ABSTRACT
Hardfacing is one of the techniques used for part lifecycle elongation. Despite being used for over 100 years, there still is much to discover, as modern metallurgy provides more and more sophisticated alloys, which then have to be studied to find the best technological parameters in order to fully utilize complex material properties. One of the most efficient and versatile hardfacing approaches is Gas Metal Arc Welding technology (GMAW) and its cored-wire equivalent, known as FCAW (Flux-Cored/Cored Arc Welding). In this paper, the authors study the influence of heat input on the geometrical properties and hardness of stringer weld beads fabricated from cored wire consisting of macrocrystalline tungsten carbides in a nickel matrix. The aim is to establish a set of parameters which allow to manufacture wear-resistant overlays with high deposition rates, preserving all possible benefits of this heterogenic material. This study shows, that for a given diameter of the Ni-WC wire, there exists an upper limit of heat input beyond which the tungsten carbide crystals may exhibit undesired segregation at the root.
ABSTRACT
The erosion phenomenon has a significant influence on many metallic materials used in numerous industrial sectors. In this paper, we present the results of an analysis of the influence of abrasive impact erosion on surface and properties of DC03/1.0347, DC04/1.0338, DC05/1.0312, and DD14/1.0389 deep drawing steels. The chemical composition, static tensile tests, hardness tests, drawability tests, erosion tests, microstructure analysis, surface roughness, and hardness of the plates were investigated. The wear mechanisms and wear behavior of the investigated steels were also discussed. The results obtained in this study allowed the assessment of the microstructural changes in deep drawing steels under the influence of intense erosive impact. The obtained results indicate that the erosive impact may cause a significant grain refinement of the microstructure of the surfaces of the investigated materials. Moreover, large amounts of heat released during erosive impact may cause the material phase changes. This research expands the knowledge on specific mechanisms taking place during sandblasting and their influence on the properties of deep drawing steels and their wear behavior.
ABSTRACT
This paper presents the results of the investigations of the properties of saddle-shaped copper alloy chips briquettes produced in a roller press. The physical and mechanical properties of the investigated briquettes were examined on their external surfaces as well as on their cross-sections. The density, chemical composition, microstructure analysis obtained with a 3D and scanning microscope, surface roughness and hardness of the obtained briquettes were investigated. The research proved the differentiation of the physical and mechanical properties of briquettes depending on the investigated area of their surface. The analysis of changes in the porosity of briquettes on their cross-section showed zones of various densification levels. This research expands the knowledge of the processes taking place during the compaction and consolidation of granular materials in roller presses as well as the knowledge concerning designing the geometry of forming tools.
