Selection of an Optimal Abrasion Wheel Type for Nano-Coating Wear Studies under Wet or Dry Abrasion Conditions.

Nanocoatings have numerous potential applications in the indoor environment, such as flooring finishes with increased scratch- and wear-resistance. However, given concerns about the potential environmental and human health effects of nanomaterials, it is necessary to develop standardized methods to quantify nanomaterial release during use of these products. One key choice for mechanical wear studies is the abrasion wheel. Potential limitations of different wheels include the release of fragments from the wheel during abrasion, wearing of the wheel from the abrasion process, or not releasing a sufficient number of particles for accurate quantitative analysis. In this study, we evaluated five different wheels, including a typically used silicon oxide-based commercial wheel and four wheels fabricated at the National Institute of Standards and Technology (NIST), for their application in nanocoating abrasion studies. A rapid, nondestructive laser scanning confocal microscopy method was developed and used to identify released particles on the abraded surfaces. NIST fabricated a high performing wheel: a noncorrosive, stainless-steel abrasion wheel containing a deep cross-patch. This wheel worked well under both wet and dry conditions, did not corrode in aqueous media, did not release particles from itself, and yielded higher numbers of released particles. These results can be used to help develop a standardized protocol for surface release of particles from nanoenabled products using a commercial rotary Taber abraser.

Micro and macroscopic mechanical behaviors of high-density polyethylene under UV irradiation and temperature.

The macroscopic mechanical behavior of high-density polyethylene (HDPE) during photodegradation is characterized by decreases of tensile elongation-at-failure. An apparent linear relation between the elongation-at-failure and the molar mass indicates that the decrease of the elongation of HDPE over time is highly dependent on the decrease of the average molar mass. Possible preferential scission of the high molar mass chains was observed for HDPE exposed to ultraviolet (UV) irradiance higher than 40% (61 W/m2) of the full intensity at 50 °C. Tensile modulus of HDPE exposed at 50 °C increased with the exposure time until reaching the complete loss of ductility except the 5% UV. For 40% UV/30 °C as well as for 5% UV/50 °C, the young modulus trend cannot be evaluated with performed (small) duration. Nanomechanical test results suggest that the increased tensile modulus is due to stiffening of the entire cross-section. Furthermore, HDPE showing the complete loss of ductility exhibited significantly higher modulus in the surface regions than the core regions particularly for the UV intensity higher than 40% (61 W/m2), which increased crack sensitivity to cause embrittlement of the entire specimens.