ABSTRACT
BACKGROUND: Calcium and iron are crucial essential minerals. Iron is mainly responsible for transporting oxygen in the body and the immune system. In comparison, calcium's primary function is in human bones and teeth. Due to that, it is vital to quantify the amount in vegetables. OBJECTIVE: Optimization and validation of three analytical procedures, visible, atomic emission spectrophotometry (AES), and atomic absorption spectrophotometry (AAS), were developed to determine calcium and iron in vegetables and wastewater samples using response surface methodology (RSM) via Box-Behnken design (BBD). The design helps to reduce experiment trials with selected variables to find a correlation between them and their respective dependent variables. METHODS: Method I was developed to quantify calcium in vegetables mixed with concentrated 3M HNO3 and heated to reflux as per the BBD. Then it was cooled, filtered, and completed with 3M HNO3 to be carried out utilizing AES and AAS. For method II, vegetables were mixed with nitric acid and sulfuric acid solution with an optimized 5M KSCN solution, which was computed using the AAS and visible spectrophotometry. RESULTS: First, percentage of water content was calculated for all vegetables, higher in malabar spinach and lower in peas. The calcium and iron contents were present within 0.59-2.68 mg and 35.8-211.5 mg, respectively, in 100 g of vegetables. The results showed a higher amount of iron was available in spinach and a lower amount in okra. In contrast, the highest calcium amount was present in broccoli and the lowest amount was in peas. The calcium and iron content were between 0.015-137.25 and 0.01-147.85 µg/mL in the wastewater samples. CONCLUSIONS: These methods can help to determine the amount of calcium and iron for the quality control samples in research and development, food, and the environmental industry. HIGHLIGHTS: Three validated analytical techniques quantify calcium and iron in vegetables and wastewater samples. The RSM-BBD optimized the method and determined its crucial factors.
Subject(s)
Calcium , Iron , Humans , Iron/analysis , Wastewater , Vegetables , Spectrophotometry, Atomic/methodsABSTRACT
Recently discovered SARS-CoV-2 caused a pandemic that triggered researchers worldwide to focus their research on all aspects of this new peril to humanity. However, in the absence of specific therapeutic intervention, some preventive strategies and supportive treatment minimize the viral transmission as studied by some factors such as basic reproduction number, case fatality rate, and incubation period in the epidemiology of viral diseases. This review briefly discusses coronaviruses' life cycle of SARS-CoV-2 in a human host cell and preventive strategies at some selected source of infection. The antiviral activities of synthetic and natural polymers such as chitosan, hydrophobically modified chitosan, galactosylated chitosan, amine-based dendrimers, cyclodextrin, carrageenans, polyethyleneimine, nanoparticles are highlighted in this article. Mechanism of virus inhibition, detection and diagnosis are also presented. It also suggests that polymeric materials and nanoparticles can be effective as potential inhibitors and immunization against coronaviruses which would further develop new technologies in the field of polymer and nanoscience.
ABSTRACT
Solar photoelectric energy converted into electricity requires large surface areas with incident light and flexible materials to capture these light emissions. Currently, sunlight rays are converted to electrical energy using silicon polymeric material with efficiency up to 22%. The majority of the energy is lost during conversion due to an energy gap between sunlight photons and polymer energy transformation. This energy conversion also depends on the morphology of present polymeric materials. Therefore, it is very important to construct mechanisms of highest energy occupied molecular orbitals (HOMO)s and the lowest energy unoccupied molecular orbitals (LUMO)s to increase the efficiency of conversion. The organic and inorganic solar cells used as dyes can absorb more photons from sunlight and the energy gap will be less for better conversion of energy to electricity than the conventional solar cells. This paper provides an up-to-date review on the performance, characterization, and reliability of different composite polymeric materials for energy conversion. Specific attention has been given to organic solar cells because of their several advantages over others, such as their low-energy payback time, conversion efficiency and greenhouse emissions. Finally, this paper provides the recent progress on the application of both organic and inorganic solar cells for electric power generations together with several challenges that are currently faced.
ABSTRACT
A simple, sensitive method for the determination of meta-chlorobenzoic acid in bupropion hydrochloride is described. Chromatographic separation of m-chlorobenzoic acid is achieved using a mobile phase consisting of n-hexane and ethanol (1000:50, v/v) at a flow rate of 1.0 ml/min on a Chiralpak ADH (250 × 4.6 mm). Absorbance is monitored at 235 nm. The method is linear for m-chlorobenzoic acid over concentration range of LOQ, 5.0 µg/ml to 15.0 µg/ml for m-chlorobenzoic acid with correlation coefficient greater than 0.99. This method is more selective and accurate than United States Pharmacopoeia method for the determination of m-chlorobenzoic acid in bupropion hydrochloride.
