Robust phase determination in complex solid solutions using diffuse multiple scattering.

A novel methodology is presented for identifying and distinguishing between structural phases in multi-phasic systems, such as piezoelectric materials like PMN-PT [Pb(Mg1/3Nb2/3)O3-PbTiO3], PIN-PMN-PT [Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3] and PZT [Pb(Zr,Ti)O3], using diffuse multiple scattering and Kossel line diffraction techniques. The method exploits the splitting of triple line intersections from special coplanar reflections combined with logical constraints to generate a splitting fingerprint for robust crystallographic phase determination and discrimination.

Magnetoelastic Effects in Doubly Clamped Electroplated Co77Fe23 Microbeam Resonators.

Magnetostrictive Co77Fe23 films are fully suspended to produce free-standing, clamped-clamped, microbeam resonators. A negative or positive shift in the resonant frequency is observed for magnetic fields applied parallel or perpendicular to the length of the beam, respectively, confirming the magnetoelastic nature of the shift. Notably, the resonance shifts linearly with higher-bias fields oriented perpendicular to the beam's length. Domain imaging elucidates the distinction in the reversal processes along the easy and hard axes. Together, these results suggest that through modification of the magnetic anisotropy, the frequency shift and angular dependence can be tuned, producing highly magnetic-field-sensitive resonators.

Strain-assisted magnetization reversal in Co/Ni multilayers with perpendicular magnetic anisotropy.

Multifunctional materials composed of ultrathin magnetic films with perpendicular magnetic anisotropy combined with ferroelectric substrates represent a new approach toward low power, fast, high density spintronics. Here we demonstrate Co/Ni multilayered films with tunable saturation magnetization and perpendicular anisotropy grown directly on ferroelectric PZT [Pb(Zr0.52Ti0.48)O3] substrate plates. Electric fields up to ±2 MV/m expand the PZT by 0.1% and generate at least 0.02% in-plane compression in the Co/Ni multilayered film. Modifying the strain with a voltage can reduce the coercive field by over 30%. We also demonstrate that alternating in-plane tensile and compressive strains (less than 0.01%) can be used to propagate magnetic domain walls. This ability to manipulate high anisotropy magnetic thin films could prove useful for lowering the switching energy for magnetic elements in future voltage-controlled spintronic devices.

Simultaneous Stress and Field Control of Sustainable Switching of Ferroelectric Phases.

In ferroelectrics, manifestation of a strong electromechanical coupling is attributed to both engineered domain morphology and phase transformations. However, realization of large sustainable and reversible strains and polarization rotation has been limited by fatigue, nonlinearity and hysteresis losses. Here, we demonstrate that large strain and polarization rotation can be generated for over 40 × 10(6) cycles with little fatigue by realization of a reversible ferroelectric-ferroelectric phase transition in [011] cut Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3 (PIN-PMN-PT) relaxor ferroelectric single crystal. Direct tuning of this effect through combination of stress and applied electric field, confirmed both macroscopically and microscopically with x-ray and Raman scattering, reveals the local symmetry while sweeping through the transition with a low applied electric field (<0.2 MV/m) under mechanical stress. The observed change in local symmetry as determined by x-ray scattering confirms a proposed polarization rotation mechanism corresponding to a transition between rhombohedral and orthorhombic phases. These results shed more light onto the nature of this reversible transformation between two ferroelectric phases and advance towards the development of a wide range of ferroic and multiferroic devices.

Natural skin surface pH is on average below 5, which is beneficial for its resident flora.

Variable skin pH values are being reported in literature, all in the acidic range but with a broad range from pH 4.0 to 7.0. In a multicentre study (N = 330), we have assessed the skin surface pH of the volar forearm before and after refraining from showering and cosmetic product application for 24 h. The average pH dropped from 5.12 +/- 0.56 to 4.93 +/- 0.45. On the basis of this pH drop, it is estimated that the 'natural' skin surface pH is on average 4.7, i.e. below 5. This is in line with existing literature, where a relatively large number of reports (c. 50%) actually describes pH values below 5.0; this is in contrast to the general assumption, that skin surface pH is on average between 5.0 and 6.0. Not only prior use of cosmetic products, especially soaps, have profound influence on skin surface pH, but the use of plain tap water, in Europe with a pH value generally around 8.0, will increase skin pH up to 6 h after application before returning to its 'natural' value of on average below 5.0. It is demonstrated that skin with pH values below 5.0 is in a better condition than skin with pH values above 5.0, as shown by measuring the biophysical parameters of barrier function, moisturization and scaling. The effect of pH on adhesion of resident skin microflora was also assessed; an acid skin pH (4-4.5) keeps the resident bacterial flora attached to the skin, whereas an alkaline pH (8-9) promotes the dispersal from the skin.

Dynamic elastic hysteretic solids and dislocations.

Recently we showed that the quasistatic response of nonlinear mesoscopic elastic solids to stress can be explained by invoking the formation of dislocation-based incipient kink bands. In this Letter, using resonant ultrasound spectroscopy, we confirm that the dynamical behavior of these nonlinear elastic systems is due to the interaction of dislocations with the ultrasound waves, thus resolving a long-standing mystery.

