Raman spectroscopy coupled to high-resolution continuum source flame molecular absorption spectrometry for sequential determination of nitrogen species in fertilizers.

Raman spectroscopy (RS) was used to identify and quantify different nitrogen species in fertilizers. This is a fast and inexpensive method that requires no extensive sample preparation. Urea and nitrate were determined at 1000 and 1045 cm-1, respectively. Calibration plots obtained for these analytes showed adequate linearity, with regression coefficients (r) of 0.9989 and 0.9976, respectively. Ammonium was determined by difference after total N determination by high-resolution continuum source flame molecular absorption spectrometry (HR-CS FMAS), which provided a calibration plot with r = 0.9960. The inline coupling of RS and HR-CS FMAS allowed for a fast sequential determination of ammonium, nitrate, and urea, with limits of detection of 0.03 mg/L ammonium, 0.03 mg/L nitrate, and 0.01 mg/L urea. Relative standard deviations were ≤ 11 %, and the external standard calibration method provided accurate results for all analytes determined in certified reference materials, raw materials, and commercial samples of fertilizers. For comparison purposes, all samples were also analyzed by traditional Kjeldahl method. The RS HR-CS FMAS method was further validated by addition and recovery experiments, which provided recoveries in the 93 - 113 % range.

Simultaneous determination of phosphite and phosphate in fertilizers by Raman spectroscopy.

Raman spectroscopy is emerging and powerful technique for identifying oxyanions of phosphorus, but it still is not straightforward applied to identify and quantify simultaneously phosphite and phosphate species in solution. Herein, simultaneous determination of phosphate (PO4) and phosphite (PO3) in fertilizer were evaluated by Raman spectroscopy. The influence of pH on Raman spectra of species was evaluated at various solution pH values, and the results showed accurate and selective analysis for phosphate and phosphite by using pH = 10.0 and bands located at 874 cm-1 and 2321 cm-1, respectively. Linear working range in the 0.15%-6.20% (w/v) P concentration was consistently obtained with regression coefficients (r) of 0.9953 (PO4) and 0.9945 (PO3). The limits of detection were 0.10% (w/v) P (PO4) and 0.05% (w/v) P (PO3). Relative standard deviations were lower than 6% for samples containing 10% P2O5 (PO4) and 31% P2O5 (PO3). Commercial fertilizers were analyzed by the proposed method using external calibration and found concentrations of P were in agreement with those obtained by the comparative spectrophotometric method at the 95% confidence level (paired t-test). Recoveries of spiked samples were in the 92-110% range.

Silver(I) complexes of 3-methoxy-4-hydroxybenzaldehyde thiosemicarbazones and triphenylphosphine: structural, cytotoxicity, and apoptotic studies.

Novel silver(i) complexes of the type [AgCl(PPh3)2(L)] {PPh3 = triphenylphosphine; L = VTSC = 3-methoxy-4-hydroxybenzaldehyde thiosemicarbazone (1); VMTSC = 3-methoxy-4-[2-(morpholine-1-yl)ethoxy]benzaldehyde thiosemicarbazone (2); VPTSC = 3-methoxy-4-[2-(piperidine-1-yl)ethoxy]benzaldehyde thiosemicarbazone (3)} were synthesized and fully characterized by spectroscopic techniques. The molecular structures of complexes 2 and 3 were determined by single crystal X-ray diffraction. Compounds 1-3 exhibited appreciable cytotoxic activity against human tumor cells (lung A549, breast MDA-MB-231 and MCF-7) with IC50 values in 48 h of incubation ranging from 5.6 to 18 µM. Cellular uptake studies showed that complexes 1-3 were efficiently internalized after 3 hours of treatment in MDA-MB-231 cells. The effects of complex 1 on the cell morphology, cell cycle, induction of apoptosis, mitochondrial membrane potential (Δψm), and reactive oxygen species (ROS) production have been evaluated in triple negative breast cancer (TNBC) cells MDA-MB-231. Our results showed that complex 1 induced typical morphological alterations of cell death, an increase in cells at the sub-G1 phase, apoptosis, and mitochondrial membrane depolarization. Furthermore, DNA binding studies evidenced that 1 can bind to ct-DNA and does so without modifying the B-structure of the DNA, but that the binding is weak compared to that of Hoechst 33258.

Cytotoxic and apoptotic effects of ternary silver(i) complexes bearing 2-formylpyridine thiosemicarbazones and 1,10-phenanthroline.

New silver(i) compounds containing 2-formylpyridine-N(4)-R-thiosemicarbazones and 1,10-phenanthroline (phen) were synthesized and characterized by spectroscopic techniques (IR and NMR), elemental analysis, ESI-MS and molar conductance measurements. In these complexes, both phen and thiosemicarbazone ligands are coordinated in a chelating bidentate fashion. Compounds 1-3 not only showed good in vitro antiproliferative activity against human lung (A549) and breast tumor cells (MDA-MB-231 and MCF-7), with IC50 values ranging from 1.49 to 20.90 µM, but were also demonstrated to be less toxic towards human breast non-tumor cells (MCF-10A). Cellular uptake studies indicated that compounds 1-3 were taken up by the MDA-MB-231 cells in 6 hours. Cell death assays in the MDA-MB-231 cells were conducted with compound 1 aiming to evaluate its effects on cell morphology, induction of apoptosis, the cell cycle, reactive oxygen species (ROS) formation and mitochondrial membrane potential (Δψm). Compound 1 caused morphological changes, such as cell shrinkage and rounding, increased the sub-G1 phase population, and induced apoptotic cell death, ROS formation and loss of mitochondrial membrane potential (Δψm). DNA binding results revealed that 1 interacted with the ct-DNA minor groove. Complexes 1-3 also exhibited good in vitro activity against M. tuberculosis H37Rv, with MIC values ranging from 3.37 to 4.65 µM.

