Sputtering Codeposition and Metal-Induced Crystallization to Enhance the Power Factor of Nanocrystalline Silicon.

The power factor of highly boron-doped nanocrystalline Si thin films with controlled doping concentration is investigated. We achieve a high degree of tuning of boron content with a charge carrier concentration from 1018 to 1021/cm3 and with the electrical conductivity by varying the boron magnetron power from 10 to 60 W while maintaining the power of a SiB source constant during codeposition from two independent sputtering sources. Along with the increase in the electrical conductivity with increased boron doping, we observe a steady decrease in the Seebeck coefficient from 500 to 100 µV/K. These values result in power factors that exhibit a marked maximum of 5 mW/K2m for a carrier concentration of around 1021/cm3 at room temperature. Temperature-dependent measurements up to 650 °C show, with increasing doping concentration, a change of the resistivity from a semiconducting to a metallic behavior and an increase of both Seebeck coefficient and power factor, with this last one peaking at 9.8 mW/K2m in the 350-550 °C temperature range. For higher concentrations, scanning electron microscopy and energy-dispersive X-ray spectroscopy show a partial segregation of boron on particles on the surface. These results exemplify the great advantage of sputtering codeposition methods to easily tune and optimize the thermoelectric performance in thin films, obtaining in our specific case highly competitive power factors in a simple and reliable manner.

Micro-Kelvin Resolution at Room Temperature Using Nanomechanical Thermometry.

Ultrahigh sensitivity temperature measurement is becoming increasingly relevant for different scientific and technological fields from fundamental physics to high-precision engineering applications. Here, we demonstrate the use of a nanomechanical resonator-free standing silicon nitride membranes with thicknesses in the nanoscale-for room temperature thermometry reaching an unprecedented resolution of 15 µK. These devices were characterized by using an interferometric system at high vacuum, where there are only two possible mechanisms for heat transfer: thermal conductivity and radiation. While the expected behavior should be to decrease the frequency of the mechanical resonance due to the thermoelastic effect, we observe that the nanomechanical response can be both positive and negative depending on the thermal flux: a heat point source always shifts the mechanical resonance to lower frequencies, while a distributed heat source shifts the resonance to higher frequencies.

Deconvolution of Phonon Scattering by Ferroelectric Domain Walls and Point Defects in a PbTiO3 Thin Film Deposited in a Composition-Spread Geometry.

We present a detailed analysis of the temperature dependence of the thermal conductivity of a ferroelectric PbTiO3 thin film deposited in a composition-spread geometry enabling a continuous range of compositions from ∼25% titanium deficient to ∼20% titanium rich to be studied. By fitting the experimental results to the Debye model we deconvolute and quantify the two main phonon-scattering sources in the system: ferroelectric domain walls (DWs) and point defects. Our results prove that ferroelectric DWs are the main agent limiting the thermal conductivity in this system, not only in the stoichiometric region of the thin film ([Pb]/[Ti] ≈ 1) but also when the concentration of the cation point defects is significant (up to ∼15%). Hence, DWs in ferroelectric materials are a source of phonon scattering at least as effective as point defects. Our results demonstrate the viability and effectiveness of using reconfigurable DWs to control the thermal conductivity in solid-state devices.

Ferroelectric Domain Walls in PbTiO3 Are Effective Regulators of Heat Flow at Room Temperature.

Achieving efficient spatial modulation of phonon transmission is an essential step on the path to phononic circuits using "phonon currents". With their intrinsic and reconfigurable interfaces, domain walls (DWs), ferroelectrics are alluring candidates to be harnessed as dynamic heat modulators. This paper reports the thermal conductivity of single-crystal PbTiO3 thin films over a wide variety of epitaxial-strain-engineered ferroelectric domain configurations. The phonon transport is proved to be strongly affected by the density and type of DWs, achieving a 61% reduction of the room-temperature thermal conductivity compared to the single-domain scenario. The thermal resistance across the ferroelectric DWs is obtained, revealing a very high value (≈5.0 × 10-9 K m2 W-1), comparable to grain boundaries in oxides, explaining the strong modulation of the thermal conductivity in PbTiO3. This low thermal conductance of the DWs is ascribed to the structural mismatch and polarization gradient found between the different types of domains in the PbTiO3 films, resulting in a structural inhomogeneity that extends several unit cells around the DWs. These findings demonstrate the potential of ferroelectric DWs as efficient regulators of heat flow in one single material, overcoming the complexity of multilayers systems and the uncontrolled distribution of grain boundaries, paving the way for applications in phononics.

Enhanced antibody recognition with a magneto-optic surface plasmon resonance (MO-SPR) sensor.

A comparison between sensing performance of traditional SPR (Surface Plasmon Resonance) and magneto-optic SPR (MOSPR) transducing techniques is presented in this work. MOSPR comes from an evolution of traditional SPR platform aiming at modulating Surface Plasmon wave by the application of an external magnetic field in transverse configuration. Previous work demonstrated that, when the Plasmon resonance is excited in these structures, the external magnetic field induces a modification of the coupling of the incident light with the Surface Plasmon Polaritons (SPP). Besides, these structures can lead to an enhancement in the magneto-optical (MO) activity when the SPP is excited. This phenomenon is exploited in this work to demonstrate the possibility to use the enhanced MO signal as proper transducer signal for investigating biomolecular interactions in liquid phase. To this purpose, the transducer surface was functionalized by thiol chemistry and used for recording the binding between Bovine Serum Albumin molecules immobilized onto the surface and its complementary target. Higher sensing performance in terms of sensitivity and lower limit of detection of the MOSPR biosensor with respect to traditional SPR sensors is demonstrated.

Probing the electromagnetic field distribution within a metallic nanodisk.

A Co nanolayer is used as a local probe to evaluate the vertical inhomogeneous distribution of the electromagnetic (EM) field within a resonant metallic nanodisk. Taking advantage of the direct relation between the magneto-optical activity and the electromagnetic field intensity in the Co layer, it is shown that the nonuniform EM distribution within the nanodisk under plasmon resonant conditions has maximum values close to the upper and lower flat faces, and a minimum value in the middle.