ABSTRACT
Background: An 8-year-old, 18.9 kg, male, intact Kai Ken with a femoral shaft fracture experienced recurrent implant breakage after two fracture reductions using an internal fixator. Objectives: This case report is aimed at using a three-dimensional (3-D) printer to diagnose residual femoral rotational deviation. Implant failures and malunion occurred after two attempts at synthesis. Thus, a 3-D model was designed for preoperative planning of a third surgery. Methods: To evaluate the alignment in the postoperative state after the second surgery, we removed a broken plate from the affected limb. Subsequently, a computed tomography image produced a bone replica using 3-D printing. The distal fragment was fixed and rotated externally by 42°. In addition to correcting the rotational deformity of the femur, we used an intramedullary pin and two locking plates to stabilize the proximal and distal femoral fracture segments. Results: The bone union was confirmed four months after surgery, and no postoperative complications were observed 11 months after surgery. Conclusion: 3-D printing is a valuable tool that increases the accuracy of presurgical planning.
ABSTRACT
Device-associated infections are serious complications, and their prevention is an issue of considerable importance. Since biofilms are responsible for these refractory infections, effective methods to inhibit biofilm formation are required. In this investigation, stainless steel plates with and without 2-methacryloyloxyethyl phosphorylcholine (MPC) polymer, i.e., poly (MPC-co-n-butyl methacrylate) (PMB) coating, were incubated in a medium containing bacteria. In the course of incubation, half of the specimens received antibiotics. The specimens were stained for nucleic acid and polysaccharides, and then examined with a confocal laser scanning microscope. The numbers of bacteria on the specimen surfaces were evaluated by an ATP assay. On the surfaces of the specimens without PMB coating, the formation of a biofilm enveloping bacteria was confirmed. The addition of antibiotics did not effectively decrease the number of bacteria. On the other hand, on the surfaces of the specimens with PMB coating, no biofilm formation was observed, and the number of bacteria was significantly decreased. The addition of potent antibiotics further decreased the number of bacteria by 1/100 to 1/1000 times. The PMB coating combined with the validated use of antibiotics might provide a method for the simultaneous achievement of biocompatible surfaces of devices and the prevention of device-associated infections.
