From Chitosan to Chitin: Bio-Inspired Thin Films for Passive Daytime Radiative Cooling.

Passive radiative daytime cooling is an emerging technology contributing to carbon-neutral heat management. Optically engineered materials with distinct absorption and emission properties in the solar and mid-infrared range are at the heart of this technology. Owing to their low emissive power of about 100 W m-2 during daytime, substantial areas need to be covered with passive cooling materials or coatings to achieve a sizeable effect on global warming. Consequently, biocompatible materials are urgently needed to develop suitable coatings with no adverse environmental impact. It is shown how chitosan films with different thicknesses can be produced from slightly acidic aqueous solutions. The conversion to their insoluble form chitin in the solid state is demonstrated and the conversion is monitored with infrared (IR) and NMR spectroscopy. In combination with a reflective backing material, the films show below-ambient temperature cooling capabilities with a suitable emissivity in the mid-IR region and low solar absorption of 3.1-6.9%, depending on the film thickness. This work highlights the potential of chitosan and chitin as widely available biocompatible polymers for passive radiative cooling applications.

Microstructural and Thermal Transport Properties of Regioregular Poly(3-hexylthiophene-2,5-diyl) Thin Films.

Polymeric thin films offer a wide range of exciting properties and applications, with several advantages compared to inorganic counterparts. The thermal conductivity of such thin films ranges typically between 0.1-1 W m-1 K-1. This low thermal conductivity can cause problems with heat dissipation in various applications. Detailed knowledge about thermal transport in polymeric thin films is desired to overcome these shortcomings, especially in light of the multitude of possible microstructures for semi-crystalline thin films. Therefore, poly(3-hexylthiophene-2,5-diyl) (P3HT) is chosen as a model system to analyze the microstructure and optoelectronic properties using X-ray scattering and absorption spectra along with the thermal transport properties using the photoacoustic technique. This combination of analysis methods allows for determining the optoelectronic and thermal transport properties on the same specimen, supplemented by structural information. The effect of different molecular weights and solvents during film preparation is systematically examined. A variation of the optoelectronic properties, mainly regarding molecular weight, is apparent, while no direct influence of the solvent during preparation is discernible. In contrast, the thermal conductivities of all films examined fall within a similar range. Therefore, the microstructural properties in the ordered regions do not significantly affect the resulting thermal properties in the sample space investigated in this work. We conclude that it is mainly the amorphous regions that determine the thermal transport properties, as these represent a bottleneck for thermal transport.

A tailored indoor setup for reproducible passive daytime cooling characterization.

Passive daytime cooling materials can lower global energy consumption owing to their autonomous cooling capability. Although a significant number of passive cooling materials have been developed recently, their performance characterization is still challenging. Field tests experience high variability due to uncontrollable changes in environmental conditions. Here, we design an indoor setup to characterize the performance of passive cooling materials reproducibly and independently of weather and season. Outdoor measurement conditions are approximated using a liquid-nitrogen-cooled aluminum dome, a solar simulator, and a wavelength-selective inverse sky-window filter. In contrast to outdoor measurements, the results of various reference materials show remarkable precision and repeatability. Additionally, the impact of solar light intensity and temperature on the passive cooling performance can be experimentally investigated. Our setup is a first step in the development of a standardized test method to bring accuracy, reproducibility, and comparability to the emerging field of passive cooling materials.

Nanoscale-Structured Hybrid Bragg Stacks with Orientation- and Composition-Dependent Mechanical and Thermal Transport Properties: Implications for Nacre Mimetics and Heat Management Applications.

Layered nanomaterials fascinate researchers for their mechanical, barrier, optical, and transport properties. Nacre is a biological example thereof, combining excellent mechanical properties by aligned submicron inorganic platelets and nanoscale proteinic interlayers. Mimicking nacre with advanced nanosheets requires ultraconfined organic layers aimed at nacre-like high reinforcement fractions. We describe inorganic/polymer hybrid Bragg stacks with one or two fluorohectorite clay layers alternating with one or two poly(ethylene glycol) layers. As indicated by X-ray diffraction, perfect one-dimensional crystallinity allows for homogeneous single-phase materials with up to a 84% clay volume fraction. Brillouin light spectroscopy allows the exploration of ultimate mechanical moduli without disturbance by flaws, suggesting an unprecedentedly high Young's modulus of 162 GPa along the aligned clays, indicating almost ideal reinforcement under these conditions. Importantly, low heat conductivity is observed across films, κ⊥ = 0.11-0.15 W m-1 K-1, with a high anisotropy of κ∥/κ⊥ = 28-33. The macroscopic mechanical properties show ductile-to-brittle change with an increase in the clay volume fraction from 54% to 70%. Conceptually, this work reveals the ultimate elastic and thermal properties of aligned layered clay nanocomposites in flaw-tolerant conditions.

