Acetone Vapor-Sensing Properties of Chitosan-Polyethylene Glycol Using Surface Plasmon Resonance Technique.

To non-invasively monitor and screen for diabetes in patients, there is need to detect low concentration of acetone vapor in the range from 1.8 ppm to 5 ppm, which is the concentration range of acetone vapor in diabetic patients. This work presents an investigation for the utilization of chitosan-polyethylene glycol (PEG)-based surface plasmon resonance (SPR) sensor in the detection of trace concentration acetone vapor in the range of breath acetone in diabetic subjects. The structure, morphology, and elemental composition of the chitosan-PEG sensing layer were characterized using FTIR, UV-VIS, FESEM, EDX, AFM, and XPS methods. Response testing was conducted using low concentration of acetone vapor in the range of 0.5 ppm to 5 ppm using SPR technique. All the measurements were conducted at room temperature and 50 mL/min gas flow rate. The sensor showed good sensitivity, linearity, repeatability, reversibility, stability, and high affinity toward acetone vapor. The sensor also showed better selectivity to acetone compared to methanol, ethanol, and propanol vapors. More importantly, the lowest detection limit (LOD) of about 0.96 ppb confirmed the applicability of the sensor for the non-invasive monitoring and screening of diabetes.

Investigation of Acetone Vapour Sensing Properties of a Ternary Composite of Doped Polyaniline, Reduced Graphene Oxide and Chitosan Using Surface Plasmon Resonance Biosensor.

This work reports the use of a ternary composite that integrates p-Toluene sulfonic acid doped polyaniline (PANI), chitosan, and reduced graphene oxide (RGO) as the active sensing layer of a surface plasmon resonance (SPR) sensor. The SPR sensor is intended for application in the non-invasive monitoring and screening of diabetes through the detection of low concentrations of acetone vapour of less than or equal to 5 ppm, which falls within the range of breath acetone concentration in diabetic patients. The ternary composite film was spin-coated on a 50-nm-thick gold layer at 6000 rpm for 30 s. The structure, morphology and chemical composition of the ternary composite samples were characterized by FTIR, UV-VIS, FESEM, EDX, AFM, XPS, and TGA and the response to acetone vapour at different concentrations in the range of 0.5 ppm to 5 ppm was measured at room temperature using SPR technique. The ternary composite-based SPR sensor showed good sensitivity and linearity towards acetone vapour in the range considered. It was determined that the sensor could detect acetone vapour down to 0.88 ppb with a sensitivity of 0.69 degree/ppm with a linearity correlation coefficient of 0.997 in the average SPR angular shift as a function of the acetone vapour concentration in air. The selectivity, repeatability, reversibility, and stability of the sensor were also studied. The acetone response was 87%, 94%, and 99% higher compared to common interfering volatile organic compounds such as propanol, methanol, and ethanol, respectively. The attained lowest detection limit (LOD) of 0.88 ppb confirms the potential for the utilisation of the sensor in the non-invasive monitoring and screening of diabetes.

Green's function for a sharpened and metal-coated dielectric probe.

In apertureless scanning-probe optical microscopy and in the case of more traditional scanned optical probes coated with a metal that is thin near the probe tip (in lieu of an aperture), samples are probed via interaction between the probe and surface. In the nanometer-scale region between the tip and the sample, the field can be approximated by quasi-electrostatic analytics. Hence, the coated probe can be modeled as in the present case as a hyperboloid of revolution without the need for hyperboloidal wave functions in the near zone. The solutions to Laplace's equation and in general Green's function with the application of the boundary conditions, therefore, yield an appropriate approximation and allow a completely analytical solution for the resonance effects upon the probe tip to be obtained. The large field enhancements due to the sharpness of the tip and to surface plasmon fields may thus be analytically examined.

Chronic preclinical safety evaluation of Hematide, a pegylated peptidic erythropoiesis stimulating agent in monkeys.

Hematide is a synthetic peptide-based, pegylated erythropoiesis stimulating agent in clinical development for treatment of anemia. To support chronic clinical dosing requirements, a 9-month repeat dose IV monkey safety study was undertaken. Animals received 0, 0.2, 2 or 20 mg/kg hematide IV every three weeks for nine months followed by a 14-week recovery. Hematide administration was associated with time and dose-dependent polycythemia. Histological findings were related to exaggerated pharmacology that was secondary to the administration of an erythropoiesis stimulating agent to a normocythemic animal. In conclusion, these results support the use of repeated administration of hematide for the correction of anemia.

Preclinical safety and pharmacology of Hematide, a peptidic erythropoiesis stimulating agent (ESA), in rats and monkeys.

The pharmacology, toxicokinetics, and safety of Hematide, a synthetic peptidic erythropoiesis-stimulating agent (ESA), were characterized. Hematide was given intravenously (0, 0.5, 5, and 50 mg/kg) weekly for five weeks with a 6- (rat) and 12-week (monkey) recovery period. The pharmacological action of Hematide resulted in polycythemia. Histopathology consistent with drug-induced exaggerated pharmacology was observed primarily in rats. Secondary sequelae resulting from pronounced polycythemia was considered the cause of deaths in rats and a single high-dose monkey. Toxicokinetic analysis indicated prolonged exposure. In conclusion, Hematide is a potent ESA and the safety and efficacy profile support clinical development.

Dynamic microcantilever sensors for discerning biomolecular interactions.

Response of a conductive micromechanical cantilever placed in close proximity to a surface undergoing electrical excitation near the resonance frequency of the cantilever is influenced by the presence of microscopic dielectrics in the gap between the cantilever and the sample surface. The variations of the resonance response of unmodified cantilevers at gap distances below a few hundred nanometers are used to discern biomolecular differences of oligomeric nucleic acids in an array format without the use of extrinsic labels. The resonance response variation paves the way for the development of high throughput detection of biomolecular reactions, such as DNA hybridization reactions or antibody-antigen interactions without the use of external labels, in which the need is only to see the presence or absence of interaction. This dynamic method is simple, does not require immobilizing individual elements on a cantilever array, and is compatible with current generation DNA chips in which DNA spots are deposited in micro- and nanoarray format.