ABSTRACT
PURPOSE: To evaluate the effects of indocyanine green (ICG) injection on the retinal surface and into the subretinal space of rabbit eyes. METHODS: Twenty-two Dutch-belted rabbits underwent two-port vitrectomy followed by injection of ICG (5 mg/mL) on the retinal surface and into the subretinal space. Balanced salt solution (BSS) was also injected subretinally. The locations where ICG was delivered (both epiretinal and subretinal) were exposed to light from an endoilluminator for 7 minutes. The animals were examined at 1, 7, and 14 days after surgery. The eyes were studied by fluorescein angiography as well as light and electron microscopy. RESULTS: No damage was observed after epiretinal ICG injection, but subretinal ICG injection resulted in damage to the outer nuclear layer, photoreceptor inner and outer segments, and retinal pigment epithelium. This damage was more severe with longer follow-up. Control experiments without ICG, in which balanced salt solution was injected into the subretinal space or light was delivered on the epiretinal surface, demonstrated only damage to the photoreceptor outer segments. CONCLUSION: Subretinal delivery of ICG (5 mg/mL) in rabbits induces retinal pigment epithelium, photoreceptor inner and outer segment, and outer nuclear layer damage. These mechanisms of damage may explain the retinal pigment epithelium changes that are sometimes seen after ICG-assisted internal limiting membrane peeling in humans.
Subject(s)
Coloring Agents/toxicity , Extracellular Space/drug effects , Indocyanine Green/toxicity , Retina/drug effects , Animals , Fluorescein Angiography , Injections , Neuroglia/drug effects , Neuroglia/ultrastructure , Photoreceptor Cells, Vertebrate/drug effects , Photoreceptor Cells, Vertebrate/ultrastructure , Pigment Epithelium of Eye/drug effects , Pigment Epithelium of Eye/ultrastructure , Rabbits , Retina/ultrastructure , VitrectomyABSTRACT
BACKGROUND AND OBJECTIVE: To study the heat and power dissipation effect of anintraocular electronic heater on the retina. The determination of thermal parameters that are nonharmful to the retina will aid in the development of an implantable intraocular electronic retinal prosthesis. MATERIALS AND METHODS: In dogs, five different retinal areas were touched with a custom intraocular heater probe (1.4 x 1.4 x 1.0 mm) for 1 second while the heater dissipated 0 (control), 10, 20, 50, or 100 mW. In a second protocol, the heater was mechanically held in the vitreous cavity while dissipating 500 mW for 2 hours while monitoring intraocular temperature. The animals were observed for 4 weeks with serial fundus photography and electroretinography. The procedure was then repeated in the fellow eye. The dogs were killed and both eyes were enucleated and submitted for histology. RESULTS: In experiments using protocol 1, heater settings of 50 mW or higher caused an immediate visible whitening of the retinal tissue. Histologically, this damage was evident only if the eyeswere immediately enucleated. Permanent damage was caused by heater settings of 100 mW or higher. Under protocol 2, no ophthalmologic, electroretinography, or histologic differences were noted between the groups. Temperature increases of 5 degrees C in the vitreous and 2 degrees C near the retina were noted. CONCLUSIONS: The liquid environment of the eye acts as a heat sink that is capable of dissipating a significant amount of power. An electronic chip positioned away from the retina can run at considerably higher powers than a chip positioned on the retinal surface.
