The forest, the cicadas and the holey fluxes: Periodical cicada impacts on soil respiration depends on tree mycorrhizal type.

The emergence of billions of periodical cicadas affects plant and animal communities profoundly, yet little is known about cicada impacts on soil carbon fluxes. We investigated the effects of Brood X cicadas (Magicicada septendecim, M. cassinii and M. septendeculain) on soil CO2 fluxes (RS ) in three Indiana forests. We hypothesized RS would be sensitive to emergence hole density, with the greatest effects occurring in soils with the lowest ambient fluxes. In support of our hypothesis, RS increased with increasing hole density and greater effects were observed near AM-associating trees (which expressed lower ambient fluxes) than near EcM-associating trees. Additionally, RS from emergence holes increased the temperature sensitivity (Q10 ) of RS by 13%, elevating the Q10 of ecosystem respiration. Brood X cicadas increased annual RS by ca. 2.5%, translating to an additional 717 Gg of CO2 across forested areas. As such, periodical cicadas can have substantial effects on soil processes and biogeochemistry.

HONO Measurement by Catalytic Conversion to NO on Nafion Surfaces.

A selective catalytic converter has been developed to quantify nitrous acid (HONO), a photochemical precursor to NO and OH radicals that drives the formation of ozone and other pollutants in the troposphere. The converter is made from a sulfonated tetrafluoroethylene-based fluoropolymer-copolymer (Nafion) that was found to convert HONO to NO with unity yield under specific conditions. When coupled to a commercially available NOx (=NO + NO2) chemiluminescence (CL) analyzer, the system measures HONO with a limit of detection as low as 64 parts-per-trillion (ppt) (1 min average) in addition to NOx. The converter is selective for HONO when tested against other common gas-phase reactive nitrogen species, although loss of O3 on Nafion is a potential interference. The sensitivity and selectivity of this method allow for accurate measurement of atmospherically relevant concentrations of HONO. This was demonstrated by good agreement between HONO measurements made with the Nafion-CL method and those made with chemical ionization mass spectrometry in a simulation chamber and in indoor air. The observed reactivity of HONO on Nafion also has significant implications for the accuracy of CL NOx analyzers that use Nafion to remove water from sampling lines.

Surface Charge Measurements with Scanning Ion Conductance Microscopy Provide Insights into Nitrous Acid Speciation at the Kaolin Mineral-Air Interface.

Unique surface properties of aluminosilicate clay minerals arise from anisotropic distribution of surface charge across their layered structures. Yet, a molecular-level understanding of clay mineral surfaces has been hampered by the lack of analytical techniques capable of measuring surface charges at the nanoscale. This is important for understanding the reactivity, colloidal stability, and ion-exchange capacity properties of clay minerals, which constitute a major fraction of global soils. In this work, scanning ion conductance microscopy (SICM) is used for the first time to visualize the surface charge and topography of dickite, a well-ordered member of the kaolin subgroup of clay minerals. Dickite displayed a pH-independent negative charge on basal surfaces whereas the positive charge on edges increased from pH 6 to 3. Surface charges responded to malonate addition, which promoted dissolution/precipitation reactions. Results from SICM were used to interpret heterogeneous reactivity studies showing that gas-phase nitrous acid (HONO) is released from the protonation of nitrite at Al-OH2+ groups on dickite edges at pH well above the aqueous pKa of HONO. This study provides nanoscale insights into mineral surface processes that affect environmental processes on the local and global scale.

Nitrous acid formation on Zea mays leaves by heterogeneous reaction of nitrogen dioxide in the laboratory.

Nitrous acid (HONO) is of considerable interest because it is an important precursor of hydroxyl radicals (OH), a key species in atmospheric chemistry. HONO sources are still not well understood, and air quality models fail to predict OH as well as HONO mixing ratios. As there is little knowledge about the potential contribution of plant surfaces to HONO emission, this laboratory work investigated HONO formation by heterogeneous reaction of NO2 on Zea mays. Experiments were carried out in a flow tube reactor; HONO, NO2 and NO were measured online with a Long Path Absorption Photometer (LOPAP) and a NOx analyzer. Tests were performed on leaves under different conditions of relative humidity (5-58%), NO2 mixing ratio representing suburban to urban areas (10-80 ppbv), spectral irradiance (0-20 W m-2) and temperature (288-313 K). Additional tests on plant wax extracts from Zea mays leaves showed that this component can contribute to the observed HONO formation. Temperature and NO2 mixing ratios were the two environmental parameters that showed substantially increased HONO emissions from Zea mays leaves. The highest HONO emission rates on Zea mays leaves were observed at 313 K for 40 ppbv of NO2 and 40% RH and reached values of (5.6 ± 0.8) × 109 molecules cm-2 s-1. Assuming a mixing layer of 300 m, the HONO flux from Zea mays leaves was estimated to be 171 ± 23 pptv h-1 during summertime, which is comparable to what has been reported for soil surfaces.

The impact of photocatalytic paint porosity on indoor NOx and HONO levels.

Photocatalytic materials are a potentially effective remediation technology for indoor air purification. In this paper, we assess the impact of photocatalytic paint porosity on the indoor levels of nitrogen oxides (NOx) and nitrous acid (HONO). We observed that the porosity of photocatalytic paints plays a paramount role in the NO2 removal. The increase of pigment volume concentration (PVC), i.e. porosity, from PVC 53% to PVC 80% leads to an increase of the geometric NO2 uptake coefficient from (3.3 ± 0.5) × 10-6 to (3.2 ± 0.1) × 10-4. At the same time, a high quantity of HONO formed by NO2 conversion on the photocatalytic paint is emitted into the air. The formation of HONO, which is considered as a harmful compound and a major player in the oxidative capacity of indoor air, is reduced as the paint porosity increases. Based on these results, further optimization should be considered for future commercialization of photocatalytic paints aimed for indoor applications.

