What cell wall components are the best indicators for Miscanthus digestibility and conversion to ethanol following variable pretreatments?

BACKGROUND: Energy crops including Miscanthus provide a storable, portable energy source which can be used to complement a wide range of products and energy generation systems. Miscanthus is predominantly used in Europe as a combustion material for electricity generation but also has the potential for biochemical conversion due to its high yield and low-nutrient requirements. The ratio of holocellulose (hemicellulose and cellulose combined) to acid detergent lignin (H:L) within the senesced material has previously been shown to indicate the relative suitability of Miscanthus accessions for thermochemical conversion. In this study, the ratio was assessed to examine its use as a selection aid for biochemical conversion. 20 highly-characterised Miscanthus accessions were saccharified using an enzyme mix to determine optimum sugar release. Nine of these accessions spanning high, medium and low H:L ratios were then autoclaved with dilute acid, alkali or water, and enzymically hydrolysed and fermented to produce ethanol. Samples taken throughout the process allowed assessments of released sugars. RESULTS: Enzymic degradation of the biomass showed a relationship between H:L ratio and glucose release, with high glucose release for high H:L ratio accessions and vice versa. Xylose release showed no such relationship. This relationship was maintained following pretreatments and enzyme saccharification, where compound analysis showed that following all pretreatments, accessions with high H:L ratios repeatedly had the highest releases of glucose, xylose and arabinose, and produced more ethanol. Release of all measured compounds increased with the pretreatment severity and ethanol yields from each pretreatment correlated with the respective glucose yield, providing assurance that any inhibitory compounds generated were tolerated by the fermentation yeast. Strong correlations were also seen between glucose release, ethanol and cell wall components, with cellulose showing the highest correlations with ethanol yields for some treatments and H:L ratio with others. CONCLUSIONS: The H:L ratio is a good predictor of ethanol yields and sugar release from Miscanthus in this study but individual components lignin and cellulose also correlate well, especially for hot water and mild acid pretreatments. In conclusion, use of the H:L ratio does not provide any advantages over the concentration of individual cell wall components for predicting sugar release and ethanol yields.

Variation in Miscanthus chemical composition and implications for conversion by pyrolysis and thermo-chemical bio-refining for fuels and chemicals.

Different species and genotypes of Miscanthus were analysed to determine the influence of genotypic variation and harvest time on cell wall composition and the products which may be refined via pyrolysis. Wet chemical, thermo-gravimetric (TGA) and pyrolysis-gas chromatography-mass spectrometry (Py-GC-MS) methods were used to identify the main pyrolysis products and determine the extent to which genotypic differences in cell wall composition influence the range and yield of pyrolysis products. Significant genotypic variation in composition was identified between species and genotypes, and a clear relationship was observed between the biomass composition, yields of pyrolysis products, and the composition of the volatile fraction. Results indicated that genotypes other than the commercially cultivated Miscanthus x giganteus may have greater potential for use in bio-refining of fuels and chemicals and several genotypes were identified as excellent candidates for the generation of genetic mapping families and the breeding of new genotypes with improved conversion quality characteristics.

Seasonal variation in the chemical composition of the bioenergy feedstock Laminaria digitata for thermochemical conversion.

To avoid negative impacts on food production, novel non-food biofuel feedstocks need to be identified and utilised. One option is to utilise marine biomass, notably fast-growing, large marine 'plants' such as the macroalgal kelps. This paper reports on the changing composition of Laminaria digitata throughout it growth cycle as determined by new technologies. The potential of Laminaria sp. as a feedstock for biofuel production and future biorefining possibilities was assessed through proximate and ultimate analysis, initial pyrolysis rates using thermo-gravimetric analysis (TGA), metals content and pyrolysis gas chromatography-mass spectrometry. Samples harvested in March contained the lowest proportion of carbohydrate and the highest ash and alkali metal content, whereas samples harvested in July contained the highest proportions of carbohydrate, lowest alkali metals and ash content. July was therefore considered the most suitable month for harvesting kelp biomass for thermochemical conversion to biofuels.

Miscanthus as a feedstock for fast-pyrolysis: does agronomic treatment affect quality?

The objectives of the experiment were to assess the impact of nitrogen (N) and potassium (K) fertiliser application on the cell wall composition and fast-pyrolysis conversion quality of the commercially cultivated hybrid Miscanthus x giganteus. Five different fertiliser treatments were applied to mature Miscanthus plants which were sampled at five intervals over a growing season. The different fertiliser treatments produced significant variation in concentrations of cell wall components and ash within the biomass and affected the composition and quality of the resulting fast-pyrolysis liquids. The results indicated that application of high rates of N fertiliser had a negative effect on feedstock quality for this conversion pathway: reducing the proportion of cell wall components and increasing accumulation of ash in the harvested biomass. No exclusive effect of potassium fertiliser was observed. The low-N fertiliser treatment produced high quality, low ash-high lignin biomass most suitable as a feedstock for thermo-chemical conversion.

Differential cortical acetylcholine release in rats performing a sustained attention task versus behavioral control tasks that do not explicitly tax attention.

The present study used microdialysis techniques to compare acetylcholine release in the frontoparietal cortex of rats performing in a task requiring sustained attention with that of rats performing in two control procedures. The two control procedures were a fixed-interval 9-s schedule of reinforcement assessing primarily the effects of operant responding and comparable reward rates, and an operant procedure designed to test the effects of lever extension to prompt responding. These two control procedures involved comparable sensory-motor and motivational variables to those of the sustained attention task, but did not explicitly tax attentional processes. Performance of the sustained attention task was associated with a significant increase in cortical acetylcholine efflux, reaching a maximum of nearly 140%. Performance of the two control procedures was associated with significantly smaller (approximately 50%) increases in cortical acetylcholine release. This robust dissociation between attentional and control performance-associated increases in cortical acetylcholine release resulted, in part, from the elimination of the pre-task transfer of the animals into the operant chambers and the associated increases in acetylcholine release observed in previous studies. The present results support the hypothesis that demands on attentional performance, as opposed to the frequency of lever pressing, reward delivery and other task-related variables, selectively activate the basal forebrain corticopetal cholinergic system.

A source isolator for infected patients.

A plastic, mechanically ventilated source isolator with filters in the air effluent was designed to enable infected patients to be nursed and treated in a general ward or to be transported without risk to staff or other contacts. Two models of isolator were developed. Their potential value was tested by the challenge of heavy dispersal, inside the isolator, of bacteria (a) from patients with burns, during the change of dressings, (b) from contaminated bedding during simulated bed-making, and (c) from the dispersal of a suspension of Bacillus subtilis var. globigii. Sampling of air by slit samplers outside the isolator and, in comparable control patients, from the air of the room in which dressings were changed, showed consistently lower counts of bacteria and of Staph. aureus during dressings when the isolator was used; on removal of the isolator canopy there was, in some experiments, a considerable increase in airborne bacteria, due to residual bacteria in the isolator of to the re-dispersal of bacteria which settled on the patient and his bedding during the dressing. Simultaneous sampling with slit samplers inside and outside the isolator during and after bed-making or dispersal of B. subtilis var. globigii showed an almost complete protection of the air outside the isolator against contamination by bacteria released inside the isolator.