Multi-energy calibration applied to atomic spectrometry.

Multi-energy calibration (MEC) is a novel strategy that explores the capacity of several analytes of generating analytical signals at many different wavelengths (transition energies). Contrasting with traditional methods, which employ a fixed transition energy and different analyte concentrations to build a calibration plot, MEC uses a fixed analyte concentration and multiple transition energies for calibration. Only two calibration solutions are required in combination with the MEC method. Solution 1 is composed of 50% v v-1 sample and 50% v v-1 of a standard solution containing the analytes. Solution 2 has 50% v v-1 sample and 50% v v-1 blank. Calibration is performed by running each solution separately and monitoring the instrument response at several wavelengths for each analyte. Analytical signals from solutions 1 and 2 are plotted on the x-axis and y-axis, respectively, and the analyte concentration in the sample is calculated from the slope of the resulting calibration curve. The method has been applied to three different atomic spectrometric techniques (ICP OES, MIP OES and HR-CS FAAS). Six analytes were determined in complex samples (e.g. green tea, cola soft drink, cough medicine, soy sauce, and red wine), and the results were comparable with, and in several cases more accurate than, values obtained using the traditional external calibration, internal standardization, and standard additions methods. MEC is a simple, fast and efficient matrix-matching calibration method. It may be applied to any technique capable of simultaneous or fast sequential monitoring of multiple analytical signals.

Bismuth as a general internal standard for lead in atomic absorption spectrometry.

Bismuth was evaluated as internal standard for Pb determination by line source flame atomic absorption spectrometry (LS FAAS), high-resolution continuum source flame atomic absorption spectrometry (HR-CS FAAS) and line source graphite furnace atomic absorption spectrometry (LS GFAAS). Analysis of samples containing different matrices indicated close relationship between Pb and Bi absorbances. Correlation coefficients of calibration curves built up by plotting A(Pb)/A(Bi)versus Pb concentration were higher than 0.9953 (FAAS) and higher than 0.9993 (GFAAS). Recoveries of Pb improved from 52-118% (without IS) to 97-109% (IS, LS FAAS); 74-231% (without IS) to 96-109% (IS, HR-CS FAAS); and 36-125% (without IS) to 96-110% (IS, LS GFAAS). The relative standard deviations (n=12) were reduced from 0.6-9.2% (without IS) to 0.3-4.3% (IS, LS FAAS); 0.7-7.7% (without IS) to 0.1-4.0% (IS, HR-CS FAAS); and 2.1-13% (without IS) to 0.4-5.9% (IS, LS GFAAS).

Determination of lead in medicinal plants by high-resolution continuum source graphite furnace atomic absorption spectrometry using direct solid sampling.

A procedure is proposed for Pb determination in medicinal plants by high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GF AAS) using direct solid sampling. Among Pd(NO(3))(2), Pd/Mg(NO(3))(2), NH(4)H(2)PO(4) and the W-coated platform tested as chemical modifiers, Pd(NO(3))(2) presented the best performance. Calibration plots (10-1000 pg Pb) with regression coefficients better than 0.999 were typically obtained. Accuracy was checked for Pb determination in five plant certified reference materials. Results were in agreement with reference values at a 95% confidence level (paired t-test). Medicinal plant samples were analyzed by the proposed procedure and line-source GF AAS using slurry sampling as a comparative technique. The RSD was 10% (n=3) for a sample containing 0.88 µg g(-1) Pb. The limit of quantification (dry mass) was 0.024 µg g(-1). The contents of Pb in medicinal plant samples varied in the 0.30-1.94 µg g(-1) range.

Determination of total sulfur in agricultural samples by high-resolution continuum source flame molecular absorption spectrometry.

The usefulness of molecular absorption was investigated for the determination of total sulfur (S) in agricultural samples by high-resolution continuum source flame molecular absorption spectrometry. The lines for CS at 257.595, 257.958, and 258.056 nm and for SH at 323.658, 324.064, and 327.990 nm were evaluated. Figures of merit, such as linear dynamic range, sensitivity, linear correlation, characteristic concentration, limit of detection, and precision, were established. For selected CS lines, wavelength-integrated absorbance equivalent to 3 pixels, analytical curves in the 100-2500 mg L(-1) (257.595 nm), 250-2000 mg L(-1) (257.958 nm), and 250-5000 mg L(-1) (258.056 nm) ranges with a linear correlation coefficient better than 0.9980 were obtained. Results were in agreement at a 95% confidence level (paired t test) with those obtained by gravimetry. Recoveries of S in fungicide and fertilizer samples were within the 84-109% range, and the relative standard deviation (n=12) was typically <5%.