Enzymatic hydrolysis of poly(ethyleneterephthalate) used for and analysed by pore modification of track-etched membranes.

The potential of limited enzymatic poly(ethylene terephthalate) (PET) surface hydrolysis for the modification of track-etched (TE) membranes was investigated. Cutinases 1 and 2 from Thermobifida cellulosilytica as well as a fusion protein of cutinase 1 with the polymer binding module from the polyhydroxyalkanoate depolymerase of Alcaligenes faecalis (Thc_Cut1_PBM) were shown to hydrolyse highly crystalline PET TE membranes with a pore diameter of ∼120nm at very narrow size distribution. Furthermore the effects of surface chemistry were investigated by comparison of enzymatic hydrolysis by Thc_Cut1_PBM of "as received" PET TE membranes with two surface functionalized versions towards a "hydrophilic" and a more "hydrophobic" surface. The effects of adsorbed protein and the efficacy of cleaning steps after enzymatic treatment were elucidated by complementary methods for surface analysis and membrane characterization. With the optimized cleaning protocol, all adsorbed protein could be removed from the enzyme-treated membranes and effects of chemical surface functionalization of the PET TE membranes were demonstrated. The highest efficiency of enzymatic surface hydrolysis was observed for the original PET TE membranes, leading to an 0.36% weight loss corresponding to a removal of ∼3nm PET from the entire surface of the porous membrane. This correlates very well with the measured increase of barrier pore diameter by 4nm (a radius reduction? of 2nm), leading to about a two-fold increased water permeability.

Small cause, large effect: Structural characterization of cutinases from Thermobifida cellulosilytica.

We have investigated the structures of two native cutinases from Thermobifida cellulosilytica, namely Thc_Cut1 and Thc_Cut2 as well as of two variants, Thc_Cut2_DM (Thc_Cut2_ Arg29Asn_Ala30Val) and Thc_Cut2_TM (Thc_Cut2_Arg19Ser_Arg29Asn_Ala30Val). The four enzymes showed different activities towards the aliphatic polyester poly(lactic acid) (PLLA). The crystal structures of the four enzymes were successfully solved and in combination with Small Angle X-Ray Scattering (SAXS) the structural features responsible for the selectivity difference were elucidated. Analysis of the crystal structures did not indicate significant conformational differences among the different cutinases. However, the distinctive SAXS scattering data collected from the enzymes in solution indicated a remarkable surface charge difference. The difference in the electrostatic and hydrophobic surface properties could explain potential alternative binding modes of the four cutinases on PLLA explaining their distinct activities. Biotechnol. Bioeng. 2017;114: 2481-2488. © 2017 Wiley Periodicals, Inc.

Enzymatic Degradation of Aromatic and Aliphatic Polyesters by P. pastoris Expressed Cutinase 1 from Thermobifida cellulosilytica.

To study hydrolysis of aromatic and aliphatic polyesters cutinase 1 from Thermobifida cellulosilytica (Thc_Cut1) was expressed in P. pastoris. No significant differences between the expression of native Thc_Cut1 and of two glycosylation site knock out mutants (Thc_Cut1_koAsn and Thc_Cut1_koST) concerning the total extracellular protein concentration and volumetric activity were observed. Hydrolysis of poly(ethylene terephthalate) (PET) was shown for all three enzymes based on quantification of released products by HPLC and similar concentrations of released terephthalic acid (TPA) and mono(2-hydroxyethyl) terephthalate (MHET) were detected for all enzymes. Both tested aliphatic polyesters poly(butylene succinate) (PBS) and poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) were hydrolyzed by Thc_Cut1 and Thc_Cut1_koST, although PBS was hydrolyzed to significantly higher extent than PHBV. These findings were also confirmed via quartz crystal microbalance (QCM) analysis; for PHBV only a small mass change was observed while the mass of PBS thin films decreased by 93% upon enzymatic hydrolysis with Thc_Cut1. Although both enzymes led to similar concentrations of released products upon hydrolysis of PET and PHBV, Thc_Cut1_koST was found to be significantly more active on PBS than the native Thc_Cut1. Hydrolysis of PBS films by Thc_Cut1 and Thc_Cut1_koST was followed by weight loss and scanning electron microscopy (SEM). Within 96 h of hydrolysis up to 92 and 41% of weight loss were detected with Thc_Cut1_koST and Thc_Cut1, respectively. Furthermore, SEM characterization of PBS films clearly showed that enzyme tretment resulted in morphological changes of the film surface.

Ultrasound-enhanced enzymatic hydrolysis of poly(ethylene terephthalate).

The application of ultrasound was found to enhance enzymatic hydrolysis of poly(ethylene terephthalate) (PET). After a short activation phase up to 6.6times increase in the amount of released products was found. PET powder with lower crystallinity of 8% was hydrolyzed faster when compared to PET with 28% crystallinity. Ultrasound activation was found to be around three times more effective on powders vs. films most likely due to a larger surface area accessible to the enzyme.

Enhanced cutinase-catalyzed hydrolysis of polyethylene terephthalate by covalent fusion to hydrophobins.

Cutinases have shown potential for hydrolysis of the recalcitrant synthetic polymer polyethylene terephthalate (PET). We have shown previously that the rate of this hydrolysis can be enhanced by the addition of hydrophobins, small fungal proteins that can alter the physicochemical properties of surfaces. Here we have investigated whether the PET-hydrolyzing activity of a bacterial cutinase from Thermobifida cellulosilytica (Thc_Cut1) would be further enhanced by fusion to one of three Trichoderma hydrophobins, i.e., the class II hydrophobins HFB4 and HFB7 and the pseudo-class I hydrophobin HFB9b. The fusion enzymes exhibited decreased kcat values on soluble substrates (p-nitrophenyl acetate and p-nitrophenyl butyrate) and strongly decreased the hydrophilicity of glass but caused only small changes in the hydrophobicity of PET. When the enzyme was fused to HFB4 or HFB7, the hydrolysis of PET was enhanced >16-fold over the level with the free enzyme, while a mixture of the enzyme and the hydrophobins led only to a 4-fold increase at most. Fusion with the non-class II hydrophobin HFB9b did not increase the rate of hydrolysis over that of the enzyme-hydrophobin mixture, but HFB9b performed best when PET was preincubated with the hydrophobins before enzyme treatment. The pattern of hydrolysis by the fusion enzymes differed from that of Thc_Cut1 as the concentration of the product mono(2-hydroxyethyl) terephthalate relative to that of the main product, terephthalic acid, increased. Small-angle X-ray scattering (SAXS) analysis revealed an increased scattering contrast of the fusion proteins over that of the free proteins, suggesting a change in conformation or enhanced protein aggregation. Our data show that the level of hydrolysis of PET by cutinase can be significantly increased by fusion to hydrophobins. The data further suggest that this likely involves binding of the hydrophobins to the cutinase and changes in the conformation of its active center.