Towards eliminating friction and wear in plain bearings operating without lubrication.

Plain bearings, renowned for their versatility and simplicity, are extensively utilized in engineering design across various industries involving moving parts. Lubrication is vital to the functioning of these bearings, yet their usage is inhibited under dynamic load conditions, or at elevated or reduced temperatures due to this dependency on lubrication. This study introduces an innovative method to significantly mitigate friction and wear in plain bearings operating without lubrication. The plain bearings were constructed from steel-bronze pairs, where the steel shafts were alloyed with bismuth oxide via short-pulse laser treatment. MnO2 was utilized as a carrier to incorporate the bismuth oxide into the surface layers of the steel. Insights from transmission electron microscopy and X-ray photoelectron spectroscopy revealed a highly non-equilibrium state of matter, unattainable through conventional engineering methods. The tribological performance of the modified steel disks was assessed via a block-on-ring sliding test, demonstrating superior wear and friction performance without lubrication, as well as an ultra-low coefficient of friction. Remarkably, the modified friction pairs remained functional after 200 km of linear sliding at a load of 250 N (12.5 MPa) and a sliding speed of 9 m/s. To substantiate the technique's viability, we tested the performance of an internal combustion engine turbocharger fitted with a modified steel shaft. The turbocharger's performance validated the long-term effectiveness of the steel-bronze coupling operating without lubrication at 75,000 rpm. The simplicity and resilience of this technique for modifying steel-bronze pairs offer a ground-breaking and promising approach for a wide range of applications.

The change of the LMM auger spectra in 3d-metals due to oxidation and its correlation with the change of the atomic magnetic moment.

The surfaces of crystalline samples of 3d-metals (Mn, Fe, Co, Ni, and Cu) and their stoichiometric oxides have been studied by Auger spectroscopy. A correlation between the change in the LVV (L-inner level-valence-valence electron transition) Auger intensities and the change of the squares of the corresponding atomic-magnetic moments has been observed. This is because of the complicated nature of the Auger process. That is, the Auger electron emission is a result of the inner atomic level excitation by electron impact and Auger annihilation of the inner-level hole. Therefore, the Auger process has been considered a second-order process, and spin polarization of the valence states has been taken into account for the LMM (L-inner level-M-inner level-M-inner level electron transition) Auger spectra of 3d-metals.