Erratum: Droplet pattern and condensation gradient around a humidity sink [Phys. Rev. E 89, 012402 (2014)].

This corrects the article DOI: 10.1103/PhysRevE.89.012402.

Dew condensation on desert beetle skin.

Some tenebrionind beetles inhabiting the Namib desert are known for using their body to collect water droplets from wind-blown fogs. We aim to determine whether dew water collection is also possible for desert insects. For this purpose, we investigated the infra-red emissivity, and the wetting and structural properties, of the surface of the elytra of a preserved specimen of Physasterna cribripes (Tenebrionidæ) beetle, where the macro-structure appears as a series of "bumps", with "valleys" between them. Dew formation experiments were carried out in a condensation chamber. The surface properties (infra-red emissivity, wetting properties) were dominated by the wax at the elytra surface and, to a lower extent, its micro-structure. We performed scanning electron microscope on histological sections and determined the infra-red emissivity using a scanning pyrometer. The emissivity measured (0.95±0.07 between 8-14 µm) was close to the black body value. Dew formation occurred on the insect's elytra, which can be explained by these surface properties. From the surface coverage of the condensed drops it was found that dew forms primarily in the valleys between the bumps. The difference in droplet nucleation rate between bumps and valleys can be attributed to the hexagonal microstructure on the surface of the valleys, whereas the surface of the bumps is smooth. The drops can slide when they reach a critical size, and be collected at the insect's mouth.

Droplet pattern and condensation gradient around a humidity sink.

We describe the evolution of a water drop saturated with NaCl and the growth of pure water droplets in a breath figure pattern (BF) condensing around it. This salty drop acts as a humidity sink, inhibiting the BF inside a ring at a distance r=δ from the sink center and slowing down BF growth outside the ring. The initial salty drop is taken either from a salt-saturated solution (type I experiment) or by placing an NaCl crystal on the substrate (type II experiment). The results are similar, provided that the initial time for type II evolution is taken at the end of the crystal dissolution. The evolution of the salty drop radius R is deduced from the establishment of a three-dimensional hyperbolic concentration profile around the salty drop. This profile scales with r/δ. Accounting for the salt concentration decrease with salty drop growth, R is seen to grow as t5. In the region r>δ, water droplets nucleate and grow. The rate of evolution of the water droplets at constant r/δ can be used to determine the local water pressure. The corresponding data reasonably agree with a hyperbolic water vapor profile around the salty drop. These results can be applied to the growth of BF patterns to determine whether hyperbolic or linear water vapor profiles apply.

Breath figures of two immiscible substances on a repellent surface.

The understanding of the competition between different substances while condensing on a cold surface is of high interest in situations in which it is desirable to control their condensation rates and the formed morphologies. We do the experiments for mixtures of water and hexamethyldisiloxane vapors at several concentrations. The dropwise condensation of the vapors forms breath figures on a substrate that is repellant to both substances. We report the average radius of the drops for each specie as a function of time. Also, we pay attention to the evolution of the corresponding morphologies and the appearance of hybrid clusters.