nanomaterials are used as raw materials in less than 10% of the sites globally. In North America, less than 5% of sites and 5% workers use nanomaterials. CONCLUSIONS: Further work is required to integrate the inventory, registry, and exposure assessments.

Fluorescence spectroscopy measurements in ultrasonic navigated resection of malignant brain tumors.

BACKGROUND AND OBJECTIVE: Glioblastoma multiforme is a highly malignant primary brain tumor. It has no border but at best a marginal zone, however, invisible to the surgeon. An optical touch pointer (OTP) enabling differentiation of healthy and tumor tissue by means of fiber-optic fluorescence spectroscopy has been developed. In combination with an ultrasonic navigation system, the OTP may be used for demarcation of resectable tumor tissue. The aim of the study was to evaluate the clinical performance of OTP during surgery of malignant brain tumors. STUDY DESIGN/MATERIALS AND METHODS: Nine patients were operated on with the standard surgical procedure, including white light microscopy and navigation. A total of 5 mg/kg bodyweight of 5-amino-levulin acid was orally administrated before surgery. The OTP was calibrated into the ultrasound-based navigation system and measurements were performed in tumor core and along the tumor border. The ratio between the protoporphyrin IX fluorescence at 635 nm and the autofluorescence was used for quantifications of data. Biopsies (n = 20), ultrasound images (n = 30), and visual inspection (n = 180) were compared to the fluorescence ratio. RESULTS/CONCLUSION: Healthy and tumor tissue could be identified and differentiated with the OTP (P < 0.001). The fluorescence ratio in average was 0 outside the tumor and low in the gliotic edema zone around the tumor. It increased in the marginal zone and was highest in the solid tumor tissue. In the necrotic tissue, in the center of the tumor, the ratio in average was 0. The OTP can be used in combination with ultrasound-based navigation and may help to determine whether to resect otherwise not identifiable tissue.