ABSTRACT
The article presents the results of tests of the tribological properties of a bearing alloy on a tin matrix (B89) after surface modification by means of friction stir processing (FSP) with a Whorl tool. The samples were processed using two tool speeds of 280 and 580 RPM and a constant linear speed of 355 mm/min. The obtained results proved the significant influence of FSP on both the morphology of the precipitates and the investigated properties. Changes in the nature and course of friction were also observed, including the participation of individual wear mechanisms in the studied test conditions. The use of the 560 RPM tool rotation speed reduces the friction coefficient and the weight loss by about 30%. The flexural strength was also increased from 123 to 307 MPa.
ABSTRACT
In the study, the friction stir processing (FSP) method was used to modify the surface layer of a tin-based bearing alloy. The modification was aimed at extending the service life of bearings by improving their tribological properties. The results of investigations of the microstructure, hardness and tribological properties of the SnSbCu bearing alloy after FSP using various rotational speeds of the tool-280, 355, 450 and 560 RPM-and the constant traverse speed of 355 mm/min are presented. Particular attention was paid to the possibility of changing the morphology of the precipitates present in the alloy, and to the impact of this parameter on improvement of the tribological properties. The research carried out in this paper covered investigations of the microstructure using light and scanning electron microscopy (SEM) along with analysis of the chemical composition in micro-areas and Brinell hardness tests. Additionally, the sizes of the SnSb and CuSn precipitates present in the microstructure before and after the modification process were determined, as were the tribological properties under technically dry friction conditions and lubrication with TU 32 oil. It was proven that using friction stir processing favors refinement of the microstructure and improves the tribological properties of the analyzed alloy.
