Subject(s)
COVID-19 , Conjunctivitis , Conjunctivitis/diagnosis , Conjunctivitis/epidemiology , Humans , Incidence , Pandemics , Public HealthABSTRACT
PURPOSE: To compare the incidence of flap complications after creation of laser in situ keratomileusis (LASIK) flaps using a zero-compression microkeratome or a femtosecond laser. SETTING: John A. Moran Eye Center, Department of Ophthalmology, University of Utah, Salt Lake City, Utah, USA. DESIGN: Evidence-based manuscript. METHODS: The flap complication rate was evaluated during the initial 18 months of experience using a zero-compression microkeratome (Hansatome) or a femtosecond laser (IntraLase FS60) for flap creation. RESULTS: The flap complication rate was 14.2% in the microkeratome group and 15.2% in the femtosecond laser group (P = .5437). The intraoperative flap complication rate was 5.3% and 2.9%, respectively (P = .0111), and the postoperative flap complication rate, 8.9% and 12.3%, respectively (P = .0201). The most common intraoperative complication in the microkeratome group was major epithelial defect/sloughing; the rate (2.6%) was statistically significantly higher than in the femtosecond laser group (P = .0006). The most common postoperative complication in both groups was diffuse lamellar keratitis (DLK) (6.0%, microkeratome; 10.6%, femtosecond laser) (P = .0002). CONCLUSION: Although the total complication rates between the 2 groups were similar, the microkeratome group had significantly more epithelial defects intraoperatively and the femtosecond laser group had significantly more DLK cases postoperatively.
Subject(s)
Corneal Stroma/pathology , Intraoperative Complications , Keratomileusis, Laser In Situ/instrumentation , Postoperative Complications , Surgical Flaps/adverse effects , Adult , Aged , Female , Follow-Up Studies , Humans , Incidence , Lasers, Excimer/therapeutic use , Male , Middle Aged , Retrospective Studies , Young AdultABSTRACT
Accurate modeling of heat dissipation in pediatric intracorporeal devices is crucial in avoiding tissue and blood thermotrauma. Thermal models of new Maglev ventricular assist device (VAD) concepts for the PediaFlow VAD are developed by incorporating empirical heat transfer equations with thermal finite element analysis (FEA). The models assume three main sources of waste heat generation: copper motor windings, active magnetic thrust bearing windings, and eddy currents generated within the titanium housing due to the two-pole motor. Waste heat leaves the pump by convection into blood passing through the pump and conduction through surrounding tissue. Coefficients of convection are calculated and assigned locally along fluid path surfaces of the three-dimensional pump housing model. FEA thermal analysis yields a three-dimensional temperature distribution for each of the three candidate pump models. Thermal impedances from the motor and thrust bearing windings to tissue and blood contacting surfaces are estimated based on maximum temperature rise at respective surfaces. A new updated model for the chosen pump topology is created incorporating computational fluid dynamics with empirical fluid and heat transfer equations. This model represents the final geometry of the first generation prototype, incorporates eddy current heating, and has 60 discrete convection regions. Thermal analysis is performed at nominal and maximum flow rates, and temperature distributions are plotted. Results suggest that the pump will not exceed a temperature rise of 2 degrees C during normal operation.
