Upregulation of nuclear factor­κB and acid sensing ion channel 3 in dorsal root ganglion following application of nucleus pulposus onto the nerve root in rats.

The nucleus pulposus (NP) is an avascular, hydrated tissue that permits the intervertebral disc to resist compressive loads to the spine. To determine the mechanisms by which intervertebral disc degeneration is caused by the nucleus pulposus, the expression and regulation of nuclear factor (NF)­κB and acid sensing ion channel 3 (ASIC3) were examined. For the intervertebral disc degeneration model, NP was harvested from the tail of rats and applied to the L5 dorsal root ganglion (DRG). The mechanical pain withdrawal threshold (PWT) in NP model rats was assessed. Reverse transcription­quantitative polymerase chain reaction and western blotting were used to examine NF­κB and ASIC3 expression levels in DRG. Finally, the effect of the NF­κB inhibitor pyrrolidine dithiocarbamate (PDTC) and the ASIC3 signaling pathway blocker amiloride were examined. Rats exposed to NP exhibited decreased PWT for 12 days, and NF­κB and ASIC3 was upregulated in DRG induced by NP 14 days after surgery. After administration of amiloride and PDTC to DRG affected by NP, the levels of nitric oxide (NO), tumor necrosis factor­α (TNF­α), interleukin­6 (IL­6), NF­κB and ASIC3 were downregulated, and the levels of aquaporin (AQP) 1 and AQP3 were significantly increased for 14 days. In conclusion, these results suggested that NF­κB and ASIC3 may serve an important role in intervertebral disc degeneration caused by NP.

Effect of pretreatment on Er:YAG laser-irradiated dentin.

Erbium:yttrium-aluminum-garnet (Er:YAG) laser preparation of tooth cavities for restoration is an increasingly popular method, but its compatibility with existing composite material bonding protocols has not been fully defined. This study evaluated the effect of laser and etchant pretreatments on the performance of one-bottle self-etch adhesives in Er:YAG laser-prepared dentin. Eight groups of 20 extracted teeth were established to investigate bonding in tested dentin disks. Various combinations of laser preparation (with/without), pretreatment (none/acid-etch/low-fluence Er:YAG irradiation), and self-etching adhesive (G-Bond Plus or Xeno V) were tested. Samples were then restored with composite resin and subjected to a tensile bond strength (TBS) test. We also performed scanning electron microscopy (SEM) on dentin disks from some of these groups before and after adhesive application to evaluate their microscopic morphological appearance. Statistical analysis (Dunnett T3 test coupled with the general linear model at 5% significance level) revealed that the laser preparation of dentin did not impact on TBS (p = 0.914), whereas pretreatment with either phosphoric acid (p < 0.0001) or low-fluence Er:YAG laser irradiation (p < 0.0001) significantly increased TBS, although there was no difference between them in their respective elevation of TBS. SEM analysis demonstrated that both acid and laser pretreatments reduced irregularities and produced a more homogeneous surface. Er:YAG laser preparation does not compromise the efficacy of one-step self-etch dentin adhesives, and pretreatment with phosphoric acid or low-fluence Er:YAG laser can significantly increase the TBS of adhesion to this irradiated dentin.