Degradation and fate of 2,4-dinitroanisole (DNAN) and its intermediates treated with Mg/Cu bimetal: Surface examination with XAS, DFT, and LDI-MS.

A novel Mg-based bimetal reagent (Mg/Cu) was used as an enhanced reductive system to degrade insensitive munition 2,4-dinitroanisole (DNAN), a contaminant found in energetic-laden waste. Degradation of DNAN was significantly impacted by dissolved oxygen and studied in anoxic and oxic bimetal systems (i.e., purging with N2, air, or O2 gas). Degradation occurred through sequential nitroreduction: first one nitro group was reduced (ortho or para) to form short-lived intermediates 2-amino-4-nitroanisole or 4-amino-2-nitroanisole (2-ANAN or 4-ANAN), and then subsequent reduction of the other nitro group formed 2,4-diaminoanisole (DAAN). The nitro-amino intermediates demonstrated regioselective reduction in the ortho position to 2-ANAN; Regioselectivity was also impacted by the anoxic/oxic environment. Under O2-purging DNAN degradation rate was slightly enhanced, but most notably O2 significantly accelerated DAAN generation. DAAN also further degraded only in the oxygenated Mg/Cu system. Adsorption of DNAN byproducts to the reagent occurred regardless of anoxic/oxic condition, resulting in a partition of carbon mass between the adsorbed phase (27%-35%) and dissolved phase (59%-72%). Additional surface techniques were applied to investigate contaminant interaction with Cu. Density functional theory (DFT) calculations identified preferential adsorption structures for DNAN on Cu with binding through two O atoms of one or both nitro groups. X-ray absorption spectroscopy (XAS) measurements determined the oxidation state of catalytic metal Cu and formation of a Cu-O-N bond during treatment. Laser desorption ionization mass spectrometry (LDI-MS) measurements also identified intermediate 2-ANAN adsorbed to the bimetal surface.

Acetic Acid Adsorption and Reactions on Ni(110).

Acetic acid adsorption and reactions at multiple surface coverage values on Ni(110) were studied with temperature-programmed desorption (TPD) and infrared reflection absorption spectroscopy (IRAS) at 90-500 K. The experimental measurements were interpreted with density functional theory (DFT) calculations that provided information on adsorbate geometries, energies, and vibrational modes. Below the monolayer saturation coverage of 0.36 ML at 90 K, acetic acid adsorbs mostly molecularly. Above this coverage, a physisorbed layer is formed with dimers and catemers, without detectable monomers. Dimers and catemers desorb as molecular acetic acid at 157 and 172 K, respectively. Between 90 and 200 K, the O-H bond in acetic acid breaks to form bridge-bonded bidentate acetate that becomes the dominant surface species. Desorption-limited hydrogen evolution is observed at 265 K. However, even after the acetate formation, acetic acid desorbs molecularly at 200-300 K due to recombination. Minor surface species observed at 200 K, acetyls or acetates with a carbonyl group, decompose below 350 K and generate adsorbed carbon monoxide. At 350 K, the surface likely undergoes restructuring, the extent of which increases with acetic acid coverage. The initial dominant bridge-bonded bidentate acetate species formed below 200 K remain on the surface, but they now mostly adsorb on the restructured sites. The acetates and all other remaining hydrocarbon species decompose simultaneously at 425 K in a narrow temperature range with concurrent evolution of hydrogen, carbon monoxide, and carbon dioxide. Above 425 K, only carbon remains on the surface.