ABSTRACT
Metal-coated plastic parts are replacing traditional metallic materials in the automotive industry. Sputtering is an alternative technology that is more environmentally friendly than electrolytic coatings. Most metalized plastic parts are coated with a thin metal layer (~100-200 nm). In this work, the challenge is to achieve thicker films without cracking or without other defects, such as pinholes or pores. Chromium coatings with different thicknesses were deposited onto two different substrates, polycarbonate with and without a base coat, using dc magnetron sputtering in an atmosphere of Ar. Firstly, in order to improve the coating adhesion on the polymer surface, a plasma etching treatment was applied. The coatings were characterized for a wide thickness range from 800 nm to 1600 nm. As the thickness of the coatings increased, there was an increase in the specular reflectivity and roughness of the coatings and changes in morphology due to the columnar growth of the film and a progressive increase in thermal stresses. Furthermore, a decrease in the hardness and the number of pinholes was noticed. The maximum thickness achieved without forming buckling defects was 1400 nm. The tape tests confirmed that every deposited coating showed a good interface adhesion to both polymers.
ABSTRACT
Pathogens (disease-causing microorganisms) can survive up to a few days on surfaces and can propagate through surfaces in high percentages, and thus, these surfaces turn into a primary source of pathogen transmission. To prevent and mitigate pathogen transmission, antimicrobial surfaces seem to be a promising option that can be prepared by using resilient, mass-produced polymers with partly embedded antimicrobial nanoparticles (NPs) with controlled size. In the present study, a 6 nm thick Ag nanolayer was sputter deposited on polycarbonate (PC) substrate and then thermally annealed, in a first step at 120 °C (temperature below Tg) for two hours, for promoting NP diffusion and growth, and in a second step at 180 °C (temperature above Tg) for 22 h, for promoting thermal embedding of the NPs into the polymer surface. The variation in the height of NPs on the polymer surface with thermal annealing confirms the embedding of NPs. It was shown that the incorporation of silver nanoparticles (Ag NPs) had a great impact on the antibacterial capacity, as the Ag NP-embedded polymer surface presented an inhibition effect on the growth of Gram-positive and Gram-negative bacteria. The tested surface-engineering process of incorporating antimicrobial Ag NPs in a polymer surface is both cost-effective and highly scalable.
