ABSTRACT
According to the Quality by Design (QbD) concept, Design of Experiment (DoE) was used to indicate critical process parameters and optimize the fluid bed coating of minitablets in a laboratory size batch. Full factorial design was employed to increase knowledge of the process for three kinds of minitablet (MT) cores using two commercial gastro-resistant coating mixtures. The statistical analysis showed that different critical process parameters were indicated for the tested minitablets: X3: the coating mixture flow rate for MTs with pantoprazole sodium and Eudragit L; X2: the product temperature; X3 and X4: the spraying pressure for MTs with pantoprazole sodium and Acryl Eze II; and X1 and X2: MTs with diclofenac sodium. Such differences were the result of features, such as the sub-coat, size, and mass of the cores and the core and coating mixture composition. No optimal parameters were found for any of the tested MT types. Therefore, DoE should be considered as a statistical tool to individually optimize the process for the product, equipment, and tested parameters. However, optimization of the fluid bed coating allowed us to predict the values of the process parameters necessary to obtain good-quality products. Therefore, fluid bed coating may be successfully used to obtain modified-release MTs of high quality after applying the statistical tool DoE.
ABSTRACT
Novel calcium phosphate-based starter pellets were used to develop a biphasic-release multiple-unit pellet system (MUPS) with diclofenac sodium as a model drug in the form of hard gelatin capsules. For comparative purposes, corresponding formulations based on the inert cores made of microcrystalline cellulose, sucrose and isomalt were prepared. The developed system consisted of two types of drug-layered pellets attaining different release patterns: delayed-release (enteric-coated) and extended-release. Dissolution characteristics were examined using both compendial and biorelevant methods, which reflected fed and fasting conditions. The results were collated with an equivalent commercial product but prepared with the direct pelletization technique.
ABSTRACT
This study concerned the quality of mini-tablets' coating uniformity obtained by either the bottom spray chamber with a classical Wurster distributor (CW) or a swirl distributor (SW). Mini-tablets with a diameter of 2.0, 2.5, and 3.0 mm were coated with hypromellose using two different inlet air distributors as well as inlet airflow rates (130 and 156 m3/h). Tartrazine was used as a colorant in the coating layer and the coating uniformity was assessed by spectrophotometric analysis of solutions obtained after disintegration of the mini-tablets (n = 100). Higher uniformity of coating material distribution among the mini-tablets was observed in the case of SW distributor, even for the biggest mini-tablets (d = 3.0 mm), with an RSD no larger than 5.0%. Additionally, coating thickness was evaluated by colorimetric analysis (n = 1000), using a scanner method, and expressed as a hue value. A high correlation (R = 0.993) between inter-tablet variability of hue and UV-Vis results was obtained. Mini-tablets were successfully coated in a fluid bed system using both a classical Wurster distributor as well as a swirl generator. However, regardless of the mini-tablets' diameter, better film uniformity was achieved in the case of a distributor with a swirl generator.
