ABSTRACT
In this work, the freezing characteristics of double-droplet impact on three typical wettability surfaces were investigated by coupling the solidification and melting VOF models. Different temperature conditions were adopted to study the influence of icing speed on droplet behavior. Simulation results show that the motion of the double-droplet impact is consistent with that of a single droplet in the early spreading stage but behaves differently in the retraction stage. The wetting area evolution during the impact-freezing process shows different tendency for hydrophilic and hydrophobic surfaces: Compared with single droplets, double droplets have a smaller wetting area factor on hydrophilic surfaces but a larger one on superhydrophobic surfaces. In addition, three typical impact results are observed for the double-droplet impact on a superhydrophobic cold surface: full rebound, adhesive avulsion, and full adhesion, which reflects the interaction of droplet merging and solidification during the impact freezing of the double droplet. These findings may deepen our understanding of the mechanism of impact freezing on a cold surface, it provides reference for the associated applications and technologies in icing/anti-icing.
ABSTRACT
Based on the sludge mass transfer flux model, this paper conducts a simulation study on the drying characteristics of sludge under low-temperature environment and compares it with the previous experimental results. It is found that when the sludge moisture content is low, the change of its drying curve is basically consistent with the experimental results, but there is a large error when the sludge moisture content is 0.4-0.6. In order to better simulate sludge drying characteristics, a model of cracking and shrinkage coefficients based on sludge moisture content is proposed, and the effective diffusion coefficient and mass transfer coefficient are modified. The maximum error between simulation and experiment is reduced to 23.78%. Based on this model, the sludge drying mechanism was studied. It was found that heat transfer and diffusion played a major role in the initial stage of sludge drying, and diffusion played a major role in sludge drying 30 min later.
ABSTRACT
To improve thermal insulation, microencapsulated phase change materials (micro-PCMs), expandable graphite (EG), and ammonium polyphosphate (APP) were introduced into polyurethane foam (PUF) to enhance the thermal stability and improve the thermal insulation behavior. The morphology of the PUF and micro-PCM was studied using a scanning electronic microscope (SEM), while the thermophysical properties of the PUF were investigated using a hot disk thermal constants analyzer and differential scanning calorimetry (DSC). The thermal stability of the PUF was investigated by thermogravimetric analysis (TGA), and the gas products volatilized from the PUF were analyzed by thermogravimetric analysis coupled with Fourier transform infrared spectrometry (TGA-FTIR). The results revealed that the thermal conductivities of the PUF were reduced because micro-PCM is effective in absorbing energy, showing that the PUF functions not only as a thermal insulation material but also as a heat sink for energy absorption. Moreover, the EG and APP were found to be effective in improving the thermal stabilities of the PUF, and the optimized formulation among EG, APP, and micro-PCMs in the PUF showed a significant synergistic effect.
ABSTRACT
The single component pseudopotential lattice Boltzmann model has been widely applied in multiphase simulation due to its simplicity and stability. In many studies, it has been claimed that this model can be stable for density ratios larger than 1000. However, the application of the model is still limited to small density ratios when the contact angle is considered. The reason is that the original contact angle adjustment method influences the stability of the model. Moreover, simulation results in the present work show that, by applying the original contact angle adjustment method, the density distribution near the wall is artificially changed, and the contact angle is dependent on the surface tension. Hence, it is very inconvenient to apply this method with a fixed contact angle, and the accuracy of the model cannot be guaranteed. To solve these problems, a contact angle adjustment method based on the geometry analysis is proposed and numerically compared with the original method. Simulation results show that, with our contact angle adjustment method, the stability of the model is highly improved when the density ratio is relatively large, and it is independent of the surface tension.
