Nanostructure, osteopontin, and mechanical properties of calcitic avian eggshell.

Avian (and formerly dinosaur) eggshells form a hard, protective biomineralized chamber for embryonic growth-an evolutionary strategy that has existed for hundreds of millions of years. We show in the calcitic chicken eggshell how the mineral and organic phases organize hierarchically across different length scales and how variation in nanostructure across the shell thickness modifies its hardness, elastic modulus, and dissolution properties. We also show that the nanostructure changes during egg incubation, weakening the shell for chick hatching. Nanostructure and increased hardness were reproduced in synthetic calcite crystals grown in the presence of the prominent eggshell protein osteopontin. These results demonstrate the contribution of nanostructure to avian eggshell formation, mechanical properties, and dissolution.

Microstructure and Mechanical Properties of Ti Cold-Spray Splats Determined by Electron Channeling Contrast Imaging and Nanoindentation Mapping.

Cold spray is a thermo-mechanical process where the velocity of the sprayed particles affects the deformation, bonding, and mechanical properties of the deposited material, in the form of splats or coatings. At high strain rates, the impact stresses are converted into heat, a phenomenon known as adiabatic shear, which leads to grain re-crystallization. Grain re-crystallization and growth are shown to have a direct impact on the mechanical properties of the cold-sprayed material. The present study ties the microstructural features within the cold-sprayed Ti splats and the substrate to the bonding mechanism and mechanical properties. High-resolution electron channeling contrast imaging, electron backscatter diffraction mapping, and nanoindentation were used to correlate the microstructure to the mechanical properties distribution within the titanium cold-spray splats. The formation of nanograins was observed at the titanium splat/substrate interface and contributed to metallurgical bonding. An increase in grain re-crystallization within the splat and substrate materials was observed with pre-heating of the substrate. In the substrate material, the predominant mechanism of deformation was twinning. A good relationship was found between the hardness and distribution of the twins within the substrate and the size distribution of the re-crystallized grains within the splats.

Electron channeling contrast imaging of plastic deformation induced by indentation in polycrystalline nickel.

Vickers microindentation and Berkovich nanoindentation tests were carried out on a polycrystalline nickel (Ni) bulk specimen. Electron channeling contrast imaging (ECCI) in conjunction with electron backscattered diffraction was used to image and characterize plastic deformation inside and around the indents using a field emission scanning electron microscope. The ECCI was performed with a 5 keV beam energy and 0° tilt specimen position. The strain field distribution, slip lines, and Taylor lattices were imaged on an indented surface. Orientation mapping was used to investigate the local crystallographic misorientation and identify specific ⟨110⟩ slip systems. An ion milling surface preparation technique was used to remove materials from the surface which permitted the study of deformed microstructure below the indent. A dislocation density of 1011 cm-2 was calculated based on the curvature of bend contours observed in the ECCI micrographs obtained from the Vickers indents. A yield strength of 500 MPa was calculated based on the size of the strain field measured from the ECCI micrographs of the nanoindents. The combination of ion milling, ECCI, and electron backscattered diffraction was shown to be beneficial to investigate the indentation-induced plastic deformation in a polycrystalline Ni bulk specimen.