ABSTRACT
PURPOSE: The influence of surface energy on the compactibility of lactose particles has been investigated. MATERIALS AND METHODS: Three powders were prepared by spray drying lactose solutions without or with low proportions of the surfactant polysorbate 80. Various powder and tablet characterisation procedures were applied. The surface energy of the powders was characterized by Inverse Gas Chromatography and the compressibility of the powders was described by the relationship between tablet porosity and compression pressure. The compactibility of the powders was analyzed by studying the evolution of tablet tensile strength with increasing compaction pressure and porosity. RESULTS: All powders were amorphous and similar in particle size, shape, and surface area. The compressibility of the powders and the microstructure of the formed tablets were equal. However, the compactibility and dispersive surface energy was dependent of the composition of the powders. CONCLUSION: The decrease in tablet strength correlated to the decrease in powder surface energy at constant tablet porosities. This supports the idea that tablet strength is controlled by formation of intermolecular forces over the areas of contact between the particles and that the strength of these bonding forces is controlled by surface energy which, in turn, can be altered by the presence of surfactants.
Subject(s)
Powders/chemistry , Tablets/chemistry , Lactose/chemistry , Porosity , Surface Properties , Technology, Pharmaceutical , Tensile StrengthABSTRACT
The objective of this study was to investigate the effect of fracture strength of paracetamol particles on their compactability. For this purpose two series of paracetamol particles were prepared by crystal agglomeration and by granulation using different solvents. A free flowing particle size fraction of all types of particles was characterized with respect to their shape, degree of agglomeration and single fracture strength. The powders were compressed to tablets and the compression mechanism of the particles and the evolution in tablet micro-structure were assessed by compression parameters derived from the Heckel and Kawakita equations and by a tablet permeabililty coefficient. Tablet tensile strength and porosity were determined. The degree of deformation and fragmentation during compression varied between agglomerates and granules and was dependent on their failure strength. The granules varied in compactability with particle failure strength while the agglomerates showed limited variation. It is proposed that, the dominant mechanism of compression for the granules was permanent deformation while for the agglomerates it was fragmentation. It was thus found that the compression mechanism of the particles was dependent on both the degree of agglomeration and the particle failure strength.
Subject(s)
Acetaminophen/chemistry , Chemistry, Pharmaceutical/methods , Acetone/chemistry , Compressive Strength , Crystallization , Elasticity , Ethanol/chemistry , Methanol/chemistry , Microscopy, Electron, Scanning , Particle Size , Permeability , Porosity , Powders/chemistry , Pressure , Solvents/chemistry , Tensile Strength , Water/chemistryABSTRACT
The objective of this study was to investigate the effect of the distribution in size of free-flowing particles for the evolution in tablet structure and tablet strength. For sucrose and sodium chloride, three powders of different size distributions were prepared by mixing predetermined quantities of particle size fractions. For paracetamol, three batches with varying particle size distributions were prepared by crystallisation. The powders were formed into tablets. Tablet porosity and tensile strength were determined directly after compaction and after short-term storage at two different relative humidities. Tablets were also formed after admixture of a lubricant (magnesium stearate) and the tablet tensile strength was determined. For the test materials used in this study, the spread in particle size had no influence on the evolution in tablet porosity and tensile strength during compression. However, the spread in particle size had a significant and complex influence on the short-term post-compaction increase in tablet tensile strength. The effect of the spread was related to the instability mechanism and the presence of lubricant. It is concluded that the distribution in size of free-flowing particles is not critical for the tablet porosity but may give significant effects on tablet tensile strength due to a post-compaction reaction.
