ABSTRACT
High concentrations of pollution particles, including "soot" or black carbon, exist over the Indian Ocean, but their sources and geographical origins are not well understood. We measured emissions from the combustion of biofuels, used widely in south Asia for cooking, and found that large amounts of carbonaceous aerosols are emitted per kilogram of fuel burnt. We calculate that biofuel combustion is the largest source of black carbon emissions in India, and we suggest that its control is central to climate change mitigation in the south Asian region.
ABSTRACT
Ultrafine particles (smaller than about 0.1 microm) are often emitted from combustion and other high-temperature processes in the form of fractal-like aggregates composed of solid nanoparticles. Results of a study of atmospheric aggregates are reported. Particles were collected on transmission electron microscope grids fitted on the last two stages of a single-jet eight-stage low-pressure impactor for periods of a few minutes. Photomicrographs of transmission electron microscope grids from the impactor stages were analyzed to obtain the fractal dimension (D(f)) and prefactor (A) for aggregates. D(f) increased from near 1 to above 2 as the number of primary particles making up the aggregates increased from 10 to 180. Total particle concentrations in size ranges roughly equivalent to the low-pressure impactor stages were measured with a mobility analyzer and condensation particle counter. In one set of measurements, the fraction of the particles present as aggregates was about 60% for particles with aerodynamic diameters between 50 and 75 nm and 34% for the range 75 to 120 nm. The total aggregate concentration in the 50- to 120-nm size range was about 400 ml(-1). The primary particles that make up atmospheric aggregates are more polydisperse than soot aggregates generated from a single laboratory source, an ethane/oxygen flame. Most measurements were made in the Los Angeles area, where the aggregates may represent a signature for diesel emissions. Rural aggregate concentrations in the size range 50 to 120 nm were less than 1% of the concentrations at urban sites. The data will permit better estimates of atmospheric aggregate residence times, transport, and deposition in the lung, optical extinction, and heterogeneous nucleation.
ABSTRACT
A technique is described for detecting and characterizing bacteria on a single-particle basis by mass spectrometry. The method involves generation of a particle beam of single whole cells which are rapidly volatilized and ionized in vacuum in the ion source of a quadrupole mass spectrometer. The particle beam can be generated, with minimal sample handling, from a naturally occurring aerosol or from a solution of bacteria that can be dispersed as an aerosol. The mass spectrum is generated by successively measuring the average intensities of different mass peaks. The average intensity is obtained by measuring the ion intensity distribution at the particular mass (m/e) for ion pulses from more than 1,000 bacteria particles. Bacillus cereus, Bacillus subtilis, and Pseudomonas putida samples were analyzed to test the capability of the instrument for differentiating among species of bacteria. Significant ion-intensity information was produced over the m/e range of 50 to 300, an improvement over previous pyrolysis-mass spectrometry results. The complex mass spectra contained a few unique peaks which could be used for the differentiation of the bacteria. A statistical analysis of the variations in peak intensities among the three bacteria provided a quantitative measure of the reproducibility of the instrument and its ability to differentiate among bacteria. The technique could lead to a new rapid method for the analysis of microorganisms and could be used for the detection of airborne pathogens on a continuous, real-time basis.
ABSTRACT
Gas phase and particular phase sulfur have been measured at various locations in the Los Angeles basin to determine atmospheric conversion rates and mechanisms. A new technique was developed for the measurement of particulate sulfur. From measurements of the particulate to gas phase sulfur ratio near the major stationary sources and far downstream and from estimates of travel time determined by air trajectory analysis, it is possible to estimate gas-to-particle conversion rates for sulfur. Such calculations show that automobiles presently contribute a major part of the total sulfur as measured at a receptor site such as Pasadena, while contributing only a small amount to the particulate sulfur loading. The introduction of oxidation catalyst-equipped vehicles may add significantly to the particulate sulfur at downwind receptor sites; predictions of particulate sulfur concentrations near freeways show substantial increases due to such vehicles.
Subject(s)
Air Pollution , Sulfur Dioxide , Sulfur , Aerosols , Air/analysis , Air Movements , Air Pollutants , California , Industrial Waste , Particle Size , Photochemistry , Sulfur/analysis , Vehicle EmissionsABSTRACT
Measurements were made of exchange rates of oxygen, carbon dioxide, and krypton-85 with blood at 37.5 degrees C. Gas transfer took place across a 1 mil silicone rubber membrane. The blood was in a rotating disk boundary layer flow, and the controlling resistance to transfer was the concentration boundary layer. Measured rates were compared with rates predicted from the equation of convective diffusion using velocities derived from the Navier-Stokes equations and diffusivities calculated from the theory for conduction in a heterogeneous medium. The measured absorption rate of krypton-85 was closely predicted by this model. Significant deposition of material onto the membrane surface, resulting in an increased transfer resistance, occurred in one experiment with blood previously used in a nonmembrane type artificial lung. The desorption rate of oxygen from blood at low P(o2)(1) was up to four times the corresponding transfer rate of inert gas. This effect is described somewhat conservatively by a local equilibrium form of the convective diffusion equation. The carbon dioxide transfer rate in blood near venous conditions was about twice that of inert gas, a rate significantly greater than predicted by the local equilibrium theory. It should be possible to apply these theoretical methods to predict exchange rates with blood flowing in systems of other geometries.
ABSTRACT
The steady-state transport of oxygen through hemoglobin solutions was studied to identify the mechanism of the diffusion augmentation observed at low oxygen tensions. A novel technique employing a platinum-silver oxygen electrode was developed to measure the effective diffusion coefficient of oxygen in steady-state transport. The measurements were made over a wider range of hemoglobin and oxygen concentrations than previously reported. Values of the Brownian motion diffusion coefficient of oxygen in hemoglobin solution were obtained as well as measurements of facilitated transport at low oxygen tensions. Transport rates up to ten times greater than ordinary diffusion rates were found. Predictions of oxygen flux were made assuming that the oxyhemoglobin transport coefficient was equal to the Brownian motion diffusivity which was measured in a separate set of experiments. The close correlation between prediction and experiment indicates that the diffusion of oxyhemoglobin is the mechanism by which steady-state oxygen transport is facilitated.
Subject(s)
Hemoglobins , Oxygen , Chemical Phenomena , Chemistry, Physical , Polarography , SolutionsABSTRACT
Experimental measurements of the diffusion coefficient of human methemoglobin were made at 25 degrees C with a modified Stokes diaphragm diffusion cell. A Millipore filter was used in place of the ordinary fritted disc to facilitate rapid achievement of steady state in the diaphragm. Methemoglobin concentrations varied from approximately 5 g/100 ml to 30 g/100 ml. The diffusion coefficient in this range decreased from 7.5 x 10(-7) cm(2)/sec to 1.6 x 10(-7) cm(2)/sec.