In vitro testing to assess the UVA protection performance of sun care products.

The UVA protection delivered by sunscreens is an issue of increasing importance due to the increasing knowledge about UVA-induced skin damage. In Europe there is no officially accepted method available to determine the degree of UVA protection. Therefore, the objective of the present study was to design a protocol combining the merits of an in vitro model, which are simple and reproducible, with aspects known to be relevant from in vivo studies. The principle is: an UV-transparent support to which the test product is applied, a (pre)irradiation and a transmission measurement. Transpore(R) tape (standard support for SPF determinations) was found to be incompatible with many preparations on prolonged contact times. Roughened quartz was adopted as a suitable alternative. Transmission measurements on this support are not reliable with a layer of 2 mg cm(-2) (standard for SPF) due to detection limitations of spectrophotometers, hence a reduced layer of 0.75 mg cm(-2) was adopted. Overall, it is very difficult to apply products in a reproducible thin layer on appropriate substrates. As a consequence, absolute parameters derived from the transmission profile show relatively large dispersion, whereas relative parameters, such as critical wavelength lambda(c)[1] or UVA/UVB ratio are much less sensitive to unavoidable variations in layer thickness. An increase in deviations was observed when the samples were irradiated before measurement. It is crucial to control the output carefully (spectral distribution and even more importantly, irradiance and dose delivered) of the light source. By doing so and also taking into account the previous learning steps, a protocol was drafted and tested in a ringtest (four samples in six laboratories). The results are encouraging and show that if relative parameters (e.g. lambda(c), UVA/UVB ratio) are considered, the intra- as well as interlaboratory reproducibility is clearly better than can be obtained in vivo. In general, we describe a suitable method, which can be considered in any future official discussions about the methodology to determine UVA protection.

Experimental studies of the liquid-glass transition in trimethylheptane

The molecular glass former trimethylheptane was studied by calorimetric, dielectric, ultrasonic, neutron scattering, Brillouin scattering, and depolarized light-scattering techniques. The molecular structure appears to be nearly spherical optically as indicated by the low depolarization ratio and dielectric susceptibility values. A preliminary mode-coupling theory (MCT) analysis of the light-scattering and neutron-scattering data indicates that T(C) greater, similar150 K, at least 25 K above T(G). The susceptibility minima were analyzed with the MCT interpolation equation, and disagreement between the light and neutron results was observed despite the apparent isotropy of the molecules.

Collaborative development of a sun protection factor test method: a proposed European Standard. COLIPA Task Force 'Sun Protection Measurement', Europe.

Synopsis Standardization of the method to determine sun protection factors (SPF) is fundamental to uniform labelling of SPF values on sun products. The COLIPA Task Force 'Sun Protection Measurement'(SPM), including representatives of major European sun-product manufacturers and contract testing laboratories, was established in 1990 to define methods for sun products testing. The process involved in developing the COLlPA SPF Test Method started with a critical appraisal of previously existing methods, and identification of areas for improvement. Experiments were performed by the participating laboratories to establish the new recommended test protocol which was then confirmed in two multicentred ring tests. Improvements to test methodology included the number and selection of volunteers and skin types, the application of the product, the definition of W output from solar simulators, and the method for assessing erythemal response (MED) including an option to use colorimetry to define objectively the 'erythemal threshold' of skin and to predetermine MED prior to exposure. Four cosmetic formulations and neutral density physical filters (SPF from 4 to 20) were tested in two ring tests. Results showed that variations in SPF of the cosmetic products were, on average, directly proportional to SPF value. An excellent correlation was found between visual and colorimetric SPF assessments (r = 0.99). An acceptable range of values for low and high SPF standard products was also established. The COLIPA SPF test method is now fully defined and supported by experimental data. Its use will harmonize SPF testing throughout Europe and help in the quest for global harmonization in testing sun products.

Rehabilitation experiences of patients receiving dialysis.

The concept of "rehabilitation" contains physical, psychosocial, and vocational elements. An exploratory study was developed by ESRD Network 18 regarding patient rehabilitation experiences in Southern California. A questionnaire was developed, and data collected from 248 randomly selected work-eligible ESRD patients in the network. Results showed relatively few significant differences between employed and unemployed ESRD patients in terms of demographics, and on many aspects of physical function, psychosocial adaptation, and vocational rehabilitation potential. However, unemployed patients reported lower energy levels, less stamina for working, greater benefits for not working, and problems with vocational rehabilitation programs. Unemployed patients also had more negative attitudes about achieving life goals and former job experiences. To help patients overcome barriers to rehabilitation, facility staff can focus on management of ESRD complications, assisting patients with support groups, connecting patients to rehabilitation resources early, and encouraging employed patients to continue working as long as possible.

Schizophrenic performance on the Halstead-Reitan battery.

Compared Halstead-Reitan Battery scores of hospitalized male schizophrenics with scores of normals and brain-damaged Ss to determine performance patterns that differentiate the groups. Schizophrenics performed less well than normals on the Categories, TPT-Memory, and TPT-Location subtests and better than brain-damaged Ss on all subtests except Categories. In general, the effects of medication produced nonsignificant results.