Third molar agenesis in individuals with supernumerary teeth.

OBJECTIVES: To explore the association between third molar agenesis and supernumerary tooth formation in a white-European population. MATERIALS AND METHODS: A record review in various orthodontic clinics identified 380 eligible white-European individuals, half of whom had non-syndromic permanent supernumerary teeth (122 males and 68 females, totalling 244 supernumerary teeth; median age: 13.1, iqr: 1.5 years), and the other half were age- and sex-matched controls with full dentition, excluding the third molars. Tooth sequences were identified in panoramic radiographs. RESULTS: In the supernumerary group, approximately 80% of the individuals had a single supernumerary tooth, followed by those having two additional teeth. In both groups, there was no sexual dimorphism in third molar agenesis severity. The prevalence of third molar agenesis in the supernumerary group was similar to that of the control group (28/190 = 14.7% in both groups; p = 1.0). In total, 53 third molars were missing in the supernumerary group (n = 190) compared to 67 in the control group (n = 190; p = .862). The ratio of bilateral to unilateral third molar agenesis was significantly lower in the supernumerary group than in the control group (1.0 vs. 3.7, respectively; p = .026). CONCLUSION: The presence of supernumerary teeth did not significantly alter the likelihood of third molar agenesis or its severity. Bilateral third molar agenesis was considerably less prevalent in individuals with supernumerary teeth compared to controls. The present novel findings have important clinical and developmental implications.

Supernumerary Tooth Patterns in Non-Syndromic White European Subjects.

Supernumerary teeth form at an incidence of about 3% in the population, with differences among races and various clinical consequences. Information on detailed patterns, and especially on white subjects, is scarce in the literature. Therefore, we aimed to investigate the patterns of non-syndromic permanent supernumerary teeth in a white European population. A record review was performed in different orthodontic clinics and identified 207 eligible individuals with 258 supernumerary teeth. Approximately 80% of the subjects had one supernumerary tooth, while 15% had two. Supernumerary tooth formation was more often evident in males (male/female: 1.65). However, there was no sexual dimorphism in its severity. The following pattern sequences, with decreasing prevalence order, were observed in the maxilla: 21 > 11 > 12 > 18 > 28 and in the mandible: 34 > 44 > 35 > 45 > 42. Supernumerary teeth were most often unilaterally present, without sexual dimorphism. In the maxilla, they were more often anteriorly present, whereas in the mandible, an opposite tendency was observed. Supernumerary teeth were consistently more often observed in the maxilla than in the mandible; 74% were impacted, 80% had normal orientation (13% horizontal, 7% inverted), and 53% had normal size. The present thorough supernumerary tooth pattern assessment enables a better understanding of this condition with clinical, developmental, and evolutionary implications.

The effect of regular dental cast artifacts on the 3D superimposition of serial digital maxillary dental models.

Superimpositions of serial 3D dental surface models comprise a powerful tool to assess morphological changes due to growth, treatment, or pathology. In this study, we evaluated the effect of artifacts on the superimposition outcome, using standard model acquisition and superimposition techniques. Ten pre- and post-orthodontic treatment plaster models were scanned with an intraoral scanner and superimposed using the iterative closest point algorithm. We repeated the whole process after manual removal of plaster artifacts, according to the current practice, as well as after re-scanning the cleaned models, to assess the effect of the model acquisition process derived artifacts on the superimposition outcome. Non-parametric multivariate models showed no mean effect on accuracy and precision by software settings, cleaning status (artifact removal), or time point. The choice of the superimposition reference area was the only factor that affected the measurements. However, assessment of individual cases revealed significant differences on the detected tooth movement, depending on artifact removal and on the model acquisition process. The effects of all factors tended to decrease with an increase in the size of the superimposition reference area. The present findings highlight the importance of accurate, artifact-free models, for valid assessment of morphological changes through serial 3D model superimpositions.

In Vitro Effect of Er:YAG Laser on Different Single and Mixed Microorganisms Being Associated with Endodontic Infections.

Objective: The purpose of this in vitro study was to evaluate the antimicrobial effect of activated irrigation with different modes of erbium-doped yttrium aluminum garnet (Er:YAG) laser application on microorganisms related to secondary endodontic infection. Background: Er:YAG laser has been recommended as an adjuvant tool for root canal disinfection during endodontic treatment. Materials and methods: Laser-activated irrigation (LAI) with 300 or 600 µm tips were tested with or without intermittent irrigation with 0.9% sodium chloride (NaCl) solution against different microorganisms (five single strains and dual species (Streptococcus gordonii combined with Actinomyces oris or Fusobacterium nucleatum) in root canals after 3 days of incubation. In a 21-day infection model, LAI was used together with intermittent rinsing with sodium hypochlorite (NaOCl) against the dual-species mixtures; here the incidence of microbial regrowth after up to 7 days was monitored. Results: In the 3-day root infection model, LAI protocols did not show any significant reduction of the microbial load when compared with manual irrigation with saline solution. In the 21-day infection, S. gordonii combined with A. oris were not detectable anymore after applying the LAI protocol with a 600 µm tip (30 mJ/10 pps) up to 7 days after treatment. Conclusions: Application of LAI with a 600 µm tip by using an Er:YAG laser might be advantageous in treatment of endodontic infections.