Equal transcription rates of productively and nonproductively rearranged immunoglobulin mu heavy chain alleles in a pro-B cell line.

During B cell maturation, immunoglobulin (Ig) genes frequently acquire premature translation-termination codons (PTCs) as a result of the somatic rearrangement of V, D, and J gene segments. However, it is essential for a B lymphocyte to produce only one kind of antibody and therefore to ensure that the heavy and light chain polypeptides are expressed exclusively from the corresponding functional alleles, whereas no protein is made from the nonproductively rearranged alleles. At the post-transcriptional level, a well-studied mRNA quality control mechanism, termed nonsense-mediated mRNA decay (NMD), recognizes and degrades PTC-containing mRNAs in a translation-dependent manner. In addition, transcriptional silencing of PTC-containing Ig-mu and Ig-gamma heavy chain reporter genes was observed in HeLa cells. To investigate the silencing of nonproductively rearranged Ig genes in a more physiological context, we analyzed a monoclonal line of immortalized murine pro-B cells harboring one productively (PTC-) and one nonproductively (PTC+) rearranged Ig-mu heavy chain allele. We show that the steady-state abundance of PTC+ mRNA was approximately 40-fold lower when compared to that of the PTC- mRNA. However, both the PTC+ and PTC- allele seemed to be equally well transcribed since the abundances of PTC+ and PTC- pre-mRNA were very similar and chromatin immunoprecipitations revealed comparable occupancy of RNA polymerase II and acetylated histone H3 on both alleles. Altogether, we found no evidence for transcriptional silencing of the PTC+ allele in this pro-B cell line; hence, the efficient down-regulation of the PTC+ Ig-mu mRNA results entirely from NMD.

A unique role for the lambda5 nonimmunoglobulin tail in early B lymphocyte development.

Precursor BCR (pre-BCR) signaling governs proliferation and differentiation of pre-B cells during B lymphocyte development. However, it is controversial as to which parts of the pre-BCR, which is composed of Igmu H chain, surrogate L chain (SLC), and Igalpha-Igbeta, are important for signal initiation. Here, we show in transgenic mice that the N-terminal non-Ig-like (unique) tail of the surrogate L chain component lambda5 is critical for enhancing pre-BCR-induced proliferation signals. Pre-BCRs with a mutated lambda5 unique tail are still transported to the cell surface, but they deliver only basal signals that trigger survival and differentiation of pre-B cells. Further, we demonstrate that the positively charged residues of the lambda5 unique tail, which are required for pre-BCR self-oligomerization, can also mediate binding to stroma cell-associated self-Ags, such as heparan sulfate. These findings establish the lambda5 unique tail as a pre-BCR-specific autoreactive signaling motif that could increase the size of the primary Ab repertoire by selectively expanding pre-B cells with functional Igmu H chains.

Transcriptome analysis in primary B lymphoid precursors following induction of the pre-B cell receptor.

Pre-BCR signals are part of a checkpoint where early precursor (pre-) B cells with a pairing Ig muH chain (muHC) are clonally expanded before they differentiate into IgL-rearranging, resting pre-B cells. A pre-BCR consists of two muHCs, two surrogate L chains and the signal transducer Igalpha/Igbeta. The molecular circuits by which the pre-BCR controls proliferation and differentiation of pre-B cells are poorly characterized. Therefore, we identified the differential transcriptome by genome-wide expression profiling in progenitor (pro-) B cells from a Rag2-deficient mouse, in which the expression of a transgenic muHC and thus a pre-BCR as well as pre-BCR-mediated clonal expansion can be controlled by tetracycline (muHC-inducible mouse). This analysis revealed that pre-BCR signals upregulate components of the BCR signalosome, open the IgL chain (LC) locus and induce the krüppel-like transcription factor KLF2, a key regulator of quiescence and lymphocyte migration. Hence, pre-BCR signals establish the molecular network for BCR signaling even before the production of an IgLC and induce the expression of KLF2, a candidate for controlling clonal expansion and migration of functional pre-B cells.