Assessing indoor gas phase oxidation capacity through real-time measurements of HONO and NOx in Guangzhou, China.

The hydroxyl radical (OH) is one of the most important oxidants controlling the oxidation capacity of the indoor atmosphere. One of the main OH sources indoors is the photolysis of nitrous acid (HONO). In this study, real-time measurements of HONO, nitrogen oxides (NOx) and ozone (O3) in an indoor environment in Guangzhou, China, were performed under two different conditions: (1) in the absence of any human activity and (2) in the presence of cooking. The maximum NOx and HONO levels drastically increased from 15 and 4 ppb in the absence of human activity to 135 and 40 ppb during the cooking event, respectively. The photon flux was determined for the sunlit room, which has a closed south-east oriented window. The photon flux was used to estimate the photolysis rate constants of NO2, J(NO2), and HONO, J(HONO), which span the range between 8 × 10-5 and 1.5 × 10-5 s-1 in the morning from 9:30 to 11:45, and 8.5 × 10-4 and 1.5 × 10-4 s-1 at noon, respectively. The OH concentrations calculated by photostationary state (PSS) approach, observed around noon, are very similar, i.e., 2.4 × 106 and 3.1 × 106 cm-3 in the absence of human activity and during cooking, respectively. These results suggest that under "high NOx" conditions (NOx higher than a few ppb) and with direct sunlight in the room, the NOx and HONO chemistry would be similar, independent of the geographic location of the indoor environment, which facilitates future modeling studies focused on indoor gas phase oxidation capacity.

Unexpectedly High Levels of Organic Compounds Released by Indoor Photocatalytic Paints.

Photocatalytic paints based on titanium dioxide (TiO2) nanoparticles represent a promising treatment technology for cleaning the air at our dwellings. A few studies have shown that instead of elimination of harmful indoor air pollutants the production of carbonyl compounds occurs from the photocatalytic paints. Herein, we report unexpectedly high concentrations of volatile organic compounds (VOCs) released upon irradiation of photocatalytic paints which are meant to clean the air at our dwellings. The concentrations of the VOCs were measured continuously and online by PTR-ToF-MS (Proton Transfer Reaction-Time of Flight-Mass Spectrometry) connected to a well-established flow tube photoreactor. The PTR-ToF-MS analysis revealed the presence of 52 ions in the mass range between 20 and 490 amu, among which 43 have been identified. In particular very high emission rates were estimated of two relevant indoor air pollutants, formaldehyde and acetaldehyde as 355 µg h-1 and 257 µg h-1 for 1 m2, respectively. We suggest a detailed reaction mechanism responsible for the production of these harmful indoor air pollutants (formaldehyde and acetaldehyde, among the others). The hydroxyl radicals (OH) formed upon activation of TiO2, react with the organic constituent (butyl acrylate and vinyl acetate) of the paint binder lead to generation of an important number of organic compounds. We demonstrate that the TiO2 quantity and the organic content of the binder is of paramount importance with respect to the formation of VOCs, which should be considered for future optimization of this air remediation technology based on TiO2 nanoparticles.

Development of an analytical methodology for obtaining quantitative mass concentrations from LAAP-ToF-MS measurements.

Laser ablation aerosol particle-time of flight mass spectrometer (LAAP-ToF-MS) measures the size number of particles, and chemical composition of individual particles in real-time. LAAP-ToF-MS measurements of chemical composition are difficult to quantify, mostly because the instrument sensitivities to various chemical species in the multicomponent atmospheric aerosol particles are unknown. In this study, we investigate a field-based approach for quantitative measurements of ammonium, nitrate, sulfate, OC, and EC, in size-segregated atmospheric aerosols, by LAAP-ToF-MS using concurrent measurements from high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS), and multi-angle absorption photometer (MAAP). An optical particle counter (OPC) and a high-resolution nanoparticle sizer (scanning mobility particle sizer, or SMPS), were used to measure the particle size distributions of the particles in order to correct the number concentrations. The intercomparison reveals that the degree of agreement of the mass concentrations of each compound measured with LAAP-ToF-MS and HR-ToF-AMS/MAAP increases in the following order NH4+ < SO42- < NO3- < EC < OC < Cl- with r2 values in the range of 0.4-0.95 and linear regression slopes ranging between 0.62 and 1.2. The factors that affect the mass concentrations measured by LAAP-ToF-MS are also discussed in details. Yet, the matrix effect remains one of the strongest limiting factor to achieve an absolute quantification of the aerosol chemical composition. In the future we suggest the development of a methodology based on the calculation of the response factors generated by different types of particles, which could possibly resolve certain difficulties associated with the matrix effect.

Formation of indoor nitrous acid (HONO) by light-induced NO2 heterogeneous reactions with white wall paint.

Gaseous nitrogen dioxide (NO2) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO2 levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO2 with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO2 with selected indoor paint surfaces in the presence of light (300 nm<λ<400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m(-2)), an increase of HONO production rate of up to 8.6·10(9) molecules cm(-2) s(-1) was observed at [NO2]=60 ppb and 50% relative humidity (RH). At higher light intensity of 10.6 (W m(-2)), the HONO production rate increased to 2.1·10(10) molecules cm(-2) s(-1). A high NO2 to HONO conversion yield of up to 84% was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO2 heterogeneous reactions.