Binocular vision alterations after refractive and cataract surgery: a review.

To review binocular and accommodative disorders documented after corneal or intraocular refractive surgery, in normal healthy prepresbyopic patients. A bibliographic revision was performed; it included works published before 1st July 2017 where accommodation and/or binocularity was assessed following any type of refractive surgical procedure. The search in Pubmed yielded 1273 papers, 95 of which fulfilled the inclusion criteria. Few publications reporting binocular vision and/or accommodative changes after refractive surgery in normal subjects were found. The reduction in fusional vergence is the most frequently reported alteration. Anisometropia is an important risk factor for postoperative binocular vision-related complaints. Most diplopia-related visual complaints, irrespective of the surgical procedure, were in fact misdiagnosed preoperative disorders. The preoperative evaluation of patients seeking spectacle/contact lens independence should include a complete binocular and accommodation assessment where parameters such as the phoric posture, accommodative amplitude and facility, near point of convergence, fusional reserves and accommodative convergence/accommodation coefficient are measured. This would allow the identification of risk factors that could compromise the success of the refractive surgery and cause clinical symptoms.

Cell pattern in adult human corneal endothelium.

A review of the current data on the cell density of normal adult human endothelial cells was carried out in order to establish some common parameters appearing in the different considered populations. From the analysis of cell growth patterns, it is inferred that the cell aging rate is similar for each of the different considered populations. Also, the morphology, the cell distribution and the tendency to hexagonallity are studied. The results are consistent with the hypothesis that this phenomenon is analogous with cell behavior in other structures such as dry foams and grains in polycrystalline materials. Therefore, its driving force may be controlled by the surface tension and the mobility of the boundaries.