Ig heavy chain promotes mature B cell survival in the absence of light chain.

Survival of mature B cells is thought to depend on the BCR signaling (BCR) because ablation of either H chain (HC) expression or BCR signaling causes B cells to rapidly disappear. Whether a complete BCR is required for survival of mature B cells is not known. To address this question, we generated a mouse in which we can repress the expression of a transgenic Ig L chain (IgL) by doxycycline (IgL-repressible mouse). Repression of IgL abrogated expression. Surprisingly, however, IgL-negative B cells survived longer than 14 wk, expressed signal-competent HC on the cell's surface, and active unfolded protein response factors. Like postgerminal center B cells, IgL-negative B cells were small lymphocytes, not dividing and expressed Bcl-6. Our results indicate that expression of unpaired HC, as it may occur as a consequence of Ag ligation, somatic hypermutation, or receptor editing, facilitates the survival of cells either by inducing receptor signaling or by inducing unfolded protein response and/or the expression of survival genes such as Bcl-6.

Extensive immunoglobulin production sensitizes myeloma cells for proteasome inhibition.

Multiple myeloma is an incurable plasma cell neoplasia characterized by the production of large amounts of monoclonal immunoglobulins. The proteasome inhibitor bortezomib (PS-341, Velcade) induces apoptosis in various malignant cells and has been approved for treatment of refractory multiple myeloma. Inhibition of the antiapoptotic transcription factor nuclear factor-kappaB (NF-kappaB) apparently contributes to the antitumor effects of bortezomib; however, this mechanism cannot fully explain the exceptional sensitivity of myeloma cells. Extensive protein synthesis as in myeloma cells is inherently accompanied by unfolded proteins, including defective ribosomal products (DRiPs), which need to be degraded by the ubiquitin-proteasome system. Therefore, we hypothesized that the proapoptotic effect of bortezomib in multiple myeloma is mainly due to the accumulation of unfolded proteins in cells with high protein biosynthesis. Using the IgG-secreting human myeloma cell line JK-6L and murine muH-chain-transfected Ag8.H myeloma cells, apoptosis induction upon proteasome inhibition was clearly correlated with the amount of immunoglobulin production. Preferentially in immunoglobulin-high myeloma cells, bortezomib triggered activation of caspases and induction of proapoptotic CHOP, a component of the terminal unfolded protein response induced by endoplasmic reticulum (ER) stress. In immunoglobulin-high cells, bortezomib increased the levels of proapoptotic Bax while reducing antiapoptotic Bcl-2. Finally, IgG-DRiPs were detected in proteasome inhibitor-treated cells. Hence, proteasome inhibitors induce apoptosis preferentially in cells with high synthesis rate of immunoglobulin associated with accumulation of unfolded proteins/DRiPs inducing ER stress. These findings further elucidate the antitumor activities of proteasome inhibitors and have important implications for optimizing clinical applications.

Powered by pairing: the surrogate light chain amplifies immunoglobulin heavy chain signaling and pre-selects the antibody repertoire.

Selective expansion of functional pre-B cells is accomplished by the assembly of a signaling-competent pre-B cell receptor (pre-BCR) consisting of immunoglobulin mu heavy chains (muHC), surrogate light chains (SLC) and Igalpha/Igbeta. Here, we review recent data showing that muHCs, in the absence of SLC, deliver autonomous differentiation signals. However, enhanced signaling necessary for pre-B cell expansion requires cross-linking of pre-BCRs via the non-immunoglobulin tail of SLC's subunit lambda5. We also discuss how SLC's ability to modulate the strength of pre-BCR signals is controlled by a muHC's idiotype and its affinity to the chaperone BiP. In this model, BiP in concert with SLC functions as a pre-selector of the antibody repertoire.