Assessment of resistance and biosorption ability of Lactobacillus paracasei to remove lead and cadmium from aqueous solution.

Since heavy metals have been regarded as ubiquitous environmental pollutants, the exploitation of bacterial biosorption has been suggested as an applicable method for being employed for heavy metal depletion. The present study aimed to characterize the function of Lactobacillus paracasei in the presence of Pb (II) and Cd (II). The simultaneous effect of pH, initial metal concentration, and inoculum size demonstrated the Pb (II) removal of 85.77% at the lowest pH, while the inoculum size was enhanced to 45 CFU/100 ml. The maximum Cd (II) removal was obtained at a high level of pH and inoculum size, while the metal concentration was reduced to 30 ppb. The addition of Cd (II) concentration in access led to the 10% drop in Cd (II) removal efficiency attributed to the metal toxicity and pH. Additionally, the slight variation in the amount of inoculum size caused the decreasing trend in the Cd (II) removal. According to the obtained results, the benefit of L. paracasei in the biosorption of heavy metals was well-recognized, which could be suggested as an alternative candidate. PRACTITIONER POINTS: Strain of Lactobacillus paracasei as potential probiotics was tested for biosorption. A successful response surface method was proposed. L. paracasei showed a good efficiency for the lead and cadmium biosorption. Biosorption process was effective in removing low metal level from drinking water. The maximum biosorption was found to be 85.77% for Pb (II) obtained from the experiment.

Bioremediation of heavy metals in food industry: application of Saccharomyces cerevisiae

Heavy metals are natural elements in the Earth's crust that can enter human food through industrial or agricultural processing, in the form of fertilizers and pesticides. These elements are not biodegradable. Some heavy metals are known as pollutants and are toxic, and their bioaccumulation in plant and animal tissues can cause undesirable effects for humans; therefore, their amount in water and food should always be under control. The aim of this study is to investigate the conditions for the bioremediation of heavy metals in foods. Various physical, chemical, and biological methods have been used to reduce the heavy metal content in the environment. During the last decades, bioremediation methods using plants and microorganisms have created interest to researchers for their advantages such as being more specific and environmentally friendly. The main pollutant elements in foods and beverages are lead, cadmium, arsenic, and mercury, which have their own permissible limits. Among the microorganisms that are capable of bioremediation of heavy metals, Saccharomyces cerevisiae is an interesting choice for its special characteristics and being safe for humans, which make it quite common and useful in the food industry. Its mass production as the byproduct of the fermentation industry and the low cost of culture media are the other advantages. The ability of this yeast to remove an individual separated element has also been widely investigated. In countries with high heavy metal pollution in wheat, the use of S. cerevisiae is a native solution for overcoming the problem of solution. This article summarizes the main conditions for heavy metal absorption by S. cerevisiae.

Lead, cadmium, arsenic and mercury in canned tuna fish marketed in Tehran, Iran.

Fifty-four canned tuna fish samples corresponding to 10 widely used different brands were purchased from local markets in Tehran, Iran during 2012-2013 and analysed on heavy metals. Mercury was determined by a direct mercury analyser without any sample preparation. For analysis of other elements samples were digested using a microwave apparatus. Lead and cadmium were determined by graphite furnace atomic absorption spectrometry and arsenic via hydride vapour generation. All samples had arsenic and mercury contamination. Arsenic levels showed a range of 0.25-1.42 mg kg(-1), which might be due to lack of national and international limits for arsenic in canned tuna fish. Lead and cadmium were measured in a small number of samples with a mean of 0.053 ± 0.058 mg kg(-1) and 0.013 ± 0.015 mg kg(-1), respectively. Results obtained for these heavy metals in all samples were lower than the corresponding limits, whereas arsenic and mercury contents might raise some attention.

Trace elements and heavy metals in mineral and bottled drinking waters on the Iranian market.

A survey of Iranian waters, sampled from 2010 to 2013, is presented. A total of 128 water samples from 42 different brands of bottled mineral and drinking water were collected and analysed for contamination levels of lead (Pb), cadmium (Cd), copper (Cu), arsenic (As) and mercury (Hg). Determinations were performed using a graphite furnace atomic absorption spectrophotometer for Pb, Cd and Cu, a hydride vapour generation as well as an Arsenator digital kit (Wagtech WTD, Tyne and Wear, UK) for As and a direct mercury analyser for Hg. Arsenic concentration in six bottled gaseous mineral samples was higher than the related limit. Regardless of these, mean concentrations of Pb, Cd, Cu, As and Hg in all types of water samples were 4.50 ± 0.49, 1.08 ± 0.09, 16.11 ± 2.77, 5.80 ± 1.63 and 0.52 ± 0.03 µg L⁻¹, respectively. Values obtained for analysed heavy metals in all samples were permissible according to the limits of national and international standards.

Evaluation of heavy metals contamination in Iranian foodstuffs: canned tomato paste and tomato sauce (ketchup).

One hundred and thirty-five samples of canned tomato paste and 30 tomato sauces (ketchup) samples (23 and 10 brands, respectively) purchased from wholesale markets in the Tehran, Iran, during the period 2010-2013 were analysed. Levels of lead and cadmium were determined by graphite furnace atomic absorption spectrophotometer (GF-AAS) and arsenic by hydride vapour generation (HG-AAS or VGA). Average concentration of arsenic found in the tomato paste and ketchup samples was 62 ± 14 and 48 ± 12 ng g(-1), respectively. Cadmium values in 7% of tomato paste and 10% of ketchup samples were below the limit of quantification (LOQ). Lead concentrations were below LOQ in 75% of tomato paste and 77% of ketchup samples. Values obtained for these heavy metals in all samples were lower than the limits of national and